scholarly journals Synthesis and characterization of multilayered BaTiO3/NiFe2O4 thin films

2013 ◽  
Vol 7 (1) ◽  
pp. 15-20 ◽  
Author(s):  
Branimir Bajac ◽  
Jelena Vukmirovic ◽  
Ivan Tokic ◽  
Stevan Ognjanovic ◽  
Vladimir Srdic
Keyword(s):  
Thin Films ◽  
Spin Coating ◽  
Film Growth ◽  
Perovskite Phase ◽  
Spinel Phase ◽  
Dip Coating ◽  
Growth From Solution ◽  
Deposition Techniques ◽  
Ferrite Spinel

Presented research was focused on the fabrication of multiferroic thin film structures, composed of ferrielectric barium titanate perovskite phase and magnetostrictive nickel ferrite spinel phase. The applicability of different, solution based, deposition techniques (film growth from solution, dip coating and spin coating) for the fabrication of multilayered BaTiO3 /NiFe2O4 thin films was investigated. It was shown that only spin coating produces films of desired nanostructure, thickness and smooth and crackfree surfaces.

Structural and Electrical Properties of Mn-Co-Ni-O Thin Films Prepared by Dip-Coating Technique

1992 ◽  
Vol 271 ◽  
Author(s):  
Shoji Kaneko ◽  
Naoto Mazuka ◽  
Tamotsu Yamada
Keyword(s):  
Thin Films ◽  
Spinel Phase ◽  
Dip Coating ◽  
Atomic Ratio ◽  
Heating Process ◽  
Electric Resistance ◽  
Glass Substrates ◽  
Methanol Solutions ◽  
Structural And Electrical Properties ◽  
Dip Coating Technique

ABSTRACTMn-Co-Ni-O thin films of metal atomic ratio 3.0 : 1.9 : 1.0 were prepared on glass substrates from methanol solutions of the corresponding metal β-diketonates by dip-coating. As-prepared films were heated at 900°C for 1 h mostly after being calcined at 450°C for 5 min. The film thickness increased with increasing concentration of the solution as well as the number of lifting times. However, the effect was not apparent with the sample prepared without calcination. The prepared films were observed to crystallize into a complicated spinel phase by the heating process at 900°C for 1 h. The surface of the dense film composed of particles of about 0.2 μm diameter, was almost even. The thermal and aging responses of electric resistance showed the film to be a good material as a thermistor.

Preparation and characterization of V2O5 doped SiO2-TiO2 thin films

2012 ◽  
Vol 2 (1) ◽  
Author(s):  
Marek Nocuń ◽  
Sławomir Kwaśny
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Photoelectron Spectroscopy ◽  
Sol Gel ◽  
Dip Coating ◽  
Band Gap Energy ◽  
Tio2 Thin Films ◽  
Glass Substrates ◽  
Gel Technique

AbstractIn our investigation, V doped SiO2/TiO2 thin films were prepared on glass substrates by dip coating sol-gel technique. Chemical composition of the samples was studied by X-ray photoelectron spectroscopy (XPS). Transmittance of the samples was characterized using UV-VIS spectrophotometry. Subsequently band-gap energy (Eg) was estimated for these films. Powders obtained from sols were characterized by FTIR spectroscopy. It was found that vanadium decreases optical band gap of SSiO2/TiO2 films.

Sol-gel synthesis and characterization of Ag nanoparticles in ZrO2 thin films

2009 ◽  
Vol 24 (8) ◽  
pp. 2541-2546 ◽  
Author(s):  
Eisuke Yokoyama ◽  
Hironobu Sakata ◽  
Moriaki Wakaki
Keyword(s):  
Thin Films ◽  
Sol Gel ◽  
Composite Films ◽  
Dip Coating ◽  
Molar Ratio ◽  
X Ray Diffraction ◽  
Silver Surface ◽  
Molar Ratios ◽  
Sol Gel Synthesis

