scholarly journals Photoacoustic properties of single crystal PbTe(Ni)

2007 ◽  
Vol 39 (2) ◽  
pp. 161-167 ◽  
Author(s):  
D. Lukovic ◽  
P.M. Nikolic ◽  
S. Vujatovic ◽  
S. Savic ◽  
D. Urosevic
Keyword(s):  
Thermal Diffusivity ◽  
Sodium Chloride ◽  
Single Crystal ◽  
Transport Parameters ◽  
Cubic Lattice ◽  
Free Carriers ◽  
Thermal Difusivity ◽  
Bridgeman Method ◽  
Set Up ◽  
Pure Single Crystal

Single crystals of PbTe(Ni) were investigated by the photoacoustic method. They were produced using the Bridgeman method. These crystals have a sodium chloride cubic lattice and could be cleaved paralel to the plane orientation (200). They were of the n-type. Phase and amplitude photoacoustic spectra were measured using a transmision detection configuration set-up. Photoacoustic (PA) spectra (single and normalized) were numerically analyzed using the Rosencwaig-Gersho model. Thermal diffusivity and some electron-transport parameters were determined. These results were compared with existing results for pure single crystal PbTe. Thermal difusivity of PbTe(Ni) is a bit higher than the thermal difusivity of pure PbTe. This is the consequence of a decreasing concentration of the majority free carriers in the doped alloy. .

STUDY OF THERMAL TRANSPORT PARAMETERS IN PbI2 SINGLE CRYSTAL USING A PHOTOACOUSTIC TECHNIQUE

2006 ◽  
Vol 20 (20) ◽  
pp. 1253-1260 ◽  
Author(s):  
D. S. AHLAWAT ◽  
D. MOHAN ◽  
S. K. GHOSHAL ◽  
R. D. SINGH ◽  
MEENAKSHI SHARMA
Keyword(s):  
Thermal Conductivity ◽  
Thermal Diffusivity ◽  
Single Crystal ◽  
Characteristic Frequency ◽  
Modulation Frequency ◽  
Thermal Effusivity ◽  
Photoacoustic Signal ◽  
Photoacoustic Technique ◽  
Front Side ◽  
Transport Parameters

The present work discusses the study of the transport properties of the PbI 2 single crystal using an indigenously developed photoacoutistic spectrometer. The amplitude photoacoustic signal, being a function of the modulation frequency of the incident optical beam, has been measured by using the front-side detection configuration. The characteristic frequency (fc) of the single crystal has been found to be 55 Hz. The values of thermal diffusivity, thermal conductivity and thermal effusivity in the case of PbI 2 have been derived experimentally. Their values have been compared with the values reported in a case which studied other materials in the literature. Thermal diffusion lengths have also been calculated at different chopping frequencies from 15 Hz to 90 Hz.

scholarly journals Detrapping and retrapping of free carriers in nominally pure single crystal GaP, GaAs, and 4H–SiC semiconductors under light illumination at cryogenic temperatures

2010 ◽  
Vol 108 (10) ◽  
pp. 104107 ◽  
Author(s):  
David Mouneyrac ◽  
John G. Hartnett ◽  
Jean-Michel Le Floch ◽  
Michael E. Tobar ◽  
Dominique Cros ◽  
...  
Keyword(s):  
Single Crystal ◽  
Light Illumination ◽  
Cryogenic Temperatures ◽  
Free Carriers ◽  
Pure Single Crystal

Extra-Column Effects in Determination of Rate Parameters by the Chromatographic Method

1996 ◽  
Vol 61 (6) ◽  
pp. 844-855 ◽  
Author(s):  
Olga Šolcová ◽  
Petr Schneider
Keyword(s):  
Chromatographic Method ◽  
Dynamic Method ◽  
Axial Dispersion ◽  
Transport Parameters ◽  
Porous Particles ◽  
Loop Detector ◽  
Single Pellet ◽  
Set Up ◽  
Extra Column Effects

It was shown that the sampling loop, detector and connecting elements in the chromatographic set-up for determination of transport parameters by the dynamic method significantly influence the response peaks from columns packed with porous or nonporous particles. A method, based on the use of convolution theorem, was developed which can take these effects into account. The applicability of this method was demonstrated on the case of axial dispersion in a single-pellet-string column (SPSR) packed with nonporous particles. It is possible to handle also responses from columns packed with porous particles by a similar procedure.

