Magnetic Domain Structure and Spin Reorientation Transition in the System Co/Au/W(110)

1997 ◽  
Vol 475 ◽  
Author(s):  
T. Duden ◽  
E. Bauer

ABSTRACTUltrathin epitaxial Co layers grown on Au(111) show strong perpendicular magnetic aniso-tropy resulting in out-of-plane magnetization in thin films. With increasing Co thickness the increasing contribution of the shape anisotropy leads to a reorientation transition of the magnetization which has already been subject of many other studies. In the dynamic in-situ experiments reported here bulk Au(111) is replaced by epitaxially grown Au(111)/W(110). The high time resolution (0.05 ML Co deposition per acquisition cycle) allows to extract several mechanisms which occur during the spin reorientation transition.

2020 ◽  
Vol 27 (5) ◽  
pp. 1339-1346 ◽  
Author(s):  
Silja Flenner ◽  
Malte Storm ◽  
Adam Kubec ◽  
Elena Longo ◽  
Florian Döring ◽  
...  

Hard X-ray nanotomography enables 3D investigations of a wide range of samples with high resolution (<100 nm) with both synchrotron-based and laboratory-based setups. However, the advantage of synchrotron-based setups is the high flux, enabling time resolution, which cannot be achieved at laboratory sources. Here, the nanotomography setup at the imaging beamline P05 at PETRA III is presented, which offers high time resolution not only in absorption but for the first time also in Zernike phase contrast. Two test samples are used to evaluate the image quality in both contrast modalities based on the quantitative analysis of contrast-to-noise ratio (CNR) and spatial resolution. High-quality scans can be recorded in 15 min and fast scans down to 3 min are also possible without significant loss of image quality. At scan times well below 3 min, the CNR values decrease significantly and classical image-filtering techniques reach their limitation. A machine-learning approach shows promising results, enabling acquisition of a full tomography in only 6 s. Overall, the transmission X-ray microscopy instrument offers high temporal resolution in absorption and Zernike phase contrast, enabling in situ experiments at the beamline.


Author(s):  
B. G. Demczyk

CoCr thin films have been of interest for a number of years due to their strong perpendicular anisotropy, favoring magnetization normal to the film plane. The microstructure and magnetic properties of CoCr films prepared by both rf and magnetron sputtering have been examined in detail. By comparison, however, relatively few systematic studies of the magnetic domain structure and its relation to the observed film microstructure have been reported. In addition, questions still remain as to the operative magnetization reversal mechanism in different film thickness regimes. In this work, the magnetic domain structure in magnetron sputtered Co-22 at.%Cr thin films of known microstructure were examined by Lorentz transmission electron microscopy. Additionally, domain nucleation studies were undertaken via in-situ heating experiments.It was found that the 50 nm thick films, which are comprised of columnar grains, display a “dot” type domain configuration (Figure 1d), characteristic of a perpendicular magnetization. The domain size was found to be on the order of a few structural columns in diameter.


MRS Advances ◽  
2016 ◽  
Vol 1 (37) ◽  
pp. 2635-2640 ◽  
Author(s):  
Adele Moatti ◽  
Reza Bayati ◽  
Srinivasa Rao Singamaneni ◽  
Jagdish Narayan

ABSTRACTBi-epitaxial VO2 thin films with [011] out-of-plane orientation were integrated with Si(100) substrates through TiO2/TiN buffer layers. At the first step, TiN is grown epitaxially on Si(100), where a cube-on-cube epitaxy is achieved. Then, TiN was oxidized in-situ ending up having epitaxial r-TiO2. Finally, VO2 was deposited on top of TiO2. The alignment across the interfaces was stablished as VO2(011)║TiO2(110)║TiN(100)║Si(100) and VO2(110) /VO2(010)║TiO2(011)║TiN(112)║Si(112). The inter-planar spacing of VO2(010) and TiO2(011) equal to 2.26 and 2.50 Å, respectively. This results in a 9.78% tensile misfit strain in VO2(010) lattice which relaxes through 9/10 alteration domains with a frequency factor of 0.5, according to the domain matching epitaxy paradigm. Also, the inter-planar spacing of VO2(011) and TiO2(011) equals to 3.19 and 2.50 Å, respectively. This results in a 27.6% compressive misfit strain in VO2(011) lattice which relaxes through 3/4 alteration domains with a frequency factor of 0.57. We studied semiconductor to metal transition characteristics of VO2/TiO2/TiN/Si heterostructures and established a correlation between intrinsic defects and magnetic properties.


Author(s):  
A. Quesada ◽  
G. Chen ◽  
A. T. N'Diaye ◽  
P. Wang ◽  
Y. Z. Wu ◽  
...  

Carbon monoxide (CO) adsorption on ultrathin fcc Fe films is known to result in the rotation of magnetization from out-of-plane to in-plane.


Sign in / Sign up

Export Citation Format

Share Document