Raspberry Pi based automatic temperature measurement and logging system for solar thermal purposes

For automatic temperature measuring and logging purposes in solar thermal experiments, a single board computer - Raspberry Pi based and sensor system is proposed. Different data sets are observed for sensors, thermometers, and thermocouples and they are compared. The consistency of the automated temperature measurement system is also verified.

The Precise Temperature Measurement System with Compensation of Measuring Cable Influence

The article presents an active bridge system that enables the solution of a significant problem consisting in ensuring correct indications of temperature values in a wide measuring range for a Pt100 temperature sensor with properties defined by the standard (EN-60751 + A2). The presented active bridge system combines the properties of the measuring amplifier with the stabilization of the current value in the branch in which the Pt100 sensor was placed. The article focuses on the comparison of the temperature measurement in a typical resistance bridge and the measurement made in the developed active bridge, which has also become the subject of a patent. For the performed tests, in which the correctness of the temperature measurement system operation was verified, and on the basis of the obtained results, the quality of temperature measurements was compared in a wide range of changes.

Design and research of temperature measurement system for intermediate joint of 10kV power cable

Cable intermediate joint is the weak link of power cable. Its operation determines the quality of power transmission and distribution in power system. The temperature rise of the intermediate joint is the direct manifestation of a variety of faults. Therefore, monitoring the temperature of the intermediate joint of power cable and finding and eliminating cable faults in advance is of great significance to ensure the safe and reliable operation of power system. Based on the analysis of the temperature characteristics of the cable intermediate joint, the design scheme of the temperature measurement system of the power cable intermediate joint is given, and its hardware system and software system are designed. Finally, the temperature measuring device for the intermediate joint of power cable is obtained, tested on the spot, and the power consumption of the data is analyzed. The debugging results show that the system has good characteristics and meets the design requirements.

Fuzzy modeling and prediction of combustion layers′ temperature for power plant

This paper develops a fuzzy modeling strategy to study the temperature of different combustion layers in a power plant. First, a new infrared temperature measurement system is developed to measure three layers (bottom, middle and upper) temperature on both sides of the boiler. Then, a fuzzy clustering modeling algorithm is designed based on entropy to determine the structure of the fuzzy model and the corresponding fuzzy memberships of local models. The effect of modeling mismatches are overcome by the use of online identification of parameters. Simulation results show that the effectiveness of the proposed method can be achieved for a 660 MW power plant.

Intelligent electrical equipment fiber Bragg grating temperature measurement system

Fiber Bragg gratings are widely used in electrical equipment monitoring, structural health monitoring, power system fault monitoring and other actual detection occasions due to the unique advantages of anti-electromagnetic interference, low fusion loss, high sensitivity, small size, and easy distributed measurement. Fiber grating has been widely used in actual detection occasions such as electrical equipment monitoring, structural health monitoring, and power system fault monitoring. The temperature measurement of the motor based on fiber grating sensing technology not only has strong anti-electromagnetic interference ability, but also can realize multi-point distributed temperature measurement. The research of fiber grating temperature measurement system for intelligent electrical equipment is of great significance. This article mainly studies the optical fiber grating temperature measurement system of intelligent electrical equipment. This paper designs the temperature measurement system architecture, including data acquisition layer, data monitoring layer and remote monitoring layer. Complete the system design from two aspects: hardware design and software design. In the hardware part, the functions of the temperature sensor module transmission system, signal demodulation system, PLC and host computer are analyzed. Use FTM3501 fiber temperature converter is used to realize the automatic electrical fiber grating. Experimental results show that the thermometer has alarm and display analysis functions. The measurement uncertainty is analyzed, and the uncertainty of the calibration result of the fiber Bragg grating temperature sensor is 0.0725 °C; the fault judgment time of the system in this paper does not exceed 4.73 s, while the fault judgment time of the control group is more than 4.73 s. Compared with the control group, it has a faster fault accuracy speed. The system has high measurement accuracy and good stability, can be applied to actual temperature measurement systems, and has certain practical value.