scholarly journals Fast synthesis of large-scale single-crystal graphene with well-defined edges upon sodium chloride addition

Carbon ◽  
2020 ◽  
Vol 158 ◽  
pp. 904-911 ◽  
Author(s):  
Su Han Kim ◽  
Jie Jiang ◽  
Suhee Jang ◽  
Jae Hyung Lee ◽  
Dong Won Yang ◽  
...  
Keyword(s):  
Sodium Chloride ◽  
Single Crystal ◽  
Large Scale ◽  
Fast Synthesis

Condensation energies for metals on glass and other substrates

1959 ◽  
Vol 252 (1270) ◽  
pp. 418-430 ◽  
Keyword(s):  
Sodium Chloride ◽  
Single Crystal ◽  
Physical Adsorption ◽  
Van Der Waals ◽  
Van Der Waals Forces ◽  
Potassium Bromide ◽  
Binding Energies ◽  
Adhesive Energy ◽  
Good Agreement

Earlier work on condensation phenomena is briefly reviewed, and existing measurements of condensation energies are summarized. Measurements of condensation energies have been made for aluminium, silver and cadmium on glass and for aluminium and silver on single-crystal cleavage surfaces of sodium chloride and potassium bromide. Adhesive energies or binding energies between film and substrate have been calculated in each case. Association energies for nucleation are obtained by difference and shown to be consistent. Results for cadmium show good agreement with earlier work, but results for aluminium do not agree with the earlier results of Rhodin who measured the condensation energies for aluminium on various substrates, obtaining values which suggest chemisorption. These results appear to be too high and a possible explanation is given. It is concluded that the adhesive energy is due to physical adsorption and can be explained in terms of van der Waals forces only.

scholarly journals DETERMINATION OF TRANSPORT PARAMETERS FOR SOLUTES IN SALT-TREATED SOIL COLUMNS

2017 ◽  
Vol 48 (1) ◽  
Author(s):  
Bahia & Naser
Keyword(s):  
Sodium Chloride ◽  
Calcium Chloride ◽  
Peclet Number ◽  
Dispersion Coefficient ◽  
Breakthrough Curves ◽  
Retardation Factor ◽  
Transport Parameters ◽  
Péclet Number ◽  
Mixed Salts ◽  
Sodium And Potassium

A laboratory experiment was carried out at the Department of Soil Sciences and Water Resources, College of Agriculture, University of Baghdad. Silty clay soil was treated with three salt solutions (NaCl, CaCl2 and mixed NaCl–CaCl2). Homogeneously packed soil columns (10 cm, 40 cm) were leached six times using tap water. Effluent samples were collected to determine ion concentration Cl-, Ca++, Na+, K+ and Mg++. Breakthrough curves were used to estimate solute transport parameters (retardation factor, peclet number) using an analytical solution of convection-dispersion equation (CDE) by CXTFIT program. The results showed that relative concentration of chloride was increased rapidly with calcium chloride, which increased sodium leaching rate at starting of breakthrough curve. Sodium chloride increased water requirements for calcium displacement. Results indicated a good fitting of convection-dispersion equation with breakthrough curves data. The best-fit were used to calculate peclet number, retardation factor and dispersion coefficient. When soil was treated with calcium chloride, Peclet number of chloride was increased from 3.13 to 6.48, while it has been decreased for calcium, sodium and potassium. Sodium chloride decreased peclet numbers of chloride, calcium and sodium. Also mixed salts increased sodium peclet number from 1.01 to 9.02. Results showed, calcium chloride decreased retardation factor of chloride from 1.59 to 0.50, while it has been increased from 1.39, 1.58 to 175.00, 493.36 for each of sodium and potassium, respectively. Retardation factor of calcium was decreased when soil was treated with sodium chloride or mixed salts. Dispersion coefficient was decreased for chloride, and increased for calcium and magnesium. When soil was treated with calcium chloride, dispersion coefficients have been increased from 24.29, 25.56 to 40.51, 40.89 cm2hr-1 for sodium and potassium, respectively.

Sign in / Sign up

Export Citation Format

Share Document