scholarly journals Changes in Electrical Conductance of Polymer Composites Melts Due to Carbon Nanofiller Particles Migration

Polymers ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 1030
Author(s):  
Oleg V. Lebedev ◽  
Galina P. Goncharuk ◽  
Alexander N. Ozerin
Keyword(s):  
Surface Layer ◽  
Electrical Conductance ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Different Types ◽  
Time Dependencies ◽  
Conductance Increase ◽  
Distribution Transformation ◽  
Carbon Nanofiller ◽  
Filler Distribution

In this work, the results of investigation of the effect of polymer composite melts electrical conductance increase with time are presented. The conductance time dependencies were obtained for composites based on polypropylene filled with carbon nanoparticles of different types. The dependencies were analyzed to demonstrate the possibility of correlation of the conductance kinetics with different composite parameters, such as the filler geometry. Additional studies were carried out, such as electron microscopy study, conductance measurements after consecutive surface layer removal, and composite melt conductance measurements using a three-electrode scheme. The results showed that the increased electrical conductance of the composite materials can be attributed to the formation of an enriched with the filler particles surface layer, which happens during the stay of the composite in a melt state. Analysis of the experimental data, along with the results of numerical modeling, allowed to suggest a possible filler distribution transformation scheme. The physical premises behind the investigated effect are discussed.

Adaptation for Carnivory in the West Australian pitcher plant Cephalotus follicularis Labill

1984 ◽  
Vol 32 (6) ◽  
pp. 595 ◽  
Author(s):  
DM Parkes ◽  
ND Hallam
Keyword(s):  
Cell Types ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
The West ◽  
Pitcher Plant ◽  
Mesophyll Cells ◽  
Surface Microtopography ◽  
Transmission Electron ◽  
Different Types ◽  
Gland Tissue

The West Australian pitcher plant Cephalotus follicularis has adaptive structures for carnivory including modified leaves as pitfall containers, specialized surface microtopography to reduce adhesion of insect footpads and the development of gland tissue that secretes digestive enzymes. Gland masses on the lateral pitcher walls are made up of unspecialized mesophyll cells supporting two different types of gland. Cephalotus is geographically and taxonomically isolated from other pitcher plants. A detailed scanning electron and transmission electron microscopy study of the cell types within the pitchers of Cephalotus was carried out and the evolutionary and taxonomic significance of its adaptions to carnivory are discussed.

A High Voltage Electron Microscopy Study of Sub-Oxide Formation in Vanadium

1971 ◽  
Vol 29 ◽  
pp. 212-213
Author(s):  
R. H. Geiss ◽  
R. L. Ladd ◽  
K. R. Lawless
Keyword(s):  
High Vacuum ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Ultra High Vacuum ◽  
Pure Oxygen ◽  
Pressure Oxidation ◽  
High Voltage Electron Microscopy ◽  
Oxidation Study ◽  
Voltage Electron ◽  
Good Agreement

Detailed electron microscope and diffraction studies of the sub-oxides of vanadium have been reported by Cambini and co-workers, and an oxidation study, possibly complicated by carbon and/or nitrogen, has been published by Edington and Smallman. The results reported by these different authors are not in good agreement. For this study, high purity polycrystalline vanadium samples were electrochemically thinned in a dual jet polisher using a solution of 20% H2SO4, 80% CH3OH, and then oxidized in an ion-pumped ultra-high vacuum reactor system using spectroscopically pure oxygen. Samples were oxidized at 350°C and 100μ oxygen pressure for periods of 30,60,90 and 160 minutes. Since our primary interest is in the mechanism of the low pressure oxidation process, the oxidized samples were cooled rapidly and not homogenized. The specimens were then examined in the HVEM at voltages up to 500 kV, the higher voltages being necessary to examine thick sections for which the oxidation behavior was more characteristic of the bulk.

