High Quality Microcrystalline Silicon-Carbide Films Prepared by Photo-CVD Method Using Ethylene Gas as a Carbon Source

1999 ◽  
Vol 557 ◽  
Author(s):  
Seung Yeop Myong ◽  
Hyung Kew Lee ◽  
Euisik Yoon ◽  
Koeng Su Lim
Keyword(s):  
Silicon Carbide ◽  
Vapor Deposition ◽  
Crystalline Silicon ◽  
Chemical Vapor ◽  
Dark Conductivity ◽  
Microcrystalline Silicon ◽  
Cvd Method ◽  
Hydrogen Dilution ◽  
Boron Doped

AbstractHydrogenated boron-doped microcrystalline silicon-carbide (p-μc-SiC:H) films were grown by a photo chemical vapor deposition (photo-CVD) method from silane (SiH4), hydrogen (H2), diborane (B2H6), and ethylene (C2H4) gases. Since the photo-CVD is a mild process (~10mW/cm2), we can avoid the ion damage of the film, which is inevitable during the deposition of μc-SiC:H employing conventional PECVD technique. A dark conductivity as high as 5 × 10-1 S/cm, together with an optical bandgap of 2 eV, was obtained by the C2H4 addition, which is the first approach in photo-CVD systems. From the Raman and FTIR spectra, it is clear that our p-μc-SiC:H films are made up of crystalline silicon grains embedded in amorphous silicon-carbide tissue. We investigate the role of the hydrogen dilution and ethylene addition on the electrical, optical, and structural properties of p-μc-SiC:H films.

Role of oxygen and nitrogen in n-type microcrystalline silicon carbide grown by hot wire chemical vapor deposition

2016 ◽  
Vol 120 (22) ◽  
pp. 225105 ◽  
Author(s):  
Manuel Pomaska ◽  
Jan Mock ◽  
Florian Köhler ◽  
Uwe Zastrow ◽  
Martina Perani ◽  
...  
Keyword(s):  
Silicon Carbide ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Hot Wire ◽  
Microcrystalline Silicon

Physical Properties of Undoped and Doped Microcrystalline SiC:H Deposited by PECVD

1991 ◽  
Vol 219 ◽  
Author(s):  
F. Demichelis ◽  
C. F. Pirri ◽  
E. Tresso ◽  
G. Dellamea ◽  
V. Rigato ◽  
...  
Keyword(s):  
Silicon Carbide ◽  
Optical Properties ◽  
Electrical Properties ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Dark Conductivity ◽  
Systematic Investigation ◽  
Optical And Electrical Properties ◽  
Microcrystalline Silicon ◽  
Window Material

ABSTRACTExperimental results on a systematic investigation on the elemental composition, structural, optical and electrical properties of undoped and doped microcrystalline silicon carbide films deposited by Plasma Enhanced Chemical Vapor Deposition.The doped samples show high values of dark conductivity accompanied by good optical properties so to satisfy the requirements for heterojunction window material.

Intrinsic and Doped m c-Si:H TFT Layers using 13.56 MHz PECVD at 250°C

2004 ◽  
Vol 808 ◽  
Author(s):  
Czang-Ho Lee ◽  
Denis Striakhilev ◽  
Arokia Nathan
Keyword(s):  
Performance Improvement ◽  
Volume Fraction ◽  
Chemical Vapor ◽  
Dark Conductivity ◽  
Rf Power ◽  
Crystalline Volume Fraction ◽  
Microcrystalline Silicon ◽  
Bias Stress ◽  
Hydrogen Dilution ◽  
Low Threshold

ABSTRACTUndoped and n+ hydrogenated microcrystalline silicon (μc-Si:H) films for thin film transistors (TFTs) were deposited at a temperature of 250°C with 99 ∼ 99.6 % hydrogen dilution of silane by standard 13.56 MHz plasma enhanced chemical vapor deposition (PECVD). High crystallinity m c-Si:H films were achieved at 99.6 % hydrogen dilution and at low rf power. An undoped 80 nm thick m c-Si:H film showed a dark conductivity of the order of 10−7 S/cm, the photosensitivity of an order of 102, and a crystalline volume fraction of 80 %. However, a 60 nm thick n+ μc-Si:H film deposited using a seed layer showed a high dark conductivity of 35 S/cm and a crystalline volume fraction of 60 %. Using n+ μc-Si:H films as drain and source contact layers in a-Si:H TFTs provides substantial performance improvement over n+ a-Si:H contacts. Finally, fully μ c-Si:H TFTs incorporating intrinsic m c-Si:H films as channel layers and n+ μc-Si:H films as contact layers have been fabricated and characterized. These TFTs exhibit a low threshold voltage and a field effect mobility of 0.85 cm2/Vs, and are far more stable under gate bias stress than a-Si:H TFTs.

DEVELOPMENT OF HIGHLY CONDUCTIVE BORON-DOPED MICROCRYSTALLINE SILICON FILMS FOR APPLICATION IN SOLAR CELLS

2006 ◽  
Vol 20 (03) ◽  
pp. 303-314 ◽  
Author(s):  
QING-SONG LEI ◽  
ZHI-MENG WU ◽  
JIAN-PING XI ◽  
XIN-HUA GENG ◽  
YING ZHAO ◽  
...  
Keyword(s):  
Solar Cells ◽  
Substrate Temperature ◽  
Chemical Vapor ◽  
Dark Conductivity ◽  
Silicon Films ◽  
Microcrystalline Silicon ◽  
Very High Frequency ◽  
Boron Doped ◽  
Deposition Processes ◽  
P Type

We have examined the deposition of highly conductive boron-doped microcrystalline silicon (μc- Si:H ) films for application in solar cells. Depositions were conducted in a very high frequency plasma enhanced chemical vapor deposition (VHF PECVD) chamber. In the deposition processes, various substrate temperatures (TS) were applied. Highly conductive p-type microcrystalline silicon films were obtained at substrate temperature lower than 210°C. The factors that affect the conductivity of the films were investigated. Results suggest that the dark conductivity, which was determined by the Hall mobility and carrier concentration, is influenced by the structure. The properties of the films are strongly dependent on the substrate temperature. With TS increasing, the dark conductivity (σd) increases initially; reach the maximum values at certain TS and then decrease. Also, we applied the boron-doped μc- Si:H as p-layers to the solar cells. An efficiency of about 8.5% for a solar cell with μc- Si:H p-layer was obtained.

Sign in / Sign up

Export Citation Format

Share Document