Effect of Immersion/Freezing/Drying Cycles on the Hygrothermal and Mechanical Behaviour of Hemp Concrete

Hemp concrete is one of the most used bio-based materials in the construction industry due to its hygrothermal behaviour and its low environmental footprint. This is mainly due to the complexity of the microstructure of these materials and their highly breathable nature. However, their use remains limited due to the lack of databases and guarantees regarding of the evolution of their functional properties over time. In this paper, experimental investigation has been performed to answer this problematic. The aim is to investigate the influence of accelerated aging on the properties of this material through a succession of immersion/freezing/drying cycles. Materials (aged and reference) were characterized at the same relative humidity state in order to be able to compare the results and to highlight the effect of ageing on the properties of hemp concrete. Results revealed a significant change in the microstructure of this material. As a consequence, this induced significant changes in its hygrothermal and mechanical properties. An increase of 40% in water vapour permeability and decrease of 57% in compressive strength were observed after aging (07 cycles of immersion/freezing/drying).

Mexican agricultural soil dust as a source of ice nucleating particles

Agricultural soil erosion, both mechanical and eolic, may impact cloud processes as some aerosol particles are able to facilitate ice crystals formation. Given the large agricultural sector in Mexico, this study investigates the ice nucleating abilities of agricultural dust collected at different sites and generated in the laboratory. The immersion freezing mechanism of ice nucleation was simulated in the laboratory via the Universidad Nacional Autónoma de México (UNAM)- Micro Orifice Uniform Deposit Impactor (MOUDI)-Droplet freezing technique (DFT) (UNAM-MOUDI-DFT). The results show that agricultural dust from the Mexican territory promote ice formation in a temperature range from −11.8 ºC to −34.5 ºC, with ice nucleating particle (INP) concentrations between 0.11 L−1 and 41.8 L−1. Furthermore, aerosol samples generated in the laboratory are more efficient than those collected in the field, with T50 values (i.e., the temperature at which 50 % of the droplets freeze) higher by more than 2.9 ºC. The mineralogical analysis indicated a high concentration of feldspars i.e., K-feldspar and plagioclase (> 40 %) in most of the aerosol and soil samples, with K-feldspar significantly correlated with the T50 of particles with sizes between 1.8 µm and 3.2 µm. Similarly, the organic carbon (OC) was correlated with the efficiency of aerosol samples from 3.2 µm to 5.6 µm and 1.0 µm to 1.8 µm. Finally, a decrease in the efficiency as INPs, after heating the samples at 300 ºC for 2 h, evidenced that the organic matter from agricultural soils can influence the role of INPs in mixed-phase clouds.

The effect of (NH₄)₂SO₄ on the freezing properties of non-mineral dust ice-nucleating substances of atmospheric relevance

A wide range of materials including mineral dust, soil dust, and bioaerosols have been shown to act as ice nuclei in the atmosphere. During atmospheric transport, these materials can become coated with inorganic and organic solutes which may impact their ability to nucleate ice. While a number of studies have investigated the impact of solutes at low concentrations on ice nucleation by mineral dusts, very few studies have examined their impact on non-mineral dust ice nuclei. We studied the effect of dilute (NH4)2SO4 solutions (0.05 M) on immersion freezing of a variety of non-mineral dust ice-nucleating substances (INSs) including bacteria, fungi, sea ice diatom exudates, sea surface microlayer substances, and humic substances using the droplet-freezing technique. We also studied the effect of (NH4)2SO4 solutions (0.05 M) on the immersion freezing of several types of mineral dust particles for comparison purposes. (NH4)2SO4 had no effect on the median freezing temperature (ΔT50) of 9 of the 10 non-mineral dust materials tested. There was a small but statistically significant decrease in ΔT50 (−0.43 ± 0.19 ∘C) for the bacteria Xanthomonas campestris in the presence of (NH4)2SO4 compared to pure water. Conversely, (NH4)2SO4 increased the median freezing temperature of four different mineral dusts (potassium-rich feldspar, Arizona Test Dust, kaolinite, montmorillonite) by 3 to 9 ∘C and increased the ice nucleation active site density per gram of material (nm(T)) by a factor of ∼ 10 to ∼ 30. This significant difference in the response of mineral dust and non-mineral dust ice-nucleating substances when exposed to (NH4)2SO4 suggests that they nucleate ice and/or interact with (NH4)2SO4 via different mechanisms. This difference suggests that the relative importance of mineral dust to non-mineral dust particles for ice nucleation in mixed-phase clouds could potentially increase as these particles become coated with (NH4)2SO4 in the atmosphere. This difference also suggests that the addition of (NH4)2SO4 (0.05 M) to atmospheric samples of unknown composition could potentially be used as an indicator or assay for the presence of mineral dust ice nuclei, although additional studies are still needed as a function of INS concentration to confirm the same trends are observed for different INS concentrations than those used here. A comparison with results in the literature does suggest that our results may be applicable to a range of mineral dust and non-mineral dust INS concentrations.

