scholarly journals Leading-Edge Vortex Structure of Nonslender Delta Wings at Low Reynolds Number

AIAA Journal ◽  
2003 ◽  
Vol 41 (1) ◽  
pp. 16-26 ◽  
Author(s):  
Michael V. Ol ◽  
Morteza Gharib
Keyword(s):  
Reynolds Number ◽  
Vortex Structure ◽  
Low Reynolds Number ◽  
Leading Edge ◽  
Delta Wings ◽  
Leading Edge Vortex ◽  
Edge Vortex ◽  
Low Reynolds

scholarly journals The leading-edge vortex of swift wing-shaped delta wings

2017 ◽  
Vol 4 (8) ◽  
pp. 170077 ◽  
Author(s):  
Rowan Eveline Muir ◽  
Abel Arredondo-Galeana ◽  
Ignazio Maria Viola
Keyword(s):  
Reynolds Number ◽  
Delta Wing ◽  
Leading Edge ◽  
Trailing Edge ◽  
Delta Wings ◽  
Leading Edge Vortex ◽  
Wing Model ◽  
Image Velocimetry ◽  
Edge Vortex ◽  
First Time

Recent investigations on the aerodynamics of natural fliers have illuminated the significance of the leading-edge vortex (LEV) for lift generation in a variety of flight conditions. A well-documented example of an LEV is that generated by aircraft with highly swept, delta-shaped wings. While the wing aerodynamics of a manoeuvring aircraft, a bird gliding and a bird in flapping flight vary significantly, it is believed that this existing knowledge can serve to add understanding to the complex aerodynamics of natural fliers. In this investigation, a model non-slender delta-shaped wing with a sharp leading edge is tested at low Reynolds number, along with a delta wing of the same design, but with a modified trailing edge inspired by the wing of a common swift Apus apus . The effect of the tapering swift wing on LEV development and stability is compared with the flow structure over the unmodified delta wing model through particle image velocimetry. For the first time, a leading-edge vortex system consisting of a dual or triple LEV is recorded on a swift wing-shaped delta wing, where such a system is found across all tested conditions. It is shown that the spanwise location of LEV breakdown is governed by the local chord rather than Reynolds number or angle of attack. These findings suggest that the trailing-edge geometry of the swift wing alone does not prevent the common swift from generating an LEV system comparable with that of a delta-shaped wing.

scholarly journals Surging and plunging oscillations of an airfoil at low Reynolds number

2014 ◽  
Vol 763 ◽  
pp. 237-253 ◽  
Author(s):  
Jeesoon Choi ◽  
Tim Colonius ◽  
David R. Williams
Keyword(s):  
Reynolds Number ◽  
Low Reynolds Number ◽  
Leading Edge ◽  
Unsteady Motion ◽  
Flow Structures ◽  
Wake Instability ◽  
Edge Vortex ◽  
Vortex Shedding Frequency ◽  
The Mean ◽  
Low Reynolds

AbstractWe investigate the forces and unsteady flow structures associated with harmonic oscillations of an airfoil in the streamwise (surging) and transverse (plunging) directions in two-dimensional simulations at low Reynolds number. For the surging case, we show that there are specific frequencies where the wake instability synchronizes with the unsteady motion of the airfoil, leading to significant changes in the mean forces. Resonant behaviour of the time-averaged forces is observed near the vortex shedding frequency and its subharmonic; the behaviour is reminiscent of the dynamics of the generic nonlinear oscillator known as the Arnol’d tongue or the resonance horn. Below the wake instability frequency, there are two regimes where the fluctuating forces are amplified and attenuated, respectively. A detailed study of the flow structures associated with leading-edge vortex (LEV) growth and detachment are used to relate this behaviour with the LEV acting either in phase with the quasi-steady component of the forces for the amplification case, or out of phase for the attenuation case. Comparisons with wind tunnel measurements show that phenomenologically similar dynamics occur at higher Reynolds number. Finally, we show that qualitatively similar phenomena occur during both surging and plunging.

Heat Transfer and Flowfield Measurements in the Leading Edge Region of a Stator Vane Endwall

1999 ◽  
Vol 121 (3) ◽  
pp. 558-568 ◽  
Author(s):  
M. B. Kang ◽  
A. Kohli ◽  
K. A. Thole
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Leading Edge ◽  
Reynolds Numbers ◽  
Secondary Flows ◽  
Edge Region ◽  
Leading Edge Vortex ◽  
Stator Vane ◽  
Edge Vortex ◽  
The Mean

The leading edge region of a first-stage stator vane experiences high heat transfer rates, especially near the endwall, making it very important to get a better understanding of the formation of the leading edge vortex. In order to improve numerical predictions of the complex endwall flow, benchmark quality experimental data are required. To this purpose, this study documents the endwall heat transfer and static pressure coefficient distribution of a modern stator vane for two different exit Reynolds numbers (Reex = 6 × 105 and 1.2 × 106). In addition, laser-Doppler velocimeter measurements of all three components of the mean and fluctuating velocities are presented for a plane in the leading edge region. Results indicate that the endwall heat transfer, pressure distribution, and flowfield characteristics change with Reynolds number. The endwall pressure distributions show that lower pressure coefficients occur at higher Reynolds numbers due to secondary flows. The stronger secondary flows cause enhanced heat transfer near the trailing edge of the vane at the higher Reynolds number. On the other hand, the mean velocity, turbulent kinetic energy, and vorticity results indicate that leading edge vortex is stronger and more turbulent at the lower Reynolds number. The Reynolds number also has an effect on the location of the separation point, which moves closer to the stator vane at lower Reynolds numbers.

scholarly journals The leading-edge vortex on a rotating wing changes markedly beyond a certain central body size

2018 ◽  
Vol 5 (7) ◽  
pp. 172197 ◽  
Author(s):  
Shantanu S. Bhat ◽  
Jisheng Zhao ◽  
John Sheridan ◽  
Kerry Hourigan ◽  
Mark C. Thompson
Keyword(s):  
Reynolds Number ◽  
Body Size ◽  
Central Body ◽  
Three Dimensional ◽  
Leading Edge ◽  
Particle Image Velocimetry Technique ◽  
Leading Edge Vortex ◽  
Rapid Acquisition ◽  
Edge Vortex ◽  
Rotating Wing

Stable attachment of a leading-edge vortex (LEV) plays a key role in generating the high lift on rotating wings with a central body. The central body size can affect the LEV structure broadly in two ways. First, an overall change in the size changes the Reynolds number, which is known to have an influence on the LEV structure. Second, it may affect the Coriolis acceleration acting across the wing, depending on the wing-offset from the axis of rotation. To investigate this, the effects of Reynolds number and the wing-offset are independently studied for a rotating wing. The three-dimensional LEV structure is mapped using a scanning particle image velocimetry technique. The rapid acquisition of images and their correlation are carefully validated. The results presented in this paper show that the LEV structure changes mainly with the Reynolds number. The LEV-split is found to be only minimally affected by changing the central body radius in the range of small offsets, which interestingly includes the range for most insects. However, beyond this small offset range, the LEV-split is found to change dramatically.

Sign in / Sign up

Export Citation Format

Share Document