Low-Temperature Oxidation of Silicon(100) Substrates Using Atomic Oxygen

1999 ◽  
Vol 592 ◽  
Author(s):  
T. Ueno ◽  
S. Chikamura ◽  
F. Sakuraba ◽  
Y Iwasaki

ABSTRACTLow temperature oxidation process of Si(100) substrates using atomic oxygen has been proposed. For the generation of atomic oxygen, microwave plasma remotely attached on the oxidation chamber was used. In the microwave plasma, the large amount of rare gas and a small amount of 02 gas mixture was supplied. The existence of the large amount of rare gas controls the plasma energy to some restricted values associated with the metastable states of the rare gas. Consequently, using Kr as mixed rare gas, atomic oxygen were efficiently generated instead of excited 02 molecules with any vibrational or ionized states. The oxidation kinetics of crystalline Si using this process was shown to be diffusion limiting, even if the oxide thickness was less than several nm. The activation energy of B, which is referred to as the parabolic rate constant, was found to be as low as 0.14eV In addition, lower interface trap density of 2.6 × 1011/cm2/eV at the mid gap could be achieved for the as-grown SiO2/Si(100) interface at the processing temperature of 500C.

1996 ◽  
Vol 445 ◽  
Author(s):  
Soon-Jin Cho ◽  
Kyung-Wook Paik

AbstractLow temperature oxidation of a Cu-base leadframe has been investigated to understand the effect of Cu oxidation on the adhesion between Cu-base leadframes (Cu L/F) and epoxy molding compounds (EMC). From the kinetic studies on the oxidation, oxide growth was found to follow the parabolic rate law in the temperature range of 150 °C to 300 °C and the activation energy for the oxidation was 17.0 kcal/mol. X-ray photoelectron spectroscopy (XPS) studies confirmed that the oxide film consisted of Cu2O, CuO, and NiO. It was shown that the early stage of oxidation improved the adhesion strength. Furthermore the optimum copper oxide thickness required for the maximum pull strength ranged between 20 nm and 30 nm. The high pull strength was presumably due to the increase of surface wettability and mechanical interlocking effects resulting from copper oxidation.


Sign in / Sign up

Export Citation Format

Share Document