Factors influencing adhesive bonding at the bone/implant interface

1992 ◽  
Vol 50 (2) ◽  
pp. 1114-1115
Author(s):  
Julie A. Martini ◽  
Robert H. Doremus
Keyword(s):  
Electron Microscopy ◽  
Adhesive Bonding ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Bone Implant ◽  
Factors Influencing ◽  
Lr White ◽  
Transmission Electron ◽  
New Zealand White Rabbits ◽  
Scanning Electron

Tracy and Doremus have demonstrated chemical bonding between bone and hydroxylapatite with transmission electron microscopy. Now researchers ponder how to improve upon this bond in turn improving the life expectancy and biocompatibility of implantable orthopedic devices.This report focuses on a study of the- chemical influences on the interfacial integrity and strength. Pure hydroxylapatite (HAP), magnesium doped HAP, strontium doped HAP, bioglass and medical grade titanium cylinders were implanted into the tibial cortices of New Zealand white rabbits. After 12 weeks, the implants were retrieved for a scanning electron microscopy study coupled with energy dispersive spectroscopy.Following sacrifice and careful retrieval, the samples were dehydrated through a graduated series starting with 50% ethanol and continuing through 60, 70, 80, 90, 95, and 100% ethanol over a period of two days. The samples were embedded in LR White. Again a graduated series was used with solutions of 50, 75 and 100% LR White diluted in ethanol.

Electron microscopy study of reactively sputter-deposited Ti/N films on silicon

1992 ◽  
Vol 50 (2) ◽  
pp. 1362-1363
Author(s):  
V. C. Kannan ◽  
A. K. Singh ◽  
R. B. Irwin ◽  
S. Chittipeddi ◽  
F. D. Nkansah ◽  
...  
Keyword(s):  
Integrated Circuits ◽  
Large Scale ◽  
Hexagonal Phase ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Process Conditions ◽  
Tin Films ◽  
Wide Range ◽  
Fcc Phase ◽  
Circuits Vlsi

Titanium nitride (TiN) films have historically been used as diffusion barrier between silicon and aluminum, as an adhesion layer for tungsten deposition and as an interconnect material etc. Recently, the role of TiN films as contact barriers in very large scale silicon integrated circuits (VLSI) has been extensively studied. TiN films have resistivities on the order of 20μ Ω-cm which is much lower than that of titanium (nearly 66μ Ω-cm). Deposited TiN films show resistivities which vary from 20 to 100μ Ω-cm depending upon the type of deposition and process conditions. TiNx is known to have a NaCl type crystal structure for a wide range of compositions. Change in color from metallic luster to gold reflects the stabilization of the TiNx (FCC) phase over the close packed Ti(N) hexagonal phase. It was found that TiN (1:1) ideal composition with the FCC (NaCl-type) structure gives the best electrical property.

Analytical Electron Microscopy Study of Second-Phase Particles in 7075 and 7475 Aluminum Alloys

1985 ◽  
Vol 43 ◽  
pp. 348-349
Author(s):  
M. Raghavan ◽  
J. Y. Koo ◽  
J. W. Steeds ◽  
B. K. Park
Keyword(s):  
Aluminum Alloys ◽  
Silicon Oxide ◽  
Analytical Electron Microscopy ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Partial Substitution ◽  
Second Phase ◽  
X Ray ◽  
Second Phase Particles ◽  
Almost All

X-ray microanalysis and Convergent Beam Electron Diffraction (CBD) studies were conducted to characterize the second phase particles in two commercial aluminum alloys -- 7075 and 7475. The second phase particles studied were large (approximately 2-5μm) constituent phases and relatively fine ( ∼ 0.05-1μn) dispersoid particles, Figures 1A and B. Based on the crystal structure and chemical composition analyses, the constituent phases found in these alloys were identified to be Al7Cu2Fe, (Al,Cu)6(Fe,Cu), α-Al12Fe3Si, Mg2Si, amorphous silicon oxide and the modified 6Fe compounds, in decreasing order of abundance. The results of quantitative X-ray microanalysis of all the constituent phases are listed in Table I. The data show that, in almost all the phases, partial substitution of alloying elements occurred resulting in small deviations from the published stoichiometric compositions of the binary and ternary compounds.

