Free modulation of defect states in multilayer structures consisting of epsilon-negative material and mu-negative material

2008 ◽  
Author(s):  
Qiong Wang ◽  
Changchun Yan ◽  
Lingling Zhang ◽  
Yiping Cui
Keyword(s):  
Multilayer Structures ◽  
Defect States ◽  
Negative Material

Size-Dependent Absorption and Defect States in CdSe Nanocrystals in Various Multilayer Structures

2002 ◽  
Vol 2 (6) ◽  
pp. 645-652 ◽  
Author(s):  
D. Nesheva ◽  
Z. Levi ◽  
Z. Aneva ◽  
I. Zrinscak ◽  
C. Main ◽  
...  
Keyword(s):  
Multilayer Structures ◽  
Cdse Nanocrystals ◽  
Defect States ◽  
Size Dependent ◽  
Dependent Absorption

Investigation of ultra-thin films of YBa2Cu3O7−δ grown on MgO

1990 ◽  
Vol 48 (4) ◽  
pp. 6-7
Author(s):  
S.K. Streiffer ◽  
C.B. Eom ◽  
J.C. Bravman ◽  
T.H. Geballet
Keyword(s):  
Thin Films ◽  
Room Temperature ◽  
Deposition Process ◽  
Nucleation And Growth ◽  
Multilayer Structures ◽  
Rf Power ◽  
Oxygen Loss ◽  
Transmission Electron ◽  
Single Target ◽  
Mtorr Argon

The study of very thin (<15 nm) YBa2Cu3O7−δ (YBCO) films is necessary both for investigating the nucleation and growth of films of this material and for achieving a better understanding of multilayer structures incorporating such thin YBCO regions. We have used transmission electron microscopy to examine ultra-thin films grown on MgO substrates by single-target, off-axis magnetron sputtering; details of the deposition process have been reported elsewhere. Briefly, polished MgO substrates were attached to a block placed at 90° to the sputtering target and heated to 650 °C. The sputtering was performed in 10 mtorr oxygen and 40 mtorr argon with an rf power of 125 watts. After deposition, the chamber was vented to 500 torr oxygen and allowed to cool to room temperature. Because of YBCO’s susceptibility to environmental degradation and oxygen loss, the technique of Xi, et al. was followed and a protective overlayer of amorphous YBCO was deposited on the just-grown films.

Aperiodic multilayer structures in soft X-ray optics

2015 ◽  
Vol 185 (11) ◽  
pp. 1203-1214 ◽  
Author(s):  
Aleksandr S. Pirozhkov ◽  
Evgenii N. Ragozin
Keyword(s):  
Multilayer Structures ◽  
Ray Optics ◽  
X Ray

Spectrum of Defect States in Porous Organic Low-k Dielectric Films, Annealed in Argon and Nitrogen

2003 ◽  
Vol 766 ◽  
Author(s):  
V. Ligatchev ◽  
T.K.S. Wong ◽  
T.K. Goh ◽  
Rusli Suzhu Yu
Keyword(s):  
Deep Level ◽  
Dielectric Films ◽  
Silicon Substrates ◽  
Reverse Bias Voltage ◽  
Defect States ◽  
Single Side ◽  
Sandwich Type ◽  
Transient Spectroscopy ◽  
P Type ◽  
Spectrum Deconvolution

AbstractDefect spectrum N(E) of porous organic dielectric (POD) films is studied with capacitance deep-level-transient-spectroscopy (C-DLTS) in the energy range up to 0.7 eV below conduction band bottom Ec. The POD films were prepared by spin coating onto 200mm p-type (1 – 10 Δcm) single-side polished silicon substrates followed by baking at 325°C on a hot plate and curing at 425°C in furnace. The film thickness is in the 5000 – 6000 Å range. The ‘sandwich’ -type NiCr/POD/p-Si/NiCr test structures showed both rectifying DC current-voltage characteristics and linear 1/C2 vs. DC reverse bias voltage. These confirm the applicability of the C-DLTS technique for defect spectrum deconvolution and the n-type conductivity of the studied films. Isochronal annealing (30 min in argon or 60 min in nitrogen) has been performed over the temperature range 300°C - 650°C. The N(E) distribution is only slightly affected by annealing in argon. However, the distribution depends strongly on the annealing temperature in nitrogen ambient. A strong N(E) peak at Ec – E = 0.55 – 0.60 eV is detected in all samples annealed in argon but this peak is practically absent in samples annealed in nitrogen at Ta < 480°C. On the other hand, two new peaks at Ec – E = 0.12 and 0.20 eV appear in the N(E) spectrum of the samples annealed in nitrogen at Ta = 650°C. The different features of the defect spectrum are attributed to different interactions of argon and nitrogen with dangling carbon bonds on the intra-pore surfaces.

