scholarly journals Impact of salinity on the performance and microbial community of anaerobic ammonia oxidation (Anammox) using 16S rRNA High-throughput Sequencing technology

2017 ◽  
Vol 19 (3) ◽  
pp. 377-388 ◽  
Keyword(s):  
16S Rrna ◽  
High Throughput ◽  
Nitrogen Removal ◽  
High Throughput Sequencing ◽  
Community Dynamics ◽  
Removal Rate ◽  
System Response ◽  
Anammox Bacteria ◽  
Term Operation ◽  
Anammox Activity

Salinity is a key environmental factor for the successful application of anammox technology in wastewater treatment, because it impacts the activity and the community structure of anammox bacteria. In this study, the changes in activity and population shifts of an anammox system response to the elevated salt stress (0, 5, 10, 20, 30 and 40 g NaCl/L) were studied. The results show that the anammox reactor performed effectively even at 30 g NaCl/L salinity after an appropriate acclimatization. The nitrogen removal rate maintained at 0.28 g N L-1d-1 with the nitrogen removal efficiency of 76%, though the high environmental salinity might inhibit the anammox growth in the long-term operation. 16S rRNA high-throughput sequencing results revealed that Ca. Brocadia, Ca. Jettenia and Ca. Kuenenia were the dominant anammox bacteria at all salinities. Ca. Brocadia and Ca. Jettenia were quite sensitive to salinity, and 5 g NaCl/L dosing could cause a sharp decline in their abundance. Nevertheless, these three anammox genus finally survived in the system with a steady specific anammox activity of 0.13 g N g VSS-1d-1. Specially, a novel cluster, Brocadiaceae_unclassified, which possibly belongs to anammox bacteria, became the dominant genus at the salinity over 20 g NaCl/L and likely contributed partially to the nitrogen removals. Our findings elucidated the inherent link between community dynamics and anammox system performance and stability under salty environment, and proved that anammox technologies can be an effective technology for treatment of saline ammonia-rich wastewater.

scholarly journals Effects of biotin on promoting anammox bacterial activity

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Qinyu Li ◽  
Jinhui Chen ◽  
Guo-hua Liu ◽  
Xianglong Xu ◽  
Qian Zhang ◽  
...  
Keyword(s):  
Nitrogen Removal ◽  
Slow Growth ◽  
Wastewater Treatment Plants ◽  
Removal Rate ◽  
Bacterial Biomass ◽  
Anammox Bacteria ◽  
Ammonium Oxidation ◽  
Short Term ◽  
Anammox Activity ◽  
Total Nitrogen Removal

AbstractAnaerobic ammonium oxidation (anammox) bacteria significantly improve the efficiency and reduce cost of nitrogen removal in wastewater treatment plants. However, their slow growth and vulnerable activity limit the application of anammox technology. In this paper, the enhancement of biotin on the nitrogen removal activity of anammox bacteria in short-term batch experiments was studied. We found that biotin played a significant role in promoting anammox activity within a biotin concentration range of 0.1–1.5 mg/L. At a biotin concentration of 1.0 mg/L, the total nitrogen removal rate (NRR) increased by 112%, extracellular polymeric substance (EPS) secretion and heme production significantly improved, and anammox bacterial biomass increased to maximum levels. Moreover, the predominant genus of anammox bacteria was Candidatus Brocadia.

scholarly journals Nitrogen removal using an anammox membrane bioreactor at low temperature

2015 ◽  
Vol 72 (12) ◽  
pp. 2148-2153 ◽  
Author(s):  
Takanori Awata ◽  
Yumiko Goto ◽  
Tomonori Kindaichi ◽  
Noriatsu Ozaki ◽  
Akiyoshi Ohashi
Keyword(s):  
Low Temperature ◽  
Nitrogen Removal ◽  
Membrane Bioreactor ◽  
Membrane Bioreactors ◽  
Distinct Advantage ◽  
Anammox Bacteria ◽  
Short Term ◽  
Term Operation ◽  
Anammox Activity

Membrane bioreactors (MBRs) have the ability to completely retain biomass and are thus suitable for slowly growing anammox bacteria. In the present study, an anammox MBR was operated to investigate whether the anammox activity would remain stable at low temperature, without anammox biomass washout. The maximum nitrogen removal rates were 6.7 and 1.1 g-N L−1 day−1 at 35 °C and 15 °C, respectively. Fluorescence in situ hybridization and 16S rRNA-based phylogenetic analysis revealed no change in the predominant anammox species with temperature because of the complete retention of anammox biomass in the MBR. These results indicate that the predominant anammox bacteria in the MBR cannot adapt to a low temperature during short-term operation. Conversely, anammox activity recovered rapidly after restoring the temperature from the lower value to the optimal temperature (35 °C). The rapid recovery of anammox activity is a distinct advantage of using an MBR anammox reactor.

scholarly journals Application of combined process of partial nitritation - anammox using a rotating biological contactor (PARBC) to treat ammonium-rich wastewater

