Water Footprint for Garlic under Irrigation Levels and Agrispon Application

Field experiment was conducted in Giza, Egypt, during two growing seasons of 2017-2018 and 2018-2019 on garlic crop, with the objective of investigating the effect of different irrigation levels (60, 80 and 100 % of water requirements and their combination with the foliar spraying applications of agrispon (with 0.5 and 1.0 ml/ liter) on growth and yield. The results indicated that increased irrigation level up to 100% led to increased vegetative characters of garlic and that the lowest growth and productivity was obtained by 60% irrigation level. When considering spray application of agrispon; with 1.0 ml/L increased growth and productivity followed by 0.5 ml/L; while control treatment gave the lowest productivity during the both seasons. Interaction effect between irrigation level and agrispon treatments indicated that 100% irrigation level combined with 1.0 ml/L spray application of agrispon gave the highest garlic productivity followed by 100% irrigation level combined with 0.5 ml/L spray application. The chemical analysis showed that the highest NPK was obtained by 100% irrigation level combined with 1.0 ml/L agrispon application during the both seasons. Regarding water footprint, the highest irrigation water footprint was obtained by 80% irrigation level followed by 60% irrigation level, while the lowest footprint was obtained by 100% irrigation level due to high garlic productivity under 100% irrigation level. The estimate water footprint for garlic was 525 m3/ton. The blue water footprint for garlic was 422 m3/ton about 80% form total water footprint, while gray water percentage about 20% with value of 103 m3/ton.

Reducing the Nursery Pesticide Footprint with Laser-guided, Variable-rate Spray Application Technology

Nursery producers are challenged with growing a wide range of species with little to no detectable damage from insects or diseases. Growing plants that meet consumer demand for aesthetics has traditionally meant routine pesticide application using the most time-efficient method possible, an air-blast sprayer, despite its known poor pesticide application efficiency. New variable-rate spray technology allows growers to make more targeted applications and reduce off-target pesticide loss. In this study, a prototype laser-guided variable-rate sprayer was compared with a traditional air-blast sprayer. Pesticide volume, spray application characteristics, and the control of powdery mildew were evaluated over the course of two growing seasons. Spray application characteristics were assessed using water-sensitive cards (WSCs) and DepositScan software. This prototype sprayer reduced pesticide volume by an average of 54% across both years despite being tested against a low rate (<250 L⋅ha−1). In 2016, the conventional sprayer had more than double the deposit density on target WSCs among distal trees than the variable-rate sprayer; however, within proximal trees, there was no difference between the two sprayer types. In 2017, when the trees were larger, within both the distal and proximal trees, the conventional sprayer had greater deposit density on target WSCs than the variable-rate sprayer. In 2016, coverage on target WSCs was nearly 7-fold greater with the conventional treatment than with the variable-rate treatment. In 2017, when trees were larger, there was greater coverage on target WSCs in proximal trees (3.8%) compared with those in distal trees (1.0%) regardless of the sprayer type. This variable-rate spray technology provided acceptable control of powdery mildew severity on individual branches and whole trees and maintained the incidence of powdery mildew to levels comparable to that occurring among trees sprayed with a traditional air-blast sprayer. Therefore, the variable-rate spray technology has the potential to effectively control disease, dramatically reduce the pesticide footprint, and preserve natural resources such as ground and surface water, soil, and beneficial insects found within and around nurseries.

Efficacy of Selected Insecticides as Replacement for Neonicotinoids in Managing Sweetpotato Whitefly on Poinsettia

Management of sweetpotato whitefly (Bemisia tabaci), one of the most economically important pests of poinsettia (Euphorbia pulcherrima), relies heavily on neonicotinoid insecticides. Growers are seeking insecticide alternatives to neonicotinoids due to market demands. Although several systemic and translaminar insecticides have been suggested as alternatives to neonicotinoids, no published study has simultaneously compared their efficacies against sweetpotato whiteflies. This study compared the efficacies of 10 systemic and translaminar alternative insecticides with those of two systemic neonicotinoids, when all products were applied as foliar spray (twice at 14 d) or substrate drench (once) against sweetpotato whiteflies on poinsettia plants. Sweetpotato whitefly nymph and adult densities were examined 2 weeks before the first application (pretreatment), and weekly after the application for 8 weeks. Results showed that insecticides varied greatly in their efficacy, particularly against adults, and that spray application provided more effective suppression of nymphs than drench application. Spray and drench applications of imidacloprid and dinotefuran were consistently the most effective against sweetpotato whitefly nymphs and adults. Among the neonicotinoid alternatives, cyantraniliprole was the most effective insecticide in reducing sweetpotato whitefly nymph densities by both spray and drench application methods, with efficacy comparable to those of imidacloprid and dinotefuran. Although less effective than cyantraniliprole, foliar sprays of afidopyropen, chloratraniliprole, cyclaniliprole, flonicamid, flupyradifurone, pyrifluquinazon, spirotetramat, and sulfoxaflor + spinetoram were also effective against nymphs and could serve as partners in an insecticide rotation program.