Electron microscopy study of shock synthesis of silicides

1993 ◽  
Vol 51 ◽  
pp. 1162-1163
Author(s):  
Kenneth S. Vecchio
Keyword(s):  
Shock Wave ◽  
Plastic Deformation ◽  
Close Contact ◽  
Microscopy Study ◽  
High Energy ◽  
Electron Microscopy Study ◽  
Powder Materials ◽  
Porous Powder ◽  
Wave Effects ◽  
Wave Passage

Shock-induced reactions (or shock synthesis) have been studied since the 1960’s but are still poorly understood, partly due to the fact that the reaction kinetics are very fast making experimental analysis of the reaction difficult. Shock synthesis is closely related to combustion synthesis, and occurs in the same systems that undergo exothermic gasless combustion reactions. The thermite reaction (Fe2O3 + 2Al -> 2Fe + Al2O3) is prototypical of this class of reactions. The effects of shock-wave passage through porous (powder) materials are complex, because intense and non-uniform plastic deformation is coupled with the shock-wave effects. Thus, the particle interiors experience primarily the effects of shock waves, while the surfaces undergo intense plastic deformation which can often result in interfacial melting. Shock synthesis of compounds from powders is triggered by the extraordinarily high energy deposition rate at the surfaces of the powders, forcing them in close contact, activating them by introducing defects, and heating them close to or even above their melting temperatures.

Transmission Electron Microscopy study of Bi-based superconducting phases

1990 ◽  
Vol 48 (4) ◽  
pp. 50-51
Author(s):  
J.G. Wen ◽  
K.K. Fung
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Single Crystals ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Space Groups ◽  
Superconducting Phases ◽  
Ceramic Samples ◽  
Transmission Electron ◽  
Modulated Structures

Bi-based superconducting phases have been found to be members of a structural series represented by Bi2Sr2Can−1Cun−1On+4, n=1,2,3, and are referred to as 2201, 2212, 2223 phases. All these phases are incommensurate modulated structures. The super space groups are P2/b, NBbmb 2201, 2212 phases respectively. Pb-doped ceramic samples and single crystals and Y-doped single crystals have been studied by transmission electron microscopy.Modulated structures of all Bi-based superconducting phases are in b-c plane, therefore, it is the best way to determine modulated structure and c parameter in diffraction pattern. FIG. 1,2,3 show diffraction patterns of three kinds of modulations in Pb-doped ceramic samples. Energy dispersive X-ray analysis (EDAX) confirms the presence of Pb in the three modulated structures. Parameters c are 3 0.06, 38.29, 30.24Å, ie 2212, 2223, 2212 phases for FIG. 1,2,3 respectively. Their average space groups are all Bbmb.

Cytological changes induced by platinum-thymine in sarcoma-180 cells: Electron microscopy study

1990 ◽  
Vol 48 (3) ◽  
pp. 290-291
Author(s):  
Gustav Ofosu
Keyword(s):  
Mammalian Cells ◽  
Antitumor Agent ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Limiting Factor ◽  
Sarcoma 180 ◽  
Electron Microscopic ◽  
Cytological Changes

Platinum-thymine has been found to be a potent antitumor agent, which is quite soluble in water, and lack nephrotoxicity as the dose-limiting factor. The drug has been shown to interact with DNA and inhibits DNA, RNA and protein synthesis in mammalian cells in vitro. This investigation was undertaken to elucidate the cytotoxic effects of piatinum-thymine on sarcoma-180 cells in vitro ultrastructurally, Sarcoma-180 tumor bearing mice were treated with intraperitoneal injection of platinum-thymine 40mg/kg. A concentration of 60μg/ml dose of platinum-thymine was used in in vitro experiments. Treatments were at varying time intervals of 3, 7 and 21 days for in vivo experiments, and 30, 60 and 120 min., 6, 12, and 24th in vitro. Controls were not treated with platinum-thymine.Electron microscopic analyses of the treated cells in vivo and in vitro showed drastic cytotoxic effect.

Electron microscopy study of microtexture in Cu-Al-Ni shape memory alloys processed by powder metallurgy

2003 ◽  
Vol 112 ◽  
pp. 615-618 ◽  
Author(s):  
P. P. Rodriguez ◽  
J. San Jean ◽  
A. Iza-Mendia ◽  
V. Recarte ◽  
J. J. Pérez-Landazabal ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Powder Metallurgy ◽  
Shape Memory Alloys ◽  
Shape Memory ◽  
Microscopy Study ◽  
Electron Microscopy Study
Sign in / Sign up

Export Citation Format

Share Document