2016 ◽  
Vol 19 (4) ◽  
pp. 5-16
Author(s):  
Hien Nhu Nguyen ◽  
Van Thi Thanh Truong ◽  
Son Thanh Le ◽  
Nhat The Phan ◽  
Dan Phuoc Nguyen
Keyword(s):  
Nitrogen Removal ◽  
Removal Rate ◽  
Synthetic Wastewater ◽  
Anammox Bacteria ◽  
Rotating Biological Contactor ◽  
Combined Process ◽  
Partial Nitritation ◽  
Anammox Activity ◽  
Startup Time ◽  
Autotrophic Nitrogen Removal

Combining the partial Nitritation and Anammox using a rotating biological contactor (PARBC) to remove the ammonium in wastewater was evaluated in this study. The accumulation of Anammox bacteria on the carrier easily obtained after 5 days operating of sequence batch with synthetic wastewater. Then AOB biomass cultivated in PARBC to complete the process of combining two bacteria in the same reactor for completely autotrophic nitrogen removal. After 60 batches of the operation, highest nitrogen removal rate reached 0.33 kg N/m3.d with nitrogen removal efficiency is 90% at a concentration of ammonium input of 250 mg N/L. The specific Anammox activity (SAA) of biofilm and suspended sludge in the tank is determined to be 0.298 gN-N2/gVSS/day and 0.0041 gN-N2/gVSS/day, respectively. Moreover, the suspended sludge concentration is 17.765 mg MLSS/L. This result showed that Anammox bacteria adapt and grow on the rotating biological carrier; otherwise Anammox bacteria hardly develop in the form of suspended sludge in the tank. This study shows that the PARBCR has great potential to effectively removing ammonium from wastewater with the short startup time.

scholarly journals Influence of temperature and salinity on microbial structure of marine anammox bacteria

2012 ◽  
Vol 66 (5) ◽  
pp. 958-964 ◽  
Author(s):  
Takanori Awata ◽  
Katsuichiro Tanabe ◽  
Tomonori Kindaichi ◽  
Noriatsu Ozaki ◽  
Akiyoshi Ohashi
Keyword(s):  
Nitrogen Removal ◽  
Removal Rate ◽  
Fixed Bed ◽  
Optimal Growth ◽  
Growth Conditions ◽  
Anammox Bacteria ◽  
Ammonium Oxidation ◽  
Influence Of Temperature ◽  
Anammox Activity

Anaerobic ammonium oxidation (anammox) is a type of biological oxidation mediated by a group of Planctomycete-like bacteria. Members of the genus Candidatus Scalindua are mainly found in marine environments, but not exclusively. This group is cultured using different inoculums and conditions; however, its optimal growth conditions are not clear. Additionally, little information is known about the factors that influence the activity and the selection of a population of marine anammox bacteria. This study was conducted to investigate the influence of temperature and salinity on the marine anammox community. To accomplish this, an up-flow fixed-bed column reactor was operated, and quantitative fluorescence in situ hybridization (FISH) with probes specific to dominant marine anammox bacteria was conducted. Anammox activity was observed at 20 and 30 °C, but not at 10 °C. A nitrogen removal rate of 0.32 kg TN m–3 day–1 was obtained at 20 °C. These results suggest that temperature affects the activity (nitrogen removal rate) of anammox bacteria, while salinity does not affect the activity in the marine anammox biofilm.

scholarly journals In Situ Water Quality Improvement Mechanism (Nitrogen Removal) by Water-Lifting Aerators in a Drinking Water Reservoir

Water ◽  
2018 ◽  
Vol 10 (8) ◽  
pp. 1051 ◽  
Author(s):  
Zizhen Zhou ◽  
Tinglin Huang ◽  
Weijin Gong ◽  
Yang Li ◽  
Yue Liu ◽  
...  
Keyword(s):  
Drinking Water ◽  
Nitrogen Removal ◽  
High Throughput Sequencing ◽  
Removal Rate ◽  
Water Reservoir ◽  
Control Area ◽  
Nitrite Accumulation ◽  
Field Scale ◽  
Drinking Water Reservoir ◽  
N Removal

A field scale experiment was performed to explore the nitrogen removal performance of the water and surface sediment in a deep canyon-shaped drinking water reservoir by operating WLAs (water-lifting aerators). Nitrogen removal performance was achieved by increasing the densities and N-removal genes (nirK and nirS) of indigenous aerobic denitrifiers. After the operation of WLAs, the total nitrogen removal rate reached 29.1 ± 0.8% in the enhanced area. Ammonia and nitrate concentrations were reduced by 72.5 ± 2.5% and 40.5 ± 2.1%, respectively. No nitrite accumulation was observed. Biolog results showed improvement of carbon metabolism and carbon source utilization of microbes in the enhanced area. Miseq high-throughput sequencing indicated that the denitrifying bacteria percentage was also higher in the enhanced area than that in the control area. Microbial communities had changed between the enhanced and control areas. Thus, nitrogen removal through enhanced indigenous aerobic denitrifiers by the operation of WLAs was feasible and successful at the field scale.

Sign in / Sign up

Export Citation Format

Share Document