Solid phase epitaxy of Germanium on Silicon substrates

2011 ◽  
Vol 1339 ◽  
Author(s):  
R.R. Lieten ◽  
Q.-B. Ma ◽  
J. Guzman ◽  
J.W. Ager ◽  
E.E. Haller ◽  
...  

ABSTRACTWe demonstrate the possibilities of plasma enhanced chemical vapor deposition (PECVD) and solid phase epitaxy to obtain germanium on silicon with excellent crystalline properties, even for very thin layers (< 100 nm). Amorphous germanium layers are deposited by PECVD on silicon substrates. Deposition of an amorphous layer, without the presence of crystalline seeds, is critical. Crystalline inclusions must be avoided to obtain high crystal quality and a smooth surface after crystallization. PECVD is well suited for deposition of amorphous layers because low temperature deposition and high growth rates are possible. Additional experiments with molecular beam epitaxy show that it is not mandatory to have hydrogen present inside the germanium layer to obtain highly crystalline germanium. Atomic hydrogen plays, however, an important role during deposition by lowering the surface adatom mobility and consequently increasing the disorder of the deposited layer. Synchrotron X-ray diffraction shows no germanium diffraction, indicating that the layer does not contain crystalline seeds. Crystallization can be performed at limited temperatures: Raman measurements show crystallization between 400 and 425 °C. Another important advantage of the proposed method is the scalability: germanium layers of larger diameter can be obtained by simply using larger silicon substrates.

1992 ◽  
Vol 275 ◽  
Author(s):  
J. Chen ◽  
H. A. Lu ◽  
F. DiMeo ◽  
B. W. Wessels ◽  
D. L. Schulz ◽  
...  

ABSTRACT-Heteroepitaxial superconducting Bi,Sr2CaCu2Ox (BSCCO 2212) thin films have been formed by solid phase epitaxy from amorphous films deposited on (100) LaA1O3 single crystal substrates by organometallic chemical vapor deposition. The epitaxial structure of the film is confirmed by x-ray diffraction including θ/2θ and Φ (in plane rotation) scans. Cross-sectional high resolution transmission electron microscopy indicates that the film-substrate interface is nearly atomically abrupt. Improvements in superconducting properties of the epitaxial thin films are noted in comparison to highly textured films deposited on MgO.


Author(s):  
N. David Theodore ◽  
Leslie H. Allen ◽  
C. Barry Carter ◽  
James W. Mayer

Metal/polysilicon investigations contribute to an understanding of issues relevant to the stability of electrical contacts in semiconductor devices. These investigations also contribute to an understanding of Si lateral solid-phase epitactic growth. Metals such as Au, Al and Ag form eutectics with Si. reactions in these metal/polysilicon systems lead to the formation of large-grain silicon. Of these systems, the Al/polysilicon system has been most extensively studied. In this study, the behavior upon thermal annealing of Au/polysilicon bilayers is investigated using cross-section transmission electron microscopy (XTEM). The unique feature of this system is that silicon grain-growth occurs at particularly low temperatures ∽300°C).Gold/polysilicon bilayers were fabricated on thermally oxidized single-crystal silicon substrates. Lowpressure chemical vapor deposition (LPCVD) at 620°C was used to obtain 100 to 400 nm polysilicon films. The surface of the polysilicon was cleaned with a buffered hydrofluoric acid solution. Gold was then thermally evaporated onto the samples.


1988 ◽  
Vol 126 ◽  
Author(s):  
M. Razeghi ◽  
M. Defour ◽  
F. Omnes ◽  
J. Nagle ◽  
P. Maurel ◽  
...  

ABSTRACTHigh quality GaAs and InP have been grown on silicon substrates, using low pressure metalorganic chemical vapor deposition technique. The growth temperature is 550°C and the growth rate 100 A/min.Photoluminescence, X-ray diffraction and electrochemical profiling verified the high quality of these layers. The use of superlattices as buffer layers, (GaAs/GaInP) in the case of GaAs/Si and (GaInAsP/InP) in the case of InP/Si, decreased the amount of misfit dislocations in the epitaxial layer. Carrier concentrations as low as 5.1015 cm−3 have been measured by electrochemical profiling.


2000 ◽  
Vol 637 ◽  
Author(s):  
F. Niu ◽  
A.R. Teren ◽  
B.H. Hoerman ◽  
B.W. Wessels

AbstractEpitaxial ferroelectric BaTiO3 thin films have been developed as a material for microphotonics. Efforts have been directed toward developing these materials for thin film electro-optic modulators. Films were deposited by metalorganic chemical vapor deposition (MOCVD) on both MgO and silicon substrates. The electro-optic properties of the thin films were measured. For BaTiO3 thin films grown on (100) MgO substrates, the effective electro-optic coefficient, reff depended on the magnitude and direction of the electric field. Coefficients as high as 260 pm/V have been measured. Investigation of BaTiO3 films on silicon has been undertaken. Epitaxial BaTiO3 thin films were deposited by MOCVD on (100) MgO layers grown on silicon (100) substrates by metal-organic molecular beam epitaxy (MOMBE). The MgO serves as the low index optical cladding layer as well as an insulating layer. X-ray diffraction and transmission electron microscopy (TEM) indicated that BaTiO3 was epitaxial with an orientational relation given by BaTiO3 (100)//Si (100) and BaTiO3[011]//Si [011]. Polarization measurements indicated that the BaTiO3 epitaxial films on Si were in the ferroelectric state.


1990 ◽  
Vol 205 ◽  
Author(s):  
J. A. Roth ◽  
G. L. Olson ◽  
D. C. Jacobson ◽  
J. M. Poate ◽  
C. Kirschbaum

AbstractThis paper discusses the intrusion of H into a-Si layers during solid phase epitaxy and the effect of this H on the growth kinetics. We show that during annealing in the presence of water vapor, H is continuously generated at the oxidizing a-Si surface and diffuