ABSTRACT1.5 micron range emission has been realized using the InAs quantum dots embedded into the metamorphic InGaAs layer containing 20% of InAs grown by MBE on a GaAs substrate. Growth regimes were optimized to reduce significantly the density of dislocations propagating into the active layer from the lattice mismatched interface. 2 mm long InGaAs/InGaAlAs lasers with 10 planes of quantum dots in the active region showed threshold current density about 1.4 kA/cm2 with the external differential efficiency as high as 38%. Lasing wavelength depends on the optical loss being in the 1.44–1.49 micron range at room temperature. On increasing the temperature the wavelength reaches 1.515 micron at 85C while the threshold current characteristic temperature of 55–60K was estimated. High internal quantum efficiency (η>60%)and low internal losses (α=3–4 cm ) were realized. Maximum room temperature output power in pulsed regime as high as 5.5 W for 100 micron wide stripe was demonstrated. Using the same concept 1.3 micron InGaAs/InGaAlAs quantum well lasers were fabricated. The active region contained quantum wells with high (∼40%) indium content which was possible due to the intermediate InGaAs strain relaxation layer. 1 mm stripe lasers showed room temperature threshold current densities about 3.3 kA/cm (λ=1.29 micron) and 400 A/cm2 at 85K. Thus, the use of metamorphic InGaAs layers on GaAs substrate is a very promising approach for increasing the emission wavelength of GaAs based lasers.
AbstractPbSe/PbSrSe multiple-quantum-well (MQW) structures and PbSrSe thin films were grown on BaF2 (111) substrates by molecular beam epitaxy (MBE) and characterized by Fourier transform infrared (FTIR) spectrometer. Strong photoluminescence without Fabry-Perot interference fringes was observed even at room temperature from the MQW structures. The peak energies for the MQW structures with different well widths shifted to high energy with increasing temperature. The absorption edge of PbSrSe layer was determined by transmission spectra. Meanwhile, we designed and fabricated λ=4.1 μm MQW vertical cavity surface emitting laser (VCSEL). A power output of 40 mW was obtained at room temperature. The room temperature threshold pump density is 200 kW/cm2.
ABSTRACTWe have obtained continuous-wave laser operation at room temperature from a (Zn,Mg)(S,Se)-based Il-VI separate-confinement heterostructure where injection of holes into the p-type quaternary was achieved through the employment of a Zn(Se,Te) graded-bandgap contact. The laser devices exhibit threshold current densities of below 300 A/cm2 and voltages below 6 V. Issues related to the control of the growth of the quaternary (Zn,Mg)(S,Se) compound, and a proposal to further reducing the laser operating voltage will also be described.
ABSTRACT1.5 micron range emission has been realized using the InAs quantum dots embedded into the metamorphic InGaAs layer containing 20% of InAs grown by MBE on a GaAs substrate. Growth regimes were optimized to reduce significantly the density of dislocations propagating into the active layer from the lattice mismatched interface. 2 mm long InGaAs/InGaAlAs lasers with 10 planes of quantum dots in the active region showed threshold current density about 1.4 kA/cm2 with the external differential efficiency as high as 38%. Lasing wavelength depends on the optical loss being in the 1.44–1.49 micron range at room temperature. On increasing the temperature the wavelength reaches 1.515 micron at 85C while the threshold current characteristic temperature of 55–60K was estimated. High internal quantum efficiency (η>60%) and low internal losses (α=3–4 cm-1 ) were realized. Maximum room temperature output power in pulsed regime as high as 5.5 W for 100 micron wide stripe was demonstrated. Using the same concept 1.3 micron InGaAs/InGaAlAs quantum well lasers were fabricated. The active region contained quantum wells with high (∼40%) indium content which was possible due to the intermediate InGaAs strain relaxation layer. 1 mm stripe lasers showed room temperature threshold current densities about 3.3 kA/cm2 (λ=1.29 micron) and 400 A/cm2 at 85K. Thus, the use of metamorphic InGaAs layers on GaAs substrate is a very promising approach for increasing the emission wavelength of GaAs based lasers.
ABSTRACTWe have studied the influence of overgrowth procedure and a few monolayer-thick AlAs overlayer on the properties of self-assembled InAs quantum dots (QDs) using scanning electron microscopy (SEM) and photoluminescence (PL). PL spectroscopy was used to optimize optical properties of the QDs by shape engineering (QD truncation) through adjustment of the thickness of overlayers and temperature of the subsequent heating. QDs with 6 nm - thick overlayer with subsequent heating up to 560°C was found to have the highest PL intensity at room temperature and the lowest FWHM, 29 meV. Ground state energy of the truncated QDs is very stable against variations of growth parameters. 1.23 μm edge-emitting laser of triple-layer QD structure demonstrated room temperature threshold current density, 74 A/cm2.
Interband cascade lasers with room temperature threshold current densities below 100 A/cm2