Сравнительное исследование термостойкости пелликлов на основе бериллия

We demonstrate the possibility of manufacturing Be-based ultrathin films with high transmission at wavelengths of 11.4 and 13.5 nm. For free-standing films of Be and Be-based multilayer structures (Si/Be, ZrSi2/Be, Be/BexNy, Zr/Be, Ru/Be, Mo/Be), we determine the thresholds of the absorbed power at which over a short period (tens of minutes) of vacuum annealing, initially sagging free-standing films became visibly stretched over the hole. Of the film structures tested here, the Be/BexNy structure (with beryllium nitride interlayers) showed the highest threshold for the absorbed power (1 W/cm2). However, due to the low strength of this structure, ZrSi2/Be, Mo/Be, and Be films seem to be more promising for the manufacture of a full-size pellicle. Long-term vacuum annealing of Mo/Be and Be ultrathin films showed that they could withstand 24 hours of vacuum heating at an absorbed power density of 0.2 W/cm2 (film temperature ~250°C) without noticeable changes in EUV transmission or sagging of films. With comparable transmission (~83% at 13.5 nm and ~88% at 11.4 nm), a multilayer Mo/Be structure with a thickness of 30 nm appears to be preferable, as it shows less brittleness than a monolayer Be film with a thickness of 50 nm.

Гальваномагнитные свойства и термоэдс ультратонких пленок системы висмут--сурьма на подложке из слюды

The study of the electronic properties of ultrathin films of pure bismuth and bismuth-antimony alloys is of interest, since an increase in conductivity with decreasing sample thickness was found. This paper presents the results of an experimental study of the structure, electrical, galvanomagnetic and thermoelectric properties of pure bismuth and Bi1−x Sbx thin films (x = 0.05 and 0.12) on a mica substrate in the thickness range of 10−30 nm. An increase in the conductivity with a decrease in the thickness of the samples was found. It may be due to the presence of topologically protected surface states. It is shown that the features of the manifestation of this effect are significantly influenced by the alloys band structure. The form of the temperature dependences of the Seebeck coefficient casts doubt on the fact that surface states have a positive effect on the thermoelectric efficiency of thin bismuth-antimony films. However, the detection of a positive thermoelectric power in Bi0.88Sb0.12 samples can become an important factor for searching for the possibility of creating a p-branch of thermoelectric converters.

Use of an electronic tongue in the assessment of highly diluted systems

Introduction: “Eletronic tongue” is a device commonly used in the analysis of tastants, heavy metal ions, fruit juice, wines and also in the development of biosensors [1-3]. Briefly, the e-tongue is constituted by sensing units formed by ultrathin films of distinct materials deposited on gold interdigitated electrodes, which are immersed in liquid samples, followed by impedance spectroscopy measurements [1]. The e-tongue sensor is based on the global selectivity concept, i.e., the materials forming the sensing units are not selective to any substance in the samples, therefore, it allows the grouping of information into distinct patterns of response, enabling the distinction of complex liquid systems [1]. Aim: Our aim was to use e-tongue system for the assessment the homeopathic medicine Belladonna at different degrees of dilution, in attempt to differentiate highly diluted systems. Methods: Ultrathin films forming the sensing units were prepared by the layer-by-layer technique [4], using conventional polyelectrolytes such as poly(sodium styene sulfonate) (PSS) and poly(allylamine) hydrochloride (PAH), chitosan and poly(3,4-ethylenedioxythiophene) (PEDOT). Homeopathic medicines (Belladonna 1cH, 6cH, 12cH and 30cH) were prepared by dilution and agitation according to Hahnemann´s method [5], using ethanol at 30% (w/w) as vehicle. Experimental data acquisition was conducted by blind tests measurements involving Belladonna samples and the vehicle used in the dilutions. Five independent and consecutive measurements were taken for each solution at 1 kHz, which were further analysed by Principal Component Analysis (PCA), a statistical method largely employed to reduce the dimensionality of the original data without losing information in the correlation of the samples [3]. Results: Figure 1 shows that the five independent measurements are grouped quite closed each other for each solution analysed, with a clear distinction of them. Therefore, it was noticed a change in the observed pattern measured at different days, indicating a reduced reproducibility, although the groups of data could still be identified. Discussion: PCA is a powerful tool highly employed to extract relevant information in the correlation of data analysis of e-tongue systems. PCA plots showed a good statistical correlation of the systems (PC1 + PC2 ³ 90%), with the solutions being straightforwardly distinguished each other and also from the vehicle used. Conclusion: Despite the differences of data obtained along distinct days of analysis, the e-tongue could detect differences among the samples tested, even considering the highly diluted cases studied.

Enhanced Piezoresponse and Dielectric Properties for Ba1-XSrXTiO3 Composition Ultrathin Films by the High-Throughput Method

The stacked single-unit cell Ba1-xSrxTiO3 (BSTO) thin film designed by the high-throughput method is fabricated by layer-by-layer deposition by laser molecular beam epitaxy, and its ferroelectric and dielectric characteristics as a function of Sr concentration are comprehensively investigated. The permittivity of BSTO exhibits a monotonous increase by Sr with a plateau in the region of 14% < Sr < 85%. Meanwhile, at the low Sr doping regime, the piezoelectric response has been discovered, and the maximum piezoresponse and d33 can reach approximately 139.05 pm and 88 pm/V once an appropriate Ba/Sr ratio is formed, exhibiting a coexistence of a dielectric property and giant piezoresponse. This effective piezoelectric constant d33 value is significantly larger than the conventional chemical doping scenarios, suggesting that the intra-plane interaction is crucial for designing future promising dielectric and ferroelectric thin films via high-throughput technologies.