scholarly journals Interface Roughness Effects in Ultra-Thin Tunneling Oxides

VLSI Design ◽  
1998 ◽  
Vol 8 (1-4) ◽  
pp. 47-51 ◽  
Author(s):  
D. Z.-Y. Ting ◽  
Erik S. Daniel ◽  
T. C. Mcgill
Keyword(s):  
Silicon Oxide ◽  
Theoretical Study ◽  
Interface Roughness ◽  
Oxide Interface ◽  
Roughness Effects ◽  
Direct Tunneling ◽  
Silicon Based

Advanced MOSFET for ULSI and novel silicon-based devices require the use of ultrathin tunneling oxides where non-uniformity is often present. We report on our theoretical study of how tunneling properties of ultra-thin oxides are affected by roughness at the silicon/oxide interface. The effect of rough interfacial topography is accounted for by using the Planar Supercell Stack Method (PSSM) which can accurately and efficiently compute scattering properties of 3D supercell structures. Our results indicate that while interface roughness effects can be substantial in the direct tunneling regime, they are less important in the Fowler-Nordheim regime.

Tem Studies of Silicon-Silicon Oxide Interface Roughness

1987 ◽  
Vol 105 ◽  
Author(s):  
Kyung-Ho Park ◽  
T. Sasaki ◽  
S. Matsuoka ◽  
M. Yoshida ◽  
M. Nakano
Keyword(s):  
Polycrystalline Silicon ◽  
Silicon Oxide ◽  
Thermally Grown Oxide ◽  
Interface Roughness ◽  
Silicon On Insulator ◽  
Oxide Surface ◽  
Bulk Single Crystal ◽  
Oxide Interface ◽  
Crystal Silicon ◽  
Cross Sectional

AbstractInterfaces between two kind of substrate, a bulk silicon wafer and a laser-recrystallized Silicon-On-Insulator (SOI), and its thermally grown oxide have been studied. High resolution transmission electron microscopy (HRTEM) of cross sectional specimen shows that the roughness at the interface is atomically flat and nearly uniform for the bulk single crystal silicon and silicon oxide, while being nonuniform and rough as much as 20 nm height for the recrystallized silicon and silicon oxide interface. Consideration of interface between recrystallized silicon and silicon oxide, and the oxide surface above, the observed roughness at the interface is due to original grain boundaries of polycrystalline silicon which was used as the material for the laser recrystallized silicon formation. It is also discussed HRTEM of the interface between polycrystalline silicon and silicon oxide.

Dendritic Growth Failure of a Mesa Diode

1997 ◽  
Author(s):  
P. Singh ◽  
V. Cozzolino ◽  
G. Galyon ◽  
R. Logan ◽  
K. Troccia ◽  
...  
Keyword(s):  
Electric Fields ◽  
Dendritic Growth ◽  
Silicon Oxide ◽  
Impact Ionization ◽  
Electron Tunneling ◽  
Growth Failure ◽  
Side Wall ◽  
Oxide Interface ◽  
Band Bending ◽  
Cross Section Area

Abstract The time delayed failure of a mesa diode is explained on the basis of dendritic growth on the oxide passivated diode side walls. Lead dendrites nucleated at the p+ side Pb-Sn solder metallization and grew towards the n side metallization. The infinitesimal cross section area of the dendrites was not sufficient to allow them to directly affect the electrical behavior of the high voltage power diodes. However, the electric fields associated with the dendrites caused sharp band bending near the silicon-oxide interface leading to electron tunneling across the band gap at velocities high enough to cause impact ionization and ultimately the avalanche breakdown of the diode. Damage was confined to a narrow path on the diode side wall because of the limited influence of the electric field associated with the dendrite. The paper presents experimental details that led to the discovery of the dendrites. The observed failures are explained in the context of classical semiconductor physics and electrochemistry.

Nitrogen Implantation and Diffusion in Silicon

1999 ◽  
Vol 568 ◽  
Author(s):  
Lahir Shaik Adam ◽  
Mark E. Law ◽  
Omer Dokumaci ◽  
Yaser Haddara ◽  
Cheruvu Murthy ◽  
...  
Keyword(s):  
Silicon Oxide ◽  
Gate Oxide ◽  
Nitrogen Diffusion ◽  
Nitrogen Implantation ◽  
Oxide Interface ◽  
Diffusion Behavior ◽  
Czochralski Silicon ◽  
Interface Modeling ◽  
And Diffusion ◽  
Silicon Silicon

ABSTRACTNitrogen implantation can be used to control gate oxide thicknesses [1,2]. This study aims at studying the fundamental behavior of nitrogen diffusion in silicon. Nitrogen at sub-amorphizing doses has been implanted as N2+ at 40 keV and 200 keV into Czochralski silicon wafers. Furnace anneals have been performed at a range of temperatures from 650°C through 1050°C. The resulting annealed profiles show anomalous diffusion behavior. For the 40 keV implants, nitrogen diffuses very rapidly and segregates at the silicon/ silicon-oxide interface. Modeling of this behavior is based on the theory that the diffusion is limited by the time to create a mobile nitrogen interstitial.

Interface roughness effects in Gaussian superlattices

2001 ◽  
Vol 16 (5) ◽  
pp. 304-309 ◽  
Author(s):  
Francesco Banfi ◽  
Vittorio Bellani ◽  
Ignacio Gómez ◽  
Enrique Diez ◽  
Francisco Domínguez-Adame
Keyword(s):  
Interface Roughness ◽  
Roughness Effects

Hydrogen passivation of silicon/silicon oxide interface by atomic layer deposited hafnium oxide and impact of silicon oxide underlayer

2018 ◽  
Vol 36 (1) ◽  
pp. 01A116 ◽  
Author(s):  
Evan Oudot ◽  
Mickael Gros-Jean ◽  
Kristell Courouble ◽  
Francois Bertin ◽  
Romain Duru ◽  
...  
Keyword(s):  
Hafnium Oxide ◽  
Silicon Oxide ◽  
Atomic Layer ◽  
Hydrogen Passivation ◽  
Oxide Interface ◽  
Silicon Silicon

A New Model Silicon/Silicon Oxide Interface Synthesized fromH10Si10O15andSi(100)-2×1

1997 ◽  
Vol 36 (Part 1, No. 3B) ◽  
pp. 1622-1626 ◽  
Author(s):  
K. Z. Zhang ◽  
Leah M. Meeuwenberg ◽  
Mark M. Banaszak Holl ◽  
F. R. McFeely
Keyword(s):  
Silicon Oxide ◽  
Oxide Interface ◽  
New Model ◽  
Silicon Silicon
Sign in / Sign up

Export Citation Format

Share Document