The Nucleation and Growth of Germanium on (1102) Sapphire Deposited by Molecular Beam Epitaxy

1989 ◽  
Vol 160 ◽  
Author(s):  
David J. Godbey ◽  
Mark E. Twigg
Keyword(s):  
Molecular Beam Epitaxy ◽  
Single Crystal ◽  
Line Width ◽  
Molecular Beam ◽  
Nucleation And Growth ◽  
X Ray ◽  
Germanium Film ◽  
Germanium Films ◽  
First Time

Single crystal undoped germanium has been grown successfully for the first time on (1102) sapphire [1,2]. Germanium was found to grow (110) with an in plane registry of Ge(111)/Al203(1012) [1]. When a 2μm germanium film was grown on (1102) sapphire at 800°C and after a substrate preanneal of 1400°C, the X-ray line width of the Ge(220) reflection was measured to be 230 arcseconds [2]. Strain was observed only in germanium films that were thinner than 40 nm [2].

Optical and structural prorerties of InAs epilayer on graded InGaAs

2001 ◽  
Vol 696 ◽  
Author(s):  
Gu Hyun Kim ◽  
Jung Bum Choi ◽  
Joo In Lee ◽  
Se-Kyung Kang ◽  
Seung Il Ban ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Residual Strain ◽  
Molecular Beam ◽  
Lattice Mismatch ◽  
Peak Position ◽  
Excitation Intensity ◽  
Total Thickness ◽  
Ingaas Layer ◽  
X Ray Diffraction ◽  
X Ray

AbstractWe have studied infrared photoluminescence (PL) and x-ray diffraction (XRD) of 400 nm and 1500 nm thick InAs epilayers on GaAs, and 4 nm thick InAs on graded InGaAs layer with total thickness of 300 nm grown by molecular beam epitaxy. The PL peak positions of 400 nm, 1500 nm and 4 nm InAs epilayer measured at 10 K are blue-shifted from that of InAs bulk by 6.5, 4.5, and 6 meV, respectively, which can be largely explained by the residual strain in the epilayer. The residual strain caused by the lattice mismatch between InAs and GaAs or graded InGaAs/GaAs was observed from XRD measurements. While the PL peak position of 400 nm thick InAs layer is linearly shifted toward higher energy with increase in excitation intensity ranging from 10 to 140 mW, those of 4 nm InAs epilayer on InGaAs and 1500 nm InAs layer on GaAs is gradually blue-shifted and then, saturated above a power of 75 mW. These results suggest that adopting a graded InGaAs layer between InAs and GaAs can efficiently reduce the strain due to lattice mismatch in the structure of InAs/GaAs.

X-Ray Diffraction Study of Rare Earth Epitaxial Structures Grown by MBE onto (111) GaAs

1989 ◽  
Vol 151 ◽  
Author(s):  
W. R. Bennett ◽  
R. F. C. Farrow ◽  
S. S. P. Parkin ◽  
E. E. Marinero
Keyword(s):  
Rare Earth ◽  
Molecular Beam Epitaxy ◽  
Rare Earth Metal ◽  
Molecular Beam ◽  
Earth Metal ◽  
Magnetic Ordering ◽  
Metal Films ◽  
X Ray Diffraction ◽  
X Ray ◽  
Strain Components

ABSTRACTWe report on the new epitaxial system LaF3/Er/Dy/Er/LaF3/GaAs (111) grown by molecular beam epitaxy. X-ray diffraction studies have been used to determine the epitaxial relationships between the rare earths, the LaF3 and the substrate. Further studies of symmetric and asymmetric reflections yielded the in-plane and perpendicular strain components of the rare earth layers. Such systems may be used to probe the effects of magnetoelastic interactions and dimensionality on magnetic ordering in rare earth metal films and multilayers.

