Synthesis of Ag–decorated vertical graphene nanosheets and their electrocatalytic efficiencies

Herein, we report the successful preparation of Ag–decorated vertical–oriented graphene sheets (Ag/VGs) via helicon wave plasma chemical vapor deposition (HWP–CVD) and radio frequency plasma magnetron sputtering (RF–PMS). VGs were synthesized in a mixture of argon and methane (Ar/CH4) by HWP–CVD, and then the silver nanoparticles on the prepared VGs were modified using the RF-PMS system under different sputtering times and RF power levels. The morphology and structure of the Ag nanoparticles were characterized by scanning electron microscopy (SEM), and the results revealed that Ag nanoparticles were evenly dispersed on the mesoporous wall of the VGs. X-ray diffraction (XRD) results showed that the diameter of the Ag particles increased with the increase of silver loading, and the average size was between 10.49 nm and 25.9 nm, which were consistent with transmission electron microscopy (TEM) results. Ag/VGs were investigated as effective electrocatalysts for use in an alkaline aqueous system. Due to the uniquely ordered and interconnected wall structure of VGs, the area of active sites increased with the Ag loading, which made the Ag/VGs have high oxygen reduction reaction (ORR)/oxygen evolution reaction (OER) performance. The double–layer capacitance (Cdl) of the Ag/VGs under different silver loadings were studied, and the results showed that highest silver content is the best (1.04 mF/cm2). The results showed that, Ag/VGs expected to be a credible electrocatalytic material.

Lateral outward growth of single-crystal diamond by two different structures of microwave plasma reactors

On a semi-open holder, the homoepitaxial lateral growth of single-crystal diamond (SCD) was carried out via microwave plasma chemical vapor deposition (MPCVD). By tuning and optimizing two different structures of...

Control of electrostatic self-assembly seeding of diamond nanoparticles on carbon nanowalls

Seeding of diamond nanoparticles on vertically-aligned multi-layer graphene, the so-called carbon nanowalls (CNWs), is studied by using deionized water, ethylene glycol, ethanol, and formamide as dispersion mediums. Detonation nanodiamond particles show the smallest mean size and size distribution with a high positive zeta potential when dispersed in ethanol. The contact angle of ethanol on CNWs is almost zero degree, confirming highly wetting behaviour. The diamond nanoparticles dispersed in ethanol are distributed the most uniformly with minimal aggregation on CNWs as opposed to those dispersed in other liquids. The resulting diamond nanoparticle-seeded CNWs, followed by short-term growth in microwave plasma chemical vapor deposition, show a marked decrease in field emission turn-on field down to 1.3 V μm−1 together with a large increase in current density, compared to bare CNWs without diamond seeding. The results provide a way to control the density, size, and uniformity (spacing) of diamond nanoparticles on CNWs and should be applied to fabricate hybrid materials and devices using nanodiamond and nanocarbons.

Effect of fluoropolymer spots on pool boiling heat transfer

In this paper, the investigation of pool boiling heat transfer on biphilic micro/nanostructured surfaces is presented. An array of micrococoons from silicon oxide nanowires was synthesized on the surface of a copper heater using the gas-jet electron beam plasma chemical vapor deposition method. The biphilic properties of the surface were achieved by applying fluoropolymer spots by hot wire chemical vapor deposition. Technology of creating biphilic surfaces was developed and boiling curves were obtained for used samples. The advantages of using a biphilic surface to enhance heat transfer were demonstrated in comparison with a smooth surface and a micro-nanostructured surface without local hydrophobic fluoropolymer regions. This technology can be applied to enhance boiling heat transfer.

Bias-Enhanced Formation of Metastable and Multiphase Boron Nitride Coating in Microwave Plasma Chemical Vapor Deposition

Boron nitride (BN) is primarily a synthetically produced advanced ceramic material. It is isoelectronic to carbon and, like carbon, can exist as several polymorphic modifications. Microwave plasma chemical vapor deposition (MPCVD) of metastable wurtzite boron nitride is reported for the first time and found to be facilitated by the application of direct current (DC) bias to the substrate. The applied negative DC bias was found to yield a higher content of sp3 bonded BN in both cubic and metastable wurtzite structural forms. This is confirmed by X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectroscopy (FTIR). Nano-indentation measurements reveal an average coating hardness of 25 GPa with some measurements as high as 31 GPa, consistent with a substantial fraction of sp3 bonding mixed with the hexagonal sp2 bonded BN phase.

Synthesis and Properties of Electrically Conductive/Nitrogen Grain Boundaries Incorporated Ultrananocrystalline Diamond (N-UNCD) Thin Films Grown by Microwave Plasma Chemical Vapor Deposition (MPCVD)

Research and development have been performed to investigate the effect of total pressure and microwave power on the electrical conductivity of nitrogen (N) atoms’ grain boundaries incorporated ultrananocrystalline diamond (N-UNCD) films grown by microwave plasma chemical vapor deposition (MPCVD). Insertion of N atoms into the UNCD film’s grain boundaries induces N atoms chemical reaction with C-atoms dangling bonds, resulting in release of electrons, which induce electrical conductivity. Four-point probe electrical measurements show that the highest electrically conductive N-UNCD films, produced until now, exhibit electrical resistivity of ~1 Ohm.cm, which is orders of magnitude lower than the ≥106 Ohm.cm for undoped ultrananocrystalline diamond (UNCD) films. X-ray diffraction analysis and Raman spectroscopy revealed that the growth of the N-UNCD films by MPCVD do not produce graphite phase but only crystalline nanodiamond grains. X-ray photoelectron spectroscopy (XPS) analysis confirmed the presence of nitrogen (N) in the N-UNCD films and the high conductivity (no electrical charging is observed during XPS analysis) shown in electrical measurements.