ZrO2 thin films containing silver nanoparticles were prepared using the sol-gel method with Ag to Zr molar ratios [Ag]/[Zr] = 0.11, 0.25, 0.43, 0.67, 1.00, 1.50, and 2.33. After dip coating on glass substrate, coated films were annealed at 200 and 300 °C in air. X-ray diffraction peaks corresponding to crystalline Ag were observed, but a specific peak corresponding to ZrO2 was not observed. At the molar ratio [Ag]/[Zr] = 0.25, the particle size of Ag distributed broadly centered at 17 nm for an annealing temperature of 200 °C and at 25 nm for 300 °C. The films annealed in air at 200 °C showed an absorption band centered at 450 nm because of the silver surface plasmon resonance, whereas films heated at 300 °C in air caused a red shift of the absorption to 500 nm. The absorption peak was analyzed using the effective dielectric function of Ag-ZrO2 composite films modeled with the Maxwell-Garnett expression.

A Molecular Route to Dip-coated Transition Metal Nitride Thin Films.

2004 ◽  
Vol 848 ◽  
Author(s):  
Andrew W. Jackson ◽  
Andrew L. Hector
Keyword(s):  
Thin Films ◽  
Transition Metal ◽  
Spin Coating ◽  
Sol Gel ◽  
Particle Growth ◽  
Dip Coating ◽  
Stable Emulsion ◽  
Transition Metal Nitride ◽  
Sol Gel Synthesis ◽  
Gel Processing

ABSTRACTThere is an increasing interest in sol-gel synthesis of nitrides. The ability to deposit films of these materials by dip- or spin-coating will increase the range of applications in which they are viable and is an important step toward general sol-gel processing of nitride materials.With transition metals, the ammono based analogue of the well established alkoxy route to gels is inherently difficult to control. Due to the basicity of the system, the overwhelming tendency is of the starting materials to favour particle growth which results in a precipitate rather than a stable emulsion, unless both environment and synthetic pathway are carefully controlled. Hence reports to date of sol-gel routes to nitrides describe production of powders. We report work on a sol-gel route to titanium nitride with the ammonolysis of titanium amides controlled by temperature and chemical moderators, resulting in stable emulsions useful for dip-coating.

scholarly journals Deposition routes of Cs2AgBiBr6 double perovskites for photovoltaic applications

MRS Advances ◽  
2018 ◽  
Vol 3 (32) ◽  
pp. 1819-1823 ◽  
Author(s):  
Martina Pantaler ◽  
Christian Fettkenhauer ◽  
Hoang L. Nguyen ◽  
Irina Anusca ◽  
Doru C. Lupascu
Keyword(s):  
Thin Films ◽  
Spin Coating ◽  
Perovskite Phase ◽  
Perovskite Solar Cells ◽  
Double Perovskite ◽  
Double Perovskites ◽  
Sequential Deposition ◽  
Absorber Material ◽  
Photovoltaic Applications ◽  
Deposition Processes

ABSTRACTThe lead free double perovskite Cs2AgBiBr6 is an upcoming alternative to lead based perovskites as absorber material in perovskite solar cells. So far, the majority of investigations on this interesting material have focused on polycrystalline powders and single crystals. We present vapor and solution based approaches for the preparation of Cs2AgBiBr6 thin films. Sequential vapor deposition processes starting from different precursors are shown and their weaknesses are discussed. Single source evaporation of Cs2AgBiBr6 and sequential deposition of Cs3Bi2Br9 and AgBr result in the formation of the double perovskite phase. Additionally, we show the possibility of the preparation of planar Cs2AgBiBr6 thin films by spin coating.

Characterization of Mn doped ZnO wrinkle-network nanostructured thin films deposited by sol-gel spin coating technique

2019 ◽  
Author(s):  
Ashutosh Kumar Dikshit ◽  
Abhishek Kumar Singh ◽  
Kamal . ◽  
Yogendra Kumar Prajapati ◽  
Parthasarathi Chakrabarti
Keyword(s):  
Thin Films ◽  
Spin Coating ◽  
Sol Gel ◽  
Spin Coating Technique ◽  
Coating Technique ◽  
Nanostructured Thin Films ◽  
Doped Zno ◽  
Mn Doped
Sign in / Sign up

Export Citation Format

Share Document