New Pair of Leading-Edge Vortex Structure for Flow over Delta Wing

2005 ◽  
Vol 42 (3) ◽  
pp. 718-721 ◽  
Author(s):  
Jinjun Wang ◽  
Jingxia Zhan
Keyword(s):  
Vortex Structure ◽  
Delta Wing ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

Parametric Investigations of the Leading Edge Vortex on a Delta Wing

2011 ◽  
Author(s):  
Christoph Strangfeld ◽  
Lutz Taubert ◽  
C. Nayeri ◽  
Christian Paschereit
Keyword(s):  
Delta Wing ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

Leading-edge vortex behavior in the vicinity of delta wing apex

1996 ◽  
Author(s):  
Gregory Addington ◽  
Ernest Hanff ◽  
Robert Nelson
Keyword(s):  
Delta Wing ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

scholarly journals Effects of the Propeller Advance Ratio on Delta Wing UAV Leading Edge Vortex

2019 ◽  
Vol 16 (3) ◽  
pp. 6958-6970 ◽  
Author(s):  
K. A. Kasim ◽  
P. Segard ◽  
S. Mat ◽  
S. Mansor ◽  
M. N. Dahalan ◽  
...  
Keyword(s):  
Swirling Flow ◽  
Delta Wing ◽  
Active Flow Control ◽  
Pressure Coefficient ◽  
Leading Edge ◽  
Adverse Pressure Gradient ◽  
Leading Edge Vortex ◽  
Wing Model ◽  
Edge Vortex ◽  
Advance Ratio

Delta wing is a triangular-shaped platform that can be applied into the unmanned aerial vehicle (UAV) or drone applications. However, the flow above the delta wing is governed by complex leading-edge vortex structures which result in complicated aerodynamics behaviour. At higher angles of attack, the vortex burst can take place when the swirling flow is unable to sustain the adverse pressure gradient. More studies are needed to understand these vortex phenomena. This paper addresses an experimental study of active flow control called propeller on a generic 55° swept angle sharp-edged delta wing model. In this experiment, a propeller was placed at two different locations. The first location was at the apex of the wing while the second position was at the rear of the wing. The experiments were conducted in a 1.5 × 2.0 m2 closed-loop wind tunnel facility at Universiti Teknologi Malaysia. The freestream velocities were set at 20 m/s and 25 m/s. The research consisted of an intensive surface pressure measurement above the wing surface to investigate the effects of rotating propeller towards the leading-edge vortex. The experiments were divided into four configurations. The clean wing configuration was performed without the propeller and followed by pusher-propeller configuration using 10-inch 9-inch propellers. The final configuration was the tractor-propeller with a 10-inch propeller. The results emphasise the influences of the propeller size and its location corresponding to vortex properties above the delta-winged UAV model. The findings had indicated that the vortex peak is increased when the propeller is installed for both pusher and tractor configurations. The results also indicate that the pressure coefficient is increased when the propeller advance ratio increases. 

Characterization of a Three-Dimensional Leading-Edge Separation Bubble on Swept, Low Aspect-Ratio Propeller Blades

2017 ◽  
Author(s):  
Ye-Bonne Koyama Maldonado ◽  
Gregory Delattre ◽  
Cedric Illoul ◽  
Clement Dejeu ◽  
Laurent Jacquin
Keyword(s):  
Delta Wing ◽  
Separation Bubble ◽  
Three Dimensional ◽  
Leading Edge ◽  
Time Resolved ◽  
Leading Edge Vortex ◽  
Wall Structures ◽  
Edge Vortex ◽  
Propeller Blades ◽  
Leading Edge Vortices

Leading-edge vortex flows are often present on propeller blades at take-off, however, their characteristics and aerodynamic impact are still not fully understood. An experimental investigation using Time Resolved Particle Image Velocimetry (TR-PIV) has been performed on a model blade in order to classify this flow with respect to both delta wing leading-edge vortices and the low Reynolds number studies regarding leading-edge vortices on rotating blades. A numerical calculation of the experimental setup has been performed in order to assess usual numerical methods for propeller performance prediction against TR-PIV results. Similar characteristics were found with non slender delta wing vortices at low incidence, which hints that the leading-edge vortex flow may generate vortex lift. The influence of rotation on the characteristics of the leading-edge vortex is compared to that of the pressure gradient caused by the circulation distribution. A discussion on the quality of the PIV reconstruction for close-wall structures is provided.

scholarly journals Numerical Investigation of a Dynamic Stall on a Single Rotating Blade

Aerospace ◽  
2021 ◽  
Vol 8 (4) ◽  
pp. 90
Author(s):  
Yin Ruan ◽  
Manfred Hajek
Keyword(s):  
Numerical Investigation ◽  
Vortex Structure ◽  
Leading Edge ◽  
Rotor Blades ◽  
Tip Vortex ◽  
Dynamic Stall ◽  
Leading Edge Vortex ◽  
Pitching Airfoil ◽  
Edge Vortex ◽  
High Reynolds

Dynamic stall is a phenomenon on the retreating blade of a helicopter which can lead to excessive control loads. In order to understand dynamic stall and fill the gap between the investigations on pitching wings and full helicopter rotor blades, a numerical investigation of a single rotating and pitching blade is carried out. The flow phenomena thereupon including the Ω-shaped dynamic stall vortex, the interaction of the leading edge vortex with the tip vortex, and a newly noticed vortex structure originating inboard are examined; they show similarities to pitching wings, while also possessing their unique features of a rotating system. The leading edge/tip vortex interaction dominates the post-stall stage. A newly noticed swell structure is observed to have a great impact on the load in the post-stall stage. With such a high Reynolds number, the Coriolis force exerted on the leading edge vortex is negligible compared to the pressure force. The force history/vortex structure of the slice r/R = 0.898 is compared with a 2D pitching airfoil with the same harmonic pitch motion, and the current simulation shows the important role played by the swell structure in the recovery stage.

Sign in / Sign up

Export Citation Format

Share Document