Hrtem Study Of Dislocations In Gesi/Si Heterostructures Grown By VPE

1996 ◽  
Vol 442 ◽  
Author(s):  
Jijnwu Liang ◽  
Xueyuan Wan
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Dislocation Loop ◽  
Misfit Dislocation ◽  
Chemical Vapor ◽  
Cross Sectional ◽  
Transmission Electron ◽  
Type Dislocation ◽  
First Time

AbstractGeSi/Si heterostructures grown by atmospheric chemical vapor epitaxy have been studied by cross sectional high resolution transmission electron microscopy (HRTEM). For the first time we have observed an interstitial-type dislocation loop which is located near to a 60° misfit dislocation in the initially prepared GeSi/Si sample. After 30 minutes observation, the interstitial-type dislocation loop disappeared and the 60° dislocation climbed. Moreover, we have observed dissociated 60° dislocations with about 9 nm width of stacking fault existing in silicon substrate.

scholarly journals High Resolution Transmission Electron Microscopy of Metallic Film/Laser-Irradiated Alumina Couples.

1994 ◽  
Vol 357 ◽  
Author(s):  
A. J. Pedraza ◽  
Siqi Cao ◽  
L. F. Allard ◽  
D. H. Lowndes
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Copper Film ◽  
Interfacial Structure ◽  
Diffuse Interface ◽  
Cross Sectional ◽  
Polycrystalline Alumina ◽  
Near Surface ◽  
Transmission Electron

AbstractA near-surface thin layer is melted when single crystal alumina (sapphire) is pulsed laserirradiated in an Ar-4%H2 atmosphere. γ-alumina grows epitaxially from the (0001) face of axalumina (sapphire) during the rapid solidification of this layer that occurs once the laser pulse is over. Cross sectional high resolution transmission electron microscopy (HRTEM) reveals that the interface between unmelted sapphire and γ-alumina is atomistically flat with steps of one to a few close-packed oxygen layers; however, pronounced lattice distortions exist in the resolidified γ-alumina. HRTEM also is used to study the metal-ceramic interface of a copper film deposited on a laser-irradiated alumina substrate. The observed changes of the interfacial structure relative to that of unexposed substrates are correlated with the strong enhancement of film-substrate bonding promoted by laser irradiation. HRTEM shows that a thin amorphous film is produced after irradiation of 99.6% polycrystalline alumina. Formation of a diffuse interface and atomic rearrangements that can take place in metastable phases contribute to enhance the bonding strength of copper to laser-irradiated alumina.

Effect of Ge-rich Si1−zGez Segregation on the Morphological Stability of NiSi1−uGeu Film Formed on Strained (001) Si0.8Ge0.2 Epilayer

2004 ◽  
Vol 810 ◽  
Author(s):  
H.B. Yao ◽  
D.Z. Chi ◽  
S. Tripathy ◽  
S.Y. Chow ◽  
W.D. Wang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Grain Boundary ◽  
Surface Morphology ◽  
Morphological Stability ◽  
Triple Junctions ◽  
Cross Sectional ◽  
Transmission Electron ◽  
Segregation Process

ABSTRACTThe germanosilicidation of Ni on strained (001) Si0.8Ge0.2, particularly Ge segregation, grain boundary grooving, and surface morphology, during rapid thermal annealing (RTA) was studied. High-resolution cross-sectional transmission electron microscopy (HRXTEM) suggested that Ge-rich Si1−zGez segregation takes place preferentially at the germanosilicide/Si1−xGex interface, more specifically at the triple junctions between two adjacent NiSi1−uGeu grains and the underlying epi Si1−xGex, and it is accompanied with thermal grooving process. The segregation process accelerates the thermal grooving of NiSi1−uGeu grain boundaries at the interface. The segregation-accelerated grain boundary grooving has significant effect on the surface morphology of NiSi1−uGeu films in Ni-SiGe system.

A Study of the Origin of Band-A Emission in Homoepitaxial Diamond Thin Films

1999 ◽  
Vol 588 ◽  
Author(s):  
Daisuke Takeuchi ◽  
Hideyuki Watanabe ◽  
Sadanori Yamanaka ◽  
Hideyo Okushi ◽  
Koji Kajimura ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Grain Boundaries ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Plasma Chemical Vapor Deposition ◽  
Transmission Electron ◽  
Excitonic Emission

AbstractThe band-A emission (around 2.8 eV) observed in high quality (device-grade) homoepitaxial diamond films grown by microwave-plasma chemical vapor deposition (CVD) was studied by means of scanning cathodoluminescence spectroscopy and high-resolution transmission electron microscopy. Recent progress in our study on homoepitaxial diamond films was obtained through the low CH4/H2 conditions by CVD. These showed atomically flat surfaces and the excitonic emission at room temperature, while the band-A emission (2.95 eV) decreased. Using these samples, we found that the band-A emission only appeared at unepitaxial crystallites (UC) sites, while other flat surface parts still showed the excitonic emission. High-resolution transmission electron microscopy revealed that there were grain boundaries which contained π-bonds in UC. This indicates that one of the origin of the band-A emission in diamond films is attributed to π bonds of grain boundaries.

High-Resolution Transmission Electron Microscopy Study of Nanostructured Hydroxyapatite

2008 ◽  
Vol 14 (5) ◽  
pp. 433-438 ◽  
Author(s):  
Daniel Biggemann ◽  
Marcelo H. Prado da Silva ◽  
Alexandre M. Rossi ◽  
Antonio J. Ramirez
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Spherical Aberration ◽  
Microscopy Study ◽  
Lattice Parameter ◽  
Electron Microscopy Study ◽  
Restoration Technique ◽  
Transmission Electron ◽  
First Time

AbstractCrystalline properties of synthetic nanostructured hydroxyapatite (n-HA) were studied using high-resolution transmission electron microscopy. The focal-series-restoration technique, obtaining exit-plane wavefunction and spherical aberration-corrected images, was successfully applied for the first time in this electron-beam-susceptible material. Multislice simulations and energy dispersive X-ray spectroscopy were also employed to determine unequivocally that n-HA particles of different size preserve stoichiometric HA-like crystal structure. n-HA particles with sizes of twice the HA lattice parameter were found. These results can be used to optimize n-HA sinterization parameters to improve bioactivity.

High Resolution Transmission Electron Microscopy of Proton Implanted Gallium Arsenide

1985 ◽  
Vol 46 ◽  
Author(s):  
D. K. Sadana ◽  
J. M. Zavada ◽  
H. A. Jenkinson ◽  
T. Sands
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Phenomenological Model ◽  
Room Temperature ◽  
Stacking Faults ◽  
High Dose ◽  
Cross Sectional ◽  
Projected Range ◽  
Transmission Electron

AbstractHigh resolution transmission electron microscopy (HRTEM) has been performed on cross-sectional specimens from high dose (1016 cm−2) H+ implanted (100) GaAs (300 keV at room temperature). It was found that annealing at 500°C created small (20-50Å) loops on {111} near the projected range (Rp)(3.2 μm). At 550-600°C, voids surrounded by stacking faults, microtwins and perfect dislocations were observed near the Rp. A phenomenological model explaining the observed results is proposed.

Sign in / Sign up

Export Citation Format

Share Document