Thermopower and Conductivity Activation Energies in Hydrogenated Amorphous Silicon

1996 ◽  
Vol 420 ◽  
Author(s):  
H. M. Dyalsingh ◽  
J. Kakalios
Keyword(s):  
Activation Energy ◽  
Amorphous Silicon ◽  
Long Range ◽  
Short Circuit ◽  
Hydrogenated Amorphous Silicon ◽  
Dark Conductivity ◽  
Activation Energies ◽  
Thermoelectric Effects ◽  
Hydrogenated Amorphous ◽  
Fluctuation Model

AbstractThe long range fluctuation model has been widely used to account for the difference in activation energies seen experimentally in dark conductivity and thermopower measurements in hydrogenated amorphous silicon. We report on a test of this model using measurements of the conductivity and thermoelectric effects carried out in both open and short circuit configurations. While the thermopower activation energy is less than that of the dark conductivity, the short circuit Seebeck conductivity is found to be nearly identical to the dark conductivity in both activation energy and magnitude, consistent with the long range fluctuation model.

Stability of hydrogenated amorphous silicon prepared by reactive evaporation

1991 ◽  
Vol 69 (6) ◽  
pp. 679-683
Author(s):  
D. C. Craigen ◽  
R. D. Audas ◽  
D. E. Brodie
Keyword(s):  
Activation Energy ◽  
Amorphous Silicon ◽  
Hydrogenated Amorphous Silicon ◽  
Dark Conductivity ◽  
Time Curve ◽  
Switching Model ◽  
Order Of Magnitude ◽  
Reactive Gases ◽  
Staebler Wronski Effect ◽  
Hydrogenated Amorphous

Hydrogenated amorphous silicon (a-Si:H) was prepared by evaporating Si in a controlled ambient of reactive gases. Contamination of the samples by exposure to air affects both the dark conductivity and the photoconductivity. Some of the contamination effects can be removed by annealing, but some changes are not reversible. The irreversible changes are mainly due to the chemisorption of oxygen obtained from water vapour when the samples are stored in air. The Staebler–Wronski effect is observed in all samples whose photoconductivity is at least an order of magnitude higher than the dark conductivity. The photoconductivity versus time curve displays at t−1/3 dependence, typical of the Staebler–Wronski effect, but the degradation is much slower than that reported for glow discharge a-Si:H. The activation energy for the effect is 0.12 eV, which is larger than the 0.04 eV expected for the bond-switching model.

Mechanical Spectroscopy Study on the Light Soaking Effect on Hydrogenated Amorphous Silicon

2012 ◽  
Vol 184 ◽  
pp. 416-421 ◽  
Author(s):  
H. Mizubayashi ◽  
I. Sakata ◽  
H. Tanimoto
Keyword(s):  
Internal Friction ◽  
Temperature Dependence ◽  
Amorphous Silicon ◽  
Hydrogenated Amorphous Silicon ◽  
Wide Distribution ◽  
Activation Energies ◽  
Mechanical Spectroscopy ◽  
Induced Changes ◽  
Mild Temperature ◽  
Hydrogenated Amorphous

For hydrogenated amorphous silicon (a-Si:H) films deposited at temperatures between 423 K and 623 K (a-Si:H423Kand so on), the light-induced changes in the internal friction between 80 K and 400 K were studied. The internal friction is associated with H2motion in microvoid networks, and shows the mild temperature dependence between about 80 K and 300 K (Q-180-300K) and the almost linear increase above 300 K (Q-1>300K). BothQ-180-300KandQ-1>300Kdecrease with increasing the deposition temperature, and show the mild temperature dependence ina-Si:H623K. The white light soaking with 100 mW/cm2(WLS100and so on) below 300 K caused a change inQ-180-300Kand no changes inQ-1>300K, respectively, and the light-induced changes inQ-180-300Krecovered after annealing at 423 K. The wide distribution of activation energies for H2motions between microvoids indicate that most of neighboring microvoids are connected through windows, i.e., the microvoid networks are existing ina-Si:H, and the spatially loose or solid structures are responsible for the low or high activation energies for the H2motion between microvoids, respectively. Furthermore, the light-induced hydrogen evolution (LIHE) was observed for WLS200to WLS400in a vacuum between 400 and 500 K, resulting in the disappearance of the internal friction due to the H2motion in the microvoid network.

