Rapid Thermal Processing of Gate Dielectric Films and their Characterization

1987 ◽  
Vol 92 ◽  
Author(s):  
D. L. Flowers ◽  
J. Nulman ◽  
J. P. Krusius

ABSTRACTRapid thermal processing has been used to grow high quality, low defect density, low mobile charge, dielectric films of oxide and nitrided oxide. Suitable annealing can lower the fixed charge and interfacial trap density present in these filmsto acceptably low levels. Both RTA and RTN were shown to improve the dielectric properties of the grown oxides. These filmsshould be strong candidates for use in high density, shallow junction, integrated circuits where a minimal time/temperature constraint is imposed on further processing after diffusion.

1994 ◽  
Vol 342 ◽  
Author(s):  
Y. Ma ◽  
S.V. Hattangady ◽  
T. Yasuda ◽  
H. Niimi ◽  
S. Gandhi ◽  
...  

ABSTRACTWe have used a combination of plasma and rapid thermal processing for the formation of thin gate-dielectric films. The bulk dielectric films investigated include silicon oxide, oxynitride and multilayer oxide-nitride-oxide heterostructures formed by plasma-assisted oxidation, remoteplasma-enhanced chemical-vapor deposition (remote-PECVD) followed by post-deposition rapid thermal annealing (RTA). Auger electron spectroscopy (AES) and infrared absorption spectroscopy (IR) have been used to study the chemistry of interface formation and the bulk dielectric chemical bonding, respectively. Electrical characterization of MOS capacitor structures incorporating these dielectrics was performed by conventional capacitance and current voltage techniques, C-V and I-V, respectively.


1998 ◽  
Vol 525 ◽  
Author(s):  
John R. Hauser

ABSTRACTScaling of MOS devices is projected to continue down to device dimensions of at least 50 nm. However, there are many potential roadblocks to achieving such dimensions and many standard materials and front-end processes which must be significantly changed to achieve these goals. The most important areas for change include (a) gate dielectric materials, (b) gate contact material, (c) source/drain contacting structure and (d) fundamental bulk CMOS structure. These projected changes are reviewed along with possible applications of rapid thermal processing to achieving future nanometer scale MOS devices.


1995 ◽  
Vol 387 ◽  
Author(s):  
L. K. Han ◽  
M. Bhat ◽  
J. Yan ◽  
D. Wristers ◽  
D. L. Kwong

AbstractThis paper reports on the formation of high quality ultrathin oxynitride gate dielectric by in-situ rapid thermal multiprocessing. Four such gate dielectrics are discussed here; (i) in-situ NO-annealed SiO2, (ii) N2O- or NO- or O2-grown bottom oxide/RTCVD SiO2/thermal oxide, (iii) N2O-grown bottom oxide/Si3N4/N2O-oxide (ONO) and (iv) N2O-grown bottom oxide/RTCVD SiO2/N2O-oxide. Results show that capacitors with NO-based oxynitride gate dielectrics, stacked oxynitride gate dielectrics with varying quality of bottom oxide (O2/N2O/NO), and the ONO structures show high endurance to interface degradation, low defect-density and high charge-to-breakdown compared to thermal oxide. The N2O-last reoxidation step used in the stacked dielectrics and ONO structures is seen to suppress charge trapping and interface state generation under Fowler-Nordheim injection. The stacked oxynitride gate dielectrics also show excellent MOSFET performance in terms of transconductance and mobility. While the current drivability and mobilities are found to be comparable to thermal oxide for N-channel MOSFET's, the hot-carrier immunity of N-channel MOSFET's with the N2O-oxide/CVD-SiO2/N2O-oxide gate dielectrics is found to be significantly enhanced over that of conventional thermal oxide.


1993 ◽  
Vol 303 ◽  
Author(s):  
G. W. Yoon ◽  
A. B. Joshi ◽  
J. Kim ◽  
D. L. Kwong

ABSTRACTIn this paper, a detailed reliability investigation is presented for ultra-thin tunneling (∼50 Å) oxides grown in N2O ambient using rapid thermal processing (RTP). These N2Oss-oxides are compared with oxides of identical thickness grown in O2 ambient by RTP. The reliability investigations include time-dependent dielectric breakdown as well as stress-induced leakage current in MOS capacitors with these gate dielectrics. Results show that ultra-thin N2O-oxides show much improved reliability as compared to oxide grown in O2 ambient.


2001 ◽  
Vol 08 (05) ◽  
pp. 569-573
Author(s):  
R. LIU ◽  
K. H. KOA ◽  
A. T. S. WEE ◽  
W. H. LAI ◽  
M. F. LI ◽  
...  

As the gate dielectric for ULSI MOS devices scales in the ultrathin regime, it is fabricated increasingly with silicon oxynitride instead of silicon dioxide films. One way to obtain silicon oxynitride films is the rapid thermal oxidation of silicon in NO (RTNO). Earlier RTNO growth studies were not sufficiently comprehensive as well as limited by temperature uncertainty and nonuniformity across the wafer. Using a state-of-the-art rapid thermal processing (RTP) system, RTNO growth characteristics at oxidation pressures of 100 and 760 Torr, oxidation temperatures from 900 to 1200°C and oxidation times from 0 to 480 s were obtained and investigated. Anomalies in the growth characteristics were observed. It was also demonstrated that secondary ion mass spectrometry (SIMS) using the MCs + method could be used to accurately determine the depth distribution of N in ultrathin silicon oxynitride films.


Sign in / Sign up

Export Citation Format

Share Document