Formation and Structure of Thin Mo Layers and Mo-Ni Multilayers on Ni(001) by Molecular Beam Epitaxy

1989 ◽  
Vol 160 ◽  
Author(s):  
Y.H. Lee ◽  
R.P. Burns ◽  
J.B. Posthill ◽  
K.J. Bachmann
Keyword(s):  
Thin Films ◽  
High Temperature ◽  
High Resolution ◽  
Molecular Beam Epitaxy ◽  
Low Temperature ◽  
Molecular Beam ◽  
Nucleation And Growth ◽  
Multilayer Heterostructures ◽  
Annealing Experiments ◽  
Small Period

AbstractThe growth of Mo overtayers and Mo-Ni multilayers on single crystal Ni(001) substrates is described. The nucleation and growth processes of these thin films were analyzed by LEED, XPS, AES and SEM and High Resolution AES investigations without breaking vacuum. Growth of Mo-Ni multilayer heterostructures on Ni(001) with ≈20Å periodicity is possible at low temperature (≈200 °C). At high temperature (≈550 °C) the growth proceeds by the Volmer-Weber mechanism preventing the deposition of small period multilayers. Annealing experiments on ultra-thin (<20Å) Mo overiayers deposited at 200 °C show an onset of interdiffusion at ≈ 550°C coupled to the generation of a new surface periodicity.

A Study on the Growth of Cubic GaN Films Using an AlGaAs Buffer Layer Grown on GaAs (100) by Plasma-Assisted Molecular Beam Epitaxy

2000 ◽  
Vol 639 ◽  
Author(s):  
Ryuhei Kimura ◽  
Kiyoshi Takahashi ◽  
H. T. Grahn
Keyword(s):  
Molecular Beam Epitaxy ◽  
Buffer Layer ◽  
Molecular Beam ◽  
High Energy ◽  
Rf Plasma ◽  
Cubic Phase ◽  
X Ray Diffraction ◽  
X Ray ◽  
Cubic Gan

ABSTRACTAn investigation of the growth mechanism for RF-plasma assisted molecular beam epitaxy of cubic GaN films using a nitrided AlGaAs buffer layer was carried out by in-situ reflection high energy electron diffraction (RHEED) and high resolution X-ray diffraction (HRXRD). It was found that hexagonal GaN nuclei grow on (1, 1, 1) facets during nitridation of the AlGaAs buffer layer, but a highly pure, cubic-phase GaN epilayer was grown on the nitrided AlGaAs buffer layer.

Properties of Epitaxial SrTiO3 Thin Films Grown on Silicon by Molecular Beam Epitaxy

1999 ◽  
Vol 567 ◽  
Author(s):  
Z. Yu ◽  
R. Droopad ◽  
J. Ramdani ◽  
J.A. Curless ◽  
C.D. Overgaard ◽  
...  
Keyword(s):  
Thin Films ◽  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
High Energy ◽  
State Density ◽  
Unit Cell ◽  
Ex Situ ◽  
Silicon Oxide Layer ◽  
Single Crystalline ◽  
X Ray

ABSTRACTSingle crystalline perovskite oxides such as SrTiO3 (STO) are highly desirable for future generation ULSI applications. Over the past three decades, development of crystalline oxides on silicon has been a great technological challenge as an amorphous silicon oxide layer forms readily on the Si surface when exposed to oxygen preventing the intended oxide heteroepitaxy on Si substrate. Recently, we have successfully grown epitaxial STO thin films on Si(001) surface by using molecular beam epitaxy (MBE) method. Properties of the STO films on Si have been characterized using a variety of techniques including in-situ reflection high energy electron diffraction (RHEED), ex-situ X-ray diffraction (XRD), spectroscopic ellipsometry (SE), Auger electron spectroscopy (AES) and atomic force microscopy (AFM). The STO films grown on Si(001) substrate show bright and streaky RHEED patterns indicating coherent two-dimensional epitaxial oxide film growth with its unit cell rotated 450 with respect to the underlying Si unit cell. RHEED and XRD data confirm the single crystalline nature and (001) orientation of the STO films. An X-ray pole figure indicates the in-plane orientation relationship as STO[100]//Si[110] and STO(001)// Si(001). The STO surface is atomically smooth with AFM rms roughness of 1.2 AÅ. The leakage current density is measured to be in the low 10−9 A/cm2 range at 1 V, after a brief post-growth anneal in O2. An interface state density Dit = 4.6 × 1011 eV−1 cm−2 is inferred from the high-frequency and quasi-static C-V characteristics. The effective oxide thickness for a 200 Å STO film is around 30 Å and is not sensitive to post-growth anneal in O2 at 500-700°C. These STO films are also robust against forming gas anneal. Finally, STO MOSFET structures have been fabricated and tested. An extrinsic carrier mobility value of 66 cm2 V−11 s−1 is obtained for an STO PMOS device with a 2 μm effective gate length.

