Applications of Shallow Seismic Refraction Measurements in the Western Carpathians (Slovakia): Case Studies

Shallow seismic measurement, specifically seismic refraction tomography, is an effective geophysical method that has applications in various sectors. It enables the search for and determination of the course of the interfaces, thus helping to resolve geological, environmental, hydrogeological, engineering, geotechnical and other problems. The paper demonstrates the possibilities of using these methods through examples of shallow seismic measurements that have been performed at various four locations in the Western Carpathian Mountains. The first case study describes Monastery Pond at Katarínka. It was found that, the basement of the Monastery pond is at a depth of 2-3 m below the surface and the results were also confirmed by electrical resistivity tomography (ERT). The next measurement through the thermal power station waste storage showed that the storage area base runs at a depth of about 20 m under the measured profile. The third case study addresses the depth of groundwater depth in the area of Borská nízina. The measurement confirmed the assumed depth of ground water level at 3.35 m below the surface. In the last case study, border fault between the Turiec Basin and the Malá Fatra Mts. was mapped by application of shallow refraction methods. The results show that shallow seismic methods shed light on the problem and in combination with other geophysical methods are an effective tool with great potential. They provide very useful data for shallow mapping applications.

THE CENTRALIZED SYSTEM OF HEAT SUPPLY WITH THERMAL PUMPS

The article presents the analysis of technical and economic efficiency of replacement of a boiler house by a heatpumping unit that uses as a low potential heat source the heat electropower station waste water.

Solidification of Simulated Liquid Waste of Primary Loop Resin Elution Process of PWR

Primary loop resin waste is eluted by sulfuric acid in The Kansai Electic Company Mihama, Takahama and Ohi nuclear power station. Waste solution from this elution process is planned to be solidified by cement. This study bring out a range of chemical composition and crud concentration of waste solution from this elution process, and examine the properties of alumina cement solidification process and solidified material. Test for sulfate ion, borate, lithium, ammonium ion was carried out. Volume reduction ratio of over 0.5 was achieved for 5 to 25wt% of sulfate ion and <5,000ppm of borate. Lithium ion restrained the solidification delay by borate. Also, ammonium ion shows no significant effect. Based on this study, we concluded that the aluminum cement is applicable to all range of composition of waste solution from the resin elution process. This study is a part of committed work of The Kansai electric company.