Photoelectric and magnetic properties of chemically synthesized Cd-Ni Ferrite nanomagnetic particles

Cadmium nickel (Cd-Ni) ferrite samples have been successfully synthesized via chemical co-precipitation technique. The structural analysis revealed the formation of FCC framework and Fe-phase in a trivalent state. The crystallite size is decreased with increasing Cd2+ ion composition whereas the lattice constant is increased. SEM was used to obtain the surface morphology and average grain size of the microstructure. The FTIR shows the formation of metal oxide, hydroxyl and carboxylic groups. EDX revealed the formation of Ni2+, Cd2+, Fe3+, and O2- ions in proper stoichiometric composition. Large optical losses were revealed by Cd2+ poor-NiFe2O4 samples whereas Cd2+ rich-CdxNi1-xFe2O4 samples revealed low optical losses and showed enhanced photoconductivity and photoelectric effect. Result from optical analysis showed that Cd2+ rich-CdxNi1-xFe2O4 nanoparticles can be used as infrared (IR) detector, ultraviolet (UV) filter and in optoelectronics device applications. VSM measurement showed an increase in saturation magnetization and decrease in coercivity as Cd2+ ion content is increased. The remanance magnetization and magnetic anisotropy were also examined. Photoluminescence (PL) spectroscopy examined the nature of the light emission of the samples at the excitation wavelength 380 nm and emission of series of colours such as red, green, yellow, orange and violet light at different wavelengths were found.

Analyzing Distributed Vibrating Sensing Technologies in Optical Meshes

Hundreds of kilometers of optical fibers are installed for optical meshes (OMs) to transmit data over long distances. The visualization of these deployed optical fibers is a highlighted issue because the conventional procedure can only measure the optical losses. Thus, this paper presents distributed vibration sensing (DVS) estimation mechanisms to visualize the optical fiber behavior installed for OMs which is not possible by conventional measurements. The proposed technique will detect the power of light inside the optical fiber, as well as different physical parameters such as the phase of transmitted light inside the thread, the frequency of vibration, and optical losses. The applicability of optical frequency domain reflectometry (OFDR) and optical time-domain reflectometry (OTDR) DVS techniques are validated theoretically for various state detection procedures in optical fibers. The simulation model is investigated in terms of elapsed time, the spectrum of a light signal, frequency, and the impact of many external physical accidents with optical fibers.

High efficiency five-element trap detector with low optical losses

We have constructed a 5-element trap detector using 10 x 10 mm UVG100 photodiodes. The trap exhibits high uniformity of responsivity (±100 part per million) and ultra-low reflectance losses (mostly below 1 part per million) throughout the visible range. Responsivity and quantum efficiency measurements indicate close to ideal performance between 360 nm and 680 nm within the expanded measurement uncertainty of 0.25 %–0.15 %. The UVG trap can be considered as an absolute detector between these wavelengths and as a cheaper and a simpler alternative to the custom-made Predictable Quantum Efficient Detector for use in photometric and radiometric applications.

Optical Gain in Commercial Laser Diodes

Optical gain and optical losses are separately measured in commercial laser diodes by simple analysis of spectral and electrical characteristics, and with no special specimen preparation or handling. The aim is to bring device analysis, for characterization and reliability purposes, closer to the intimate physical processes that rule over laser diode operation. Investigation includes resonating and non-resonating optical cavities.

Reflectometry Study of the Pyroelectric Effect on Proton-Exchange Channel Waveguides in Lithium Niobate

This work is devoted to the study of the pyroelectric effect on the properties of optical waveguides formed in a lithium niobate crystal by proton exchange. In the present work, we studied the cessation effect of the radiation channeling during thermocycling of Y-splitters samples. We examined the spectral dependence of optical losses on the wavelength using an optical spectrum analyzer. The results demonstrate that in the range of 1530–1570 nm, all wavelengths are suppressed equally. The optical frequency domain reflectometry shows that the increase of optical losses is observed along the entire waveguide, but not only at the Y-splitting point, as supposed earlier.

Reflectometry Study of the Pyroelectric Effect on Proton-Exchange Channel Waveguides in Lithium Niobate

This work is devoted to the study of the pyroelectric effect on the qualities of optical waveguides formed in a lithium niobate crystal by proton exchange. In the present work, we investigated the cessation effect of the radiation channeling during thermocycling of Y-splitters samples. We examined the spectral dependence of optical losses on a wavelength using an optical spectrum analyzer. The results demonstrate that in the range of 1530–1570 nm, all wavelengths are suppressed equally. The optical reflectometry method in the frequency domain shows that the increase of optical losses is observed along the entire waveguide, but not only at the Y-distribution point, as supposed earlier.

Photosensitive Yb-Doped Germanophosphosilicate Artificial Rayleigh Fibers as a Base of Random Lasers

Asingle-mode Yb-doped germanophosphosilicate fiber with ultra-low optical losses (less than 2 dB/km) was fabricated by means of the MCVD method utilizing an all-gas-phase deposition technique developed “in house”. The absorption and luminescent spectral properties of the fiber were thoroughly studied. The photosensitivity of the pristine (non-hydrogenated) fiber to 248 nm-laser radiation was confirmed by means of fiber Bragg grating (FBG) inscription directly during the drawing process. The random single-frequency lasing at the 1060-nm-wavelength obtained in the 21-m-long fiber with an array of weak FBG was reported. The developed laser slope efficiency in the backward-pumping scheme was measured as high as 32%.

Optical Losses of Frontal Layers in Superstrate CdS/CdTe Solar Cells Using OPAL2

In this paper, optical losses in CdS/CdTe solar cells are calculated on the basis of the designated reflective index of various frontal layers using an OPAL2 calculator for the first time. Two types of glass (0.1 mm ultra-thin Schott and 1.1 mm standard borosilicate glass) were assumed to be coated by different Transparent-Conducting-Oxides (TCOs) such as SnO2:F, ZnO:Al, and ITO forming frontal layers for CdS/CdTe solar cells in superstrate configuration. Absorption, reflectance, transmittance, and consequently optical bandgap energies are calculated as a function of common thicknesses, used in the literature. The results show that an increase in TCO thickness led to a decrease in optical band gap as well as an enhancement in contact potential difference, which can deteriorate device performance. The optimum thickness of 100 nm for SnO2:F was calculated, while 200 nm for ZnO:Al and ITO show reasonable optical losses caused by reflections at the interfaces’ and the layer’s absorption. It is seen that 80 to 150 nm CdS on ITO might be an effective range to satisfy a high short circuit current and low defect densities at the CdS/CdTe interface. Finally, a minimum 2 μm thickness for the CdTe on the ultra-thin Schott glass coated by optimum layers can result in the highest short circuit current of 28.69 mA/cm2. This work offers a practical equivalent strategy to be applied for any superstrate solar cells containing TCO and CdS frontal layers.