Temperature and frequency dependent electrical characterization of HfO2/InxGa1−xAs interfaces using capacitance-voltage and conductance methods

2009 ◽  
Vol 94 (10) ◽  
pp. 102902 ◽  
Author(s):  
É. O’Connor ◽  
S. Monaghan ◽  
R. D. Long ◽  
A. O’Mahony ◽  
I. M. Povey ◽  
...  
Keyword(s):  
Electrical Characterization ◽  
Frequency Dependent ◽  
Capacitance Voltage

Electrical Characterization of In Schottky Contacts to Epitaxial n-In0.46Ga0.54P Grown on n+-GaAs by Mocvd

1996 ◽  
Vol 448 ◽  
Author(s):  
N. Marcano ◽  
A. Singh
Keyword(s):  
Barrier Height ◽  
Thermionic Emission ◽  
Electrical Characterization ◽  
Interface Layer ◽  
Zero Bias ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Direct Current Voltage ◽  
Etched Surface

AbstractIn/n-In0.46Ga0.54P Schottky diode was fabricated by thermal evaporation of In on chemically etched surface of In0.45Ga0.54P:Si epitaxial layer grown on highly doped n type GaAs. The In metal formed a high quality rectifying contact to In0.46Ga0.54P:Si with a rectification ratio of 500. The direct current-voltage/temperature (I-V/T) characteristics were non-ideal with the values of the ideality factor (n) between 1.26-1.78 for 400>T>260 K. The forward I-V data strongly indicated that the current was controlled by the generation-recombination (GR) and thermionic emission (TE) mechanisms for temperature in the range 260-400 K. From the temperature variation of the TE reverse saturation current, the values of (0.75±0.05)V and the (4.5±0.5)×10-5 Acm-2K-2 for the zero bias zero temperature barrier height (φoo) and modified effective Richardson constant were obtained. The 1 MHz capacitance-voltage (C-V) data for 260 K < T < 400 K was analyzed in terms of the C-2-V relation including the effect of interface layer to obtain more realistic values of the barrier height (φbo). The temperature dependence of φbo was described the relation φbo =(0.86±10.03) - (8.4±0.7)×l0-4T. The values of φoo, obtained by the I-V and C-V techniques agreed well.

Electrical Characterization of Al2O3 - SiO2 Mos Structures

1999 ◽  
Vol 567 ◽  
Author(s):  
L-Å Ragnarsson ◽  
E. Aderstedt ◽  
P. Lundgren
Keyword(s):  
Electrical Characterization ◽  
Thickness Reduction ◽  
Initial Thickness ◽  
Equivalent Thickness ◽  
Conventional Furnace ◽  
Capacitance Voltage ◽  
Layered Dielectric ◽  
The Impact ◽  
Mos Structures

ABSTRACTA comparative capacitance voltage method is used to investigate the equivalent thickness reduction during post metallization annealing of thermally grown ultrathin (∼15-27 Å) oxides. It is found that a double layered dielectric consisting of a thin Al2O3—SiO2 sandwich is appropriate to describe both the increased capacitance and the nearly unaltered current after anneal. It is further shown that the impact of initial thickness and method of growth — in a conventional furnace or by rapid thermal oxidation — on the equivalent thickness reduction is negligible.

Metal-Ferroelectric-Semiconductor Characteristics of BaMgF4 Films on p-Silicon

1991 ◽  
Vol 230 ◽  
Author(s):  
T. S. Kalkur ◽  
J. R. Kulkarni ◽  
R. Y. Kwor ◽  
L. Levinson ◽  
L. Kammerdiner
Keyword(s):  
Threshold Voltage ◽  
Zirconium Oxide ◽  
Ionic Conduction ◽  
Electrical Characterization ◽  
Temperature Dependent ◽  
Capping Layer ◽  
Capacitance Voltage ◽  
Ferroelectric Memories ◽  
Non Destructive

AbstractCapacitance-voltage characterstics of BaMgF4 film deposited in an ion-assisted deposition system shows hysteresis and the direction of hysteresis corresponds to ferroelectric polarization. Electrical characterization of the films shows that these films can be used to implement non-destructive read-out non-volatile ferroelectric memories. These films were found to dissolve in water and other aqueous solutions. In order to overcome this problem, a suitable capping layer like zirconium oxide and amorphous silicon was deposited on BMF films. The shift in threshold voltage did not change significantly due to the incorporation of the capping layer. The shift in threshold voltage was found to be temperature dependent and this might be due to ionic conduction in fluorides.

Probing at Nanoscale Underneath the Gate Oxides in 4H-SiC MOS-Based Devices Annealed in N2O and POCl3

2014 ◽  
Vol 806 ◽  
pp. 143-147
Author(s):  
P. Fiorenza ◽  
Marilena Vivona ◽  
L.K. Swanson ◽  
Filippo Giannazzo ◽  
C. Bongiorno ◽  
...  
Keyword(s):  
Electrical Characterization ◽  
Cross Sectional ◽  
Direct Demonstration ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
N Incorporation ◽  
The Impact ◽  
Post Deposition ◽  
Partial Compensation

In this paper a comparative study of the impact of N2O and POCl3 annealing on the SiO2/SiC system is presented, combining nanoscale electrical characterization of SiC surface doping by scanning spreading resistance microscopy (SSRM) and scanning capacitance microscopy (SCM) to the conventional capacitance-voltage (C-V) and current-voltage (I-V) measurements on MOS-based devices. A significant reduction of the interface states density (from 1.8×1012 to 5.7×1011 cm-2eV-1) and, correspondingly, an increase in the carrier mobility (from 19 to 108 cm2V-1s-1) was found moving from N2O to POCl3 annealing. Furthermore, SSRM measurements on bare p+-type SiC regions selectively exposed to N2O and POCl3 at high temperature provided the direct demonstration of the incorporation of N or P-related donors in the SiC surface, leading to a partial compensation of substrate acceptors during N2O treatment and to an overcompensation during POCl3 annealing. Finally, cross-sectional SCM profiles performed on epitaxial n-doped 4H-SiC with 45 nm SiO2 (subjected to post deposition annealing in the two ambients) allowed to quantify the active donors concentrations associated to P or N incorporation under the gate oxide, showing almost a factor of ten higher doping (4.5×1018cm-3 vs 5×1017cm-3) in the case of P related donors.

scholarly journals Barrier Modification by Methyl Violet Organic Dye Molecules of Ag/P-Inp Structures

2016 ◽  
Vol 2 (3) ◽  
pp. 7 ◽  
Author(s):  
Ömer Güllü
Keyword(s):  
Barrier Height ◽  
Methyl Violet ◽  
Electrical Characterization ◽  
Interface State ◽  
State Density ◽  
Mis Structure ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Mis Diode

This work includes fabrication and electrical characterization of Metal/Interlayer/Semiconductor (MIS) structures with methyl violet organic film on p-InP wafer. Metal(Ag)/ Interlayer (methyl violet =MV)/Semiconductor(p-InP) MIS structure presents a rectifying contact behavior. The values of ideality factor (n) and barrier height (BH) for the Ag/MV/p-InP MIS diode by using the current-voltage (I-V) measurement have been extracted as 1.21 and 0.84 eV, respectively. It was seen that the BH value of 0.84 eV calculated for the Ag/MV/p-InP MIS structure was significantly higher than the value of 0.64 eV of Ag/p-InP control contact. This situation was ascribed to the fact that the MV organic interlayer increased the effective barrier height by influencing the space charge region of inorganic semiconductor. The values of diffusion potential and barrier height for the Ag/MV/p-InP MIS diode by using the capacitance-voltage (C-V) measurement have been extracted as 1.21 V and 0.84 eV, respectively. The interface-state density of the Ag/MV/p-InP structure was seen to change from 2.57×1013 eV-1cm-2 to 2.19×1012 eV-1cm-2.

scholarly journals Properties of AlN thin films deposited by means of magnetron sputtering for ISFET applications

2015 ◽  
Vol 33 (4) ◽  
pp. 669-676 ◽  
Author(s):  
Piotr Firek ◽  
Michał Wáskiewicz ◽  
Bartłomiej Stonio ◽  
Jan Szmidt
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Electrical Characterization ◽  
Ion Sensors ◽  
Si Substrates ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Mis Capacitor

AbstractThis work presents the investigations of AlN thin films deposited on Si substrates by means of magnetron sputtering. Nine different sputtering processes were performed. Based on obtained results, the tenth process was prepared and performed (for future ISFET structures manufacturing). Round aluminum (Al) electrodes were evaporated on the top of deposited layers. The MIS capacitor structures enabled a subsequent electrical characterization of the AlN films by means of current-voltage (I-V) and capacitance-voltage (C-V) measurements. Based on these results, the main parameters of investigated layers were obtained. Moreover, the paper describes the technology of fabrication and electrical characterization of ISFET transistors and possibility of their application as ion sensors.

Electrical characterization of Al/MEH-PPV/p-Si Schottky diode by current–voltage and capacitance–voltage methods

2007 ◽  
Vol 387 (1-2) ◽  
pp. 239-244 ◽  
Author(s):  
Mehmet Enver Aydin ◽  
Fahrettin Yakuphanoglu ◽  
Jae-Hoon Eom ◽  
Do-Hoon Hwang
Keyword(s):  
Schottky Diode ◽  
Electrical Characterization ◽  
Current Voltage ◽  
Capacitance Voltage

Simulations of Ge+ and C+ Implantations to form SiGe/Si HBT and Characterization of SiGe and SiGeC Diodes

1991 ◽  
Vol 220 ◽  
Author(s):  
Ashawant Gupta ◽  
Jeffrey W. Waters ◽  
Carmen Cook ◽  
Cary Y. Yang ◽  
Akira Fukamia ◽  
...  
Keyword(s):  
Electrical Characterization ◽  
Wide Bandgap ◽  
Carbon Doping ◽  
Current Voltage ◽  
Narrow Bandgap ◽  
Measurement Results ◽  
Capacitance Voltage ◽  
Emitter Junction

ABSTRACTSimulations of Ge+ and C+ implantations in Si were performed to study bandgap grading in the SiGeC/Si heterojunction bipolar transistor (HBT). Although no bandgap discontinuity was observed at the base-emitter junction, it was found that a wide-bandgap emitter and a narrow-bandgap base with proper bandgap grading were obtainable with implantation. Electrical characterization of SiGe and SiGeC diodes formed by Ge+ and C+ implantations in Si was carried out. Current-voltage (I-V) measurement results confirm that carbon doping improves the crystalline quality of the germanium-implanted layer. On the other hand, capacitance-voltage (C-V) measurements indicate that both germanium and carbon implantations result in considerable dopant deactivation.

Frequency Dependent Electrical Characterization of Al∕Al[sub 2]O[sub 3]∕PbSe-PVA MIS Diode

2011 ◽  
Author(s):  
Isha Gawri ◽  
Mamta Sharma ◽  
S. K. Tripathi ◽  
S. K. Tripathi ◽  
Keya Dharamvir ◽  
...  
Keyword(s):  
Electrical Characterization ◽  
Frequency Dependent ◽  
Mis Diode
Sign in / Sign up

Export Citation Format

Share Document