EPR spectra and defect states in glasses of the GexS100-x system

1982 ◽  
Vol 47 (7) ◽  
pp. 1787-1793 ◽  
Author(s):  
Miloslav Frumar ◽  
Gustáv Plesch ◽  
Eva Černošková ◽  
Václav Černý ◽  
Ladislav Tichý ◽  
...  
Keyword(s):  
Experimental Data ◽  
Epr Spectra ◽  
Defect States ◽  
Composition Region ◽  
Active Defect ◽  
Temperature Conditions ◽  
Defect Centres

Glasses of the GexS100-x system were studied in the region of 30 ⪬ x ⪬ 45. The concept of magnetically active defect centres was employed to account for the EPR spectra of pure samples as well as those doped with silver or iodine, prepared in different temperature conditions. In terms of this concept a consistent interpretation of the experimental data could be given for the composition region applied.

The Instability Characteristics of Amorphous Silicon Thin Film Transistors with Various Interfacial and Bulk Defect States

1997 ◽  
Vol 36 (Part 1, No. 10) ◽  
pp. 6226-6229 ◽  
Author(s):  
Huang-Chung Cheng ◽  
Jun-Wei Tsai ◽  
Chun-Yao Huang ◽  
Fang-Chen Luo ◽  
Hsing-Chien Tuan
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thin Film Transistors ◽  
Defect States ◽  
Silicon Thin Film

scholarly journals Correlation between Defects and Electrical Performances of Ion-Irradiated 4H-SiC p–n Junctions

Materials ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 1966
Author(s):  
Domenico Pellegrino ◽  
Lucia Calcagno ◽  
Massimo Zimbone ◽  
Salvatore Di Franco ◽  
Antonella Sciuto
Keyword(s):  
Deep Level ◽  
Electrical Characterization ◽  
High Fluence ◽  
Defect States ◽  
Exponential Parameter ◽  
Current Voltage ◽  
Different Temperatures ◽  
In Series ◽  
Transient Spectroscopy ◽  
Fluence Range

In this study, 4H-SiC p–n junctions were irradiated with 700 keV He+ ions in the fluence range 1.0 × 1012 to 1.0 × 1015 ions/cm2. The effects of irradiation were investigated by current–voltage (I–V) and capacitance–voltage (C–V) measurements, while deep-level transient spectroscopy (DLTS) was used to study the traps introduced by irradiation defects. Modifications of the device’s electrical performances were observed after irradiation, and two fluence regimes were identified. In the low fluence range (≤1013 ions/cm2), I–V characteristics evidenced an increase in series resistance, which can be associated with the decrease in the dopant concentration, as also denoted by C–V measurements. In addition, the pre-exponential parameter of junction generation current increased with fluence due to the increase in point defect concentration. The main produced defect states were the Z1/2, RD1/2, and EH6/7 centers, whose concentrations increased with fluence. At high fluence (>1013 ions/cm2), I–V curves showed a strong decrease in the generation current, while DLTS evidenced a rearrangement of defects. The detailed electrical characterization of the p–n junction performed at different temperatures highlights the existence of conduction paths with peculiar electrical properties introduced by high fluence irradiation. The results suggest the formation of localized highly resistive regions (realized by agglomeration of point defects) in parallel with the main junction.

Sign in / Sign up

Export Citation Format

Share Document