Laboratory and field studies of ice-nucleating particles from open-lot livestock facilities in Texas

In this work, an abundance of ice-nucleating particles (INPs) from livestock facilities was studied through laboratory measurements from cloud-simulation chamber experiments and field investigation in the Texas Panhandle. Surface materials from two livestock facilities, one in the Texas Panhandle and another from McGregor, Texas, were selected as dust proxies for laboratory analyses. These two samples possessed different chemical and biological properties. A combination of aerosol interaction and dynamics in the atmosphere (AIDA) measurements and offline ice spectrometry was used to assess the immersion freezing mode ice nucleation ability and efficiency of these proxy samples at temperatures above −29 ∘C. A dynamic filter processing chamber was also used to complement the freezing efficiencies of submicron and supermicron particles collected from the AIDA chamber. For the field survey, periodic ambient particle sampling took place at four commercial livestock facilities from July 2017 to July 2019. INP concentrations of collected particles were measured using an offline freezing test system, and the data were acquired for temperatures between −5 and −25 ∘C. Our AIDA laboratory results showed that the freezing spectra of two livestock dust proxies exhibited higher freezing efficiency than previously studied soil dust samples at temperatures below −25 ∘C. Despite their differences in composition, the freezing efficiencies of both proxy livestock dust samples were comparable to each other. Our dynamic filter processing chamber results showed on average approximately 50 % supermicron size dominance in the INPs of both dust proxies. Thus, our laboratory findings suggest the importance of particle size in immersion freezing for these samples and that the size might be a more important factor for immersion freezing of livestock dust than the composition. From a 3-year field survey, we measured a high concentration of ambient INPs of 1171.6 ± 691.6 L−1 (average ± standard error) at −25 ∘C for aerosol particles collected at the downwind edges of livestock facilities. An obvious seasonal variation in INP concentration, peaking in summer, was observed, with the maximum at the same temperature exceeding 10 000 L−1 on 23 July 2018. The observed high INP concentrations suggest that a livestock facility is a substantial source of INPs. The INP concentration values from our field survey showed a strong correlation with measured particulate matter mass concentration, which supports the importance of size in ice nucleation of particles from livestock facilities.

Immersion Freezing Ability of Freshly Emitted Soot with Various Physico-Chemical Characteristics

The immersion freezing ability of soot particles has in previous studies been reported in the range of low/insignificant to very high. The aims of this study were to: (i) perform detailed physico-chemical characterisation of freshly produced soot particles with very different properties, (ii) investigate the immersion freezing ability of the same particles, and (iii) investigate the potential links between physico-chemical particle properties and ice-activity. A miniCAST soot generator was used to produce eight different soot samples representing a wide range of physico-chemical properties. A continuous flow diffusion chamber was used to study each sample online in immersion mode over the temperature (T) range from −41 to −32 °C, at a supersaturation of about 10% with respect to liquid water. All samples exhibited low to no heterogeneous immersion freezing. The most active sample reached ice-activated fractions (AF) of 10−3 and 10−4 at temperatures of 1.7 and 1.9 K , respectively, above the homogeneous freezing temperature. The samples were characterized online with respect to a wide range of physico-chemical properties including effective particle density, optical properties, particle surface oxidation and soot maturity. We did observe indications of increasing immersion freezing ice-activity with increasing effective particle density and increasing particulate PAH fraction. Hence, those properties, or other properties co-varying with those, could potentially enhance the immersion freezing ice-activity of the studied soot particle types. However, we found no significant correlation between the physico-chemical properties and the observed ice-nucleating ability when the particle ensemble was extended to include previously published results including more ice-active biomass combustion soot particles. We conclude that it does not appear possible in general and in any straightforward way to link observed soot particle physico-chemical properties to the ice-nucleating ability using the online instrumentation included in this study. Furthermore, our observations support that freshly produced soot particles with a wide range of physico-chemical properties have low to insignificant immersion freezing ice-nucleating ability.

Fine cryo-SEM observation of the microstructure of emulsions frozen via high-pressure freezing

An emulsion, a type of soft matter, is complexed with at least two materials in the liquid state (e.g. water and oil). Emulsions are classified into two types: water in oil (W/O) and oil in water (O/W), depending on the strength of the emulsifier. The properties and behavior of emulsions are directly correlated with the size, number, localization and structure of the dispersed phases in the continuous phase. Therefore, an understanding of the microstructure comprising liquid-state emulsions is essential for producing and evaluating these emulsions. Generally, it is impossible for conventional electron microscopy to examine liquid specimens, such as emulsion. Recent advances in cryo-scanning electron microscopy (cryo-SEM) could allow us to visualize the microstructure of the emulsions in a frozen state. Immersion freezing in slush nitrogen has often been used for preparing the frozen samples of soft matters. This preparation could generate ice crystals, and they would deform the microstructure of specimens. High-pressure freezing contributes to the inhibition of ice-crystal formation and is commonly used for preparing frozen biological samples with high moisture content. In this study, we compared the microstructures of immersion-frozen and high-pressure frozen emulsions (O/W and W/O types, respectively). The cryo-SEM observations suggested that high-pressure freezing is more suitable for preserving the microstructure of emulsions than immersion freezing.