scholarly journals Experimental Investigation of the Influence of Combustor Cooling on the Characteristics of a FLOX©-Based Micro Gas Turbine Combustor

10.5772/54405 ◽  
2013 ◽  
Author(s):  
Jan Zanger ◽  
Monz Thomas ◽  
Aigner Manfre
Keyword(s):  
Experimental Investigation ◽  
Gas Turbine ◽  
Gas Turbine Combustor ◽  
Micro Gas Turbine

scholarly journals Development of Micro Gas Turbine Combustor with a Recirculation Zone Induced by an Upward Swirl

2008 ◽  
Vol 3 (1) ◽  
pp. 204-215
Author(s):  
Kousaku YOTORIYAMA ◽  
Shunsuke AMANO ◽  
Hidetomo FUJIWARA ◽  
Tomohiko FURUHATA ◽  
Masataka ARAI
Keyword(s):  
Gas Turbine ◽  
Recirculation Zone ◽  
Gas Turbine Combustor ◽  
Micro Gas Turbine

Combustion Characteristics of Small Size Gas Turbine Combustor Fueled by Biomass Gas Employing Flameless Combustion

2007 ◽  
Author(s):  
Masato Hiramatsu ◽  
Yoshifumi Nakashima ◽  
Sadamasa Adachi ◽  
Yudai Yamasaki ◽  
Shigehiko Kaneko
Keyword(s):  
Gas Turbine ◽  
Combustion Efficiency ◽  
Combustion Characteristics ◽  
Operating Conditions ◽  
Nox Emissions ◽  
Gas Turbine Combustor ◽  
Flameless Combustion ◽  
Engine Exhaust ◽  
Micro Gas Turbine

One approach to achieving 99% combustion efficiency (C.E.) and 10 ppmV or lower NOx (at 15%O2) in a micro gas turbine (MGT) combustor fueled by biomass gas at a variety of operating conditions is with the use of flameless combustion (FLC). This paper compares experimentally obtained results and CHEMKIN analysis conducted for the developed combustor. As a result, increase the number of stage of FLC combustion enlarges the MGT operation range with low-NOx emissions and high-C.E. The composition of fuel has a small effect on the characteristics of ignition in FLC. In addition, NOx in the engine exhaust is reduced by higher levels of CO2 in the fuel.

scholarly journals Detailed Examination of a Modified Two-Stage Micro Gas Turbine Combustor

2017 ◽  
Vol 140 (2) ◽  
Author(s):  
Andreas Schwärzle ◽  
Thomas O. Monz ◽  
Andreas Huber ◽  
Manfred Aigner
Keyword(s):  
Gas Turbine ◽  
Detailed Examination ◽  
Flame Stabilization ◽  
Nox Emissions ◽  
Gas Turbine Combustor ◽  
Two Stage ◽  
Micro Gas Turbine ◽  
Previous Design ◽  
Recirculation Zones ◽  
Asme Paper