Strain relaxation in single crystal SrTiO3 grown on Si (001) by molecular beam epitaxy

2012 ◽  
Vol 111 (6) ◽  
pp. 064112 ◽  
Author(s):  
Miri Choi ◽  
Agham Posadas ◽  
Rytis Dargis ◽  
Chih-Kang Shih ◽  
Alexander A. Demkov ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Single Crystal ◽  
Molecular Beam ◽  
Strain Relaxation

scholarly journals Gas‐source molecular‐beam epitaxy using Si2H6and GeH4and x‐ray characterization of Si1−xGex(0≤x≤0.33) alloys

1992 ◽  
Vol 71 (10) ◽  
pp. 4916-4919 ◽  
Author(s):  
S. H. Li ◽  
S. W. Chung ◽  
J. K. Rhee ◽  
P. K. Bhattacharya
Keyword(s):  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
X Ray ◽  
Gas Source

Heterostructures of GaAs and AlAs on Silicon: X-Ray Analysis and Excimer Laser Annealing

1988 ◽  
Vol 116 ◽  
Author(s):  
A. Georgakilas ◽  
M. Fatemi ◽  
L. Fotiadis ◽  
A. Christou
Keyword(s):  
Molecular Beam Epitaxy ◽  
Dislocation Density ◽  
Excimer Laser ◽  
Molecular Beam ◽  
Laser Annealing ◽  
High Resistivity ◽  
Silicon Substrates ◽  
Excimer Laser Annealing ◽  
X Ray ◽  
High Resistivity Silicon

AbstractOne micron thick AlAs/GaAs structures have been deposited by molecular beam epitaxy onto high resistivity silicon substrates. Subsequent to deposition, it is shown that Excimer laser annealing up to 120mJ/cm2 at 248nm improves the GaAs mobility to approximately 2000cm2 /v-s. Dislocation density, however, did not decrease up to 180mJ/cm2 showing that improvement in transport properties may not be accompanied by an associated decrease in dislocation density at the GaAs/Si interface.

Optical and Structural Properties of AlGaN/GaN Quantum Wells Grown by Molecular Beam Epitaxy

1998 ◽  
Vol 537 ◽  
Author(s):  
Nicolas Grandjean ◽  
Jean Massies ◽  
Mathieu Leroux ◽  
Marguerite Latigt ◽  
Pierre Lefebvre ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Quantum Wells ◽  
Molecular Beam ◽  
Stark Effect ◽  
X Ray Diffraction ◽  
X Ray ◽  
Quantum Confined Stark Effect ◽  
Sapphire Substrates ◽  
Gan Buffer Layer ◽  
Large Quantum

AbstractAIGaN/GaN quantum well (QWs) were grown on (0001) sapphire substrates by molecular beam epitaxy (MBE) using ammonia as nitrogen precursor. The Al composition in the barriers was varied between 8 and 27 % and the well thickness from 4 to 17 monolayers (MLs, 1ML = 2.59Å). X-ray diffraction (XRD) experiments are used to investigate the strain state of both the well and the barriers. The QW transition energy are measured by low temperature photoluminescence (PL). A large quantum confined Stark effect is observed leading to QW luminescence much lower than the emission line of the GaN buffer layer for well width above a certain critical thickness. The built-in electric field responsible for such a phenomenon is deduced from fit of the PL data. Its magnitude is of several hundred kV/cm and increases linearly with the Al composition.

Sign in / Sign up

Export Citation Format

Share Document