INSECTICIDAL EVALUATION OF AQUEOUS EXTRACT OF INDIGENOUS PLANTS IN COMPARISON WITH SYNTHETIC INSECTICIDE FOR THE MANAGMENENT OF THRIPS Scirtothrips dorsalis (Thysnaoptera; Thripidae) IN TOMATO CROP

Insecticidal evaluation of aqueous extracts of indigenous plant extracts in comparison with synthetic insecticide against Thrips (Scirotothrips dorsalis) on tomato was conducted under natural field condition during spring 2019. Experiment consists of 8 treatments (neem extract, tobacco extract, garlic extract, datura extract, lantana extract, eucalyptus extract, flonicamid (synthetic insecticide) and control following RCB Design with 3 replications. Treatments were applied thrice after 15 days interval. Results revealed that the three times application of the tested treatments showed varying toxicity against S. dorsalis 24, 48, 72 hours and 7 days after spray applications while ladybird beetle and green lacewing were also significantly affected when recorded 7 days after spray application. However, Flonicamid 50%WG proved to be the most effective till 7th and had lowest pest population followed datura and neem extract. neem extract in all the three spray application . Garlic and eucalyptus also produced significant results compared to control. Neem, tobacco, datura and flonicamid were found to be comparatively more hazardous to ladybird beetle and green lacewing population compared to eucalyptus, garlic and lantana to in all three spray application. Tomato yield was highest with flonicamid (12533 kg/ha) followed by datura and neem (11810 kg/ha and 11300 kg/ha) respectively, while lowest (8133 kg/ha) in control. It is concluded from the current research that flonicamid performed better against S. dorsalis but comparatively more hazardous to natural enemies however lantana, garlic and eucalyptus extract showed better result against S. dorsalis and comparatively safe towards natural enemies thus recommended to be incorporated in IPM program.

Recovery of probiotic bacteria from the intestinal tract of broilers after noninvasive pre-hatch application

This paper reports the success of intestinal colonisation of chickens and foetuses by probiotics after different methods of pre-hatch application. Hatcheries not using in ovo injection of probiotics or wish to avoid the reduced hatchability associated with in ovo injections prefer using alternatives to in ovo technologies. Therefore, we used noninvasive pre-hatch application methods. This included the vertical transmission of probiotics from the mother hen to offspring, application of probiotic late in incubation and transmission of probiotics during hatch. Enterococcus faecium (NCIMB11181) and Lactobacillus animalis (DSM33570) were used as probiotics. Probiotics were applied either through drinking water for the mother hens, by dipping the eggs in a probiotic solution on days 16-18 of incubation or through drops/spray on the eggshell of the fertilised eggs. Similarly, intestinal colonisation of the probiotic in chickens was investigated either before hatch (pre-hatch) or immediately after hatch (post-hatch). Based on the performed experiments, it is concluded that E. faecium was vertically transmitted from the mother hen to the offspring, as E. faecium was recovered in 20 and 33% of the offspring pre- and post-hatch, respectively. When applied on the eggshell, the recovery of E. faecium before hatch depended on the application method and ranged from 0 to 9%. In contrast, L. animalis was not recovered before hatch. Moreover, when sampling post-hatch 100% of the chickens were colonised when E. faecium was used and 54% were colonised when L. animalis was used. Furthermore, spray application with E. faecium was the most successful application method as 9% of the foetuses were colonised pre-hatch and 100% became colonised post-hatch. Therefore, pre-hatch application by, for example, spray of probiotics on the eggshell can be used as an easy-to-use, noninvasive method for early life colonisation of chicken gut.

Field assessment of a pulse width modulation (PWM) spray system applying different spray volumes: duty cycle and forward speed effects on vines spray coverage

The pulse width modulation (PWM) spray system is the most advanced technology to obtain variable rate spray application without varying the operative sprayer parameters (e.g. spray pressure, nozzle size). According to the precision agriculture principles, PWM is the prime technology that allows to spray the required amount where needed without varying the droplet size spectra which benefits both the uniformity of spray quality and the spray drift reduction. However, some concerns related to the effect of on–off solenoid valves and the alternating on/off action of adjacent nozzles on final uneven spray coverage (SC) have arisen. Further evaluations of PWM systems used for spraying 3D crops under field conditions are welcomed. A tower-shaped airblast sprayer equipped with a PWM was tested in a vineyard. Twelve configurations, combining duty cycles (DC: 30, 50, 70, 100%) and forward speeds (FS: 4, 6, 8 km h−1), were tested. Two methodologies, namely field-standardized and real field conditions, were adopted to evaluate the effect of DC and FS on (1) SC variability (CV%) along both the sprayer travel direction and the vertical spray profile using long water sensitive papers (WSP), and (2) SC uniformity (IU, index value) within the canopy at different depths and heights, respectively. Furthermore, the SC (%) and deposit density (Nst, no stains cm−2), determined using short WSP, were used to evaluate the spray application performances taking into account the spray volumes applied. Under field-controlled conditions, the pulsing of the PWM system affects both the SC variability measured along the sprayer travel direction and along the vertical spray profile. In contrast, under real field conditions, the PWM system does not affect the uniformity of SC measured within the canopy. The relationship between SC and Nst allowed identification of the ranges of 200–250 and 300–370 l ha−1 as the most suitable spray volumes to be applied for insecticide and fungicide plant protection products, respectively.