Jet-stabilized combustion is a promising technology for fuel flexible, reliable, highly efficient combustion systems. The aim of this work is a reduction of NOx emissions of a previously published two-stage micro gas turbine (MGT) combustor (Zanger et al., 2015, “Experimental Investigation of the Combustion Characteristics of a Double-Staged FLOX-Based Combustor on an Atmospheric and a Micro Gas Turbine Test Rig,” ASME Paper No. GT2015-42313 and Schwärzle et al., 2016, “Detailed Examination of Two-Stage Micro Gas Turbine Combustor,” ASME Paper No. GT2016-57730), where the pilot stage (PS) of the combustor was identified as the main contributor to NOx emissions. The geometry optimization was carried out regarding the shape of the pilot dome and the interface between PS and main stage (MS) in order to prevent the formation of high-temperature recirculation zones. Both stages have been run separately to allow a detailed understanding of the flame stabilization within the combustor, its range of stable combustion, the interaction between both stages, and the influence of the modified geometry. All experiments were conducted at atmospheric pressure and an air preheat temperature of 650  °C. The flame was analyzed in terms of shape, length, and lift-off height, using OH* chemiluminescence (OH-CL) images. Emission measurements for NOx, CO, and unburned hydrocarbons (UHC) emissions were carried out. At a global air number of λ = 2, a fuel split variation was carried out from 0 (only PS) to 1 (only MS). The modification of the geometry leads to a decrease in NOx and CO emissions throughout the fuel split variation in comparison with the previous design. Regarding CO emissions, the PS operations are beneficial for a fuel split above 0.8. The local maximum in NOx emissions observed for the previous combustor design at a fuel split of 0.78 was not apparent for the modified design. NOx emissions were increasing, when the local air number of the PS was below the global air number. In order to evaluate the influence of the modified design on the flow field and identify the origin of the emission reduction compared to the previous design, unsteady Reynolds-averaged Navier–Stokes simulations were carried out for both geometries at fuel splits of 0.93 and 0.78, respectively, using the DLR (German Aerospace Center) in-house code turbulent heat release extension of the tau code (theta) with the k–ω shear stress transport turbulence model and the DRM22 (Kazakov and Frenklach, 1995, “DRM22,” University of California at Berkeley, Berkeley, CA, accessed Sept. 21, 2017, http://www.me.berkeley.edu/drm/) detailed reaction mechanism. The numerical results showed a strong influence of the recirculation zones on the PS reaction zone.

Experimental and numerical study of flame structure and emissions in a micro gas turbine combustor

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Vedant Dwivedi ◽  
Srikanth Hari ◽  
S. M. Kumaran ◽  
B. V. S. S. S. Prasad ◽  
Vasudevan Raghavan
Keyword(s):  
Gas Turbine ◽  
Rural Areas ◽  
Gas Turbines ◽  
Alternative Fuels ◽  
Numerical Study ◽  
Operating Conditions ◽  
Emission Characteristics ◽  
Nitric Oxides ◽  
Gas Turbine Combustor ◽  
Micro Gas Turbine

Abstract Experimental and numerical study of flame and emission characteristics in a tubular micro gas turbine combustor is reported. Micro gas turbines are used for distributed power (DP) generation using alternative fuels in rural areas. The combustion and emission characteristics from the combustor have to be studied for proper design using different fuel types. In this study methane, representing fossil natural gas, and biogas, a renewable fuel that is a mixture of methane and carbon-dioxide, are used. Primary air flow (with swirl component) and secondary aeration have been varied. Experiments have been conducted to measure the exit temperatures. Turbulent reactive flow model is used to simulate the methane and biogas flames. Numerical results are validated against the experimental data. Parametric studies to reveal the effects of primary flow, secondary flow and swirl have been conducted and results are systematically presented. An analysis of nitric-oxides emission for different fuels and operating conditions has been presented subsequently.

scholarly journals Experimental Investigation of A Twin Shaft Micro Gas-Turbine System

2013 ◽  
Vol 16 ◽  
pp. 012011
Author(s):  
Hussain Sadig ◽  
Shaharin Anwar Sulaiman ◽  
Idris Ibrahim
Keyword(s):  
Experimental Investigation ◽  
Gas Turbine ◽  
Micro Gas Turbine

scholarly journals An experimental investigation on the maximum loading of a practical gas turbine combustor.

1986 ◽  
Vol 52 (478) ◽  
pp. 2482-2486
Author(s):  
Takasi TAMARU ◽  
Kazuo SIMODAIRA ◽  
Yoji KUROSAWA ◽  
Hidesi YAMADA ◽  
Tosiyuki KUYAMA
Keyword(s):  
Experimental Investigation ◽  
Gas Turbine ◽  
Gas Turbine Combustor ◽  
Maximum Loading
Sign in / Sign up

Export Citation Format

Share Document