Improved Light Soaking Stability of R.F. Sputter Deposited Amorphous Silicon

1991 ◽  
Vol 219 ◽  
Author(s):  
A. Wynveen ◽  
J. Fan ◽  
J. Kakalios ◽  
J. Shinar
Keyword(s):  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Dark Conductivity ◽  
Initial Defect ◽  
Optical Gap ◽  
Sputter Deposited ◽  
Staebler Wronski Effect ◽  
Hydrogenated Amorphous

ABSTRACTStudies of r.f. sputter deposited hydrogenated amorphous silicon (a-Si:H) find that the light induced decrease in the dark conductivity and photoconductivity (the Staebler-Wronski effect) is reduced when the r.f. power used during deposition is increased. The slower Staebler-Wronski effect is not due to an increase in the initial defect density in the high r.f. power samples, but may result from either the lower hydrogen content or the smaller optical gap found in these films.

Boron doping in a-SiO:H,

2014 ◽  
Vol 92 (7/8) ◽  
pp. 586-588 ◽  
Author(s):  
Y. Kitani ◽  
T. Maeda ◽  
S. Kakimoto ◽  
K. Tanaka ◽  
R. Okumoto ◽  
...  
Keyword(s):  
Amorphous Silicon ◽  
Hydrogenated Amorphous Silicon ◽  
Hole Mobility ◽  
Boron Doping ◽  
Type A ◽  
Dark Conductivity ◽  
Wide Range ◽  
P Type ◽  
Hydrogenated Amorphous ◽  
Silicon Oxygen

Boron-doping characteristics in hydrogenated amorphous silicon–oxygen alloys (a-SiO:H) have been studied in contrast to those in hydrogenated amorphous silicon (a-Si:H). Although the boron-incorporation efficiency shows almost the same value between a-SiO:H and a-Si:H, p-type a-SiO:H (p-a-SiO:H) exhibits lower dark conductivity by one or two orders of magnitude as compared to p-type a-Si:H (p-a-Si:H) in a wide range of doping levels. We have found that p-a-SiO:H exhibits low dark conductivity as compared to p-a-Si:H even when we choose samples showing the same activation energy from a variety of as-deposited and thermally annealed samples. We have concluded from the different Urbach-energy values between high quality intrinsic a-SiO:H and a-Si:H that the origin of low dark conductivity in p-a-SiO:H is due to low hole mobility.

Hydrogenated Amorphous Silicon Alloys Prepared by CVD of Higher Silanes

1986 ◽  
Vol 70 ◽  
Author(s):  
Masud Akhtar ◽  
Herbert A. Weaklie
Keyword(s):  
Amorphous Silicon ◽  
Band Gap ◽  
Plasma Deposition ◽  
Hydrogenated Amorphous Silicon ◽  
Chemical Vapor ◽  
Wide Band ◽  
Dark Conductivity ◽  
Attractive Alternative ◽  
Silicon Alloys ◽  
Hydrogenated Amorphous

ABSTRACTHydrogenated amorphous silicon may be deposited at relatively low temperatures, where the density of defects may be expected to be low, by the chemical vapor deposition (CVD) of higher silanes. This method is an attractive alternative to plasma deposition techniques. We describe here the preparation of a-Si:H and related alloys incorporating carbon, germanium, and fluorine. a-Si:H films were deposited on heated substrates in the range 365°C-445°C by CVD of Si2H6 and Si3H8. The optical gap (Eg) ranged from 1.4 to 1.7 eV and the properties of films deposited from either Si2 H6 or Si3 H8 were quite similar. Wide band gap (Eg=2 eV) alloys of a-SiC:H doped with boron were prepared by CVD of disilane, methyl silane, and diborane. We also prepared variable band gap a-SiC:H alloys by substituting F2C= CFH for methylsilane, and these films were found to have approximately 1–2% fluorine incorporated. The dark conductivity of the boron doped a-SiC:H alloys dep~sited from either carbon source ranged from ix10-7 to 6x10-7 (ohm-cm)-1. We also prepared low band aap alloys of Si and Ge by CVD of trisilane and germane. The band gap of a film containing 20% Ge was 1.5 eV; however, the photoconductivity of the film was relatively low.

Sign in / Sign up

Export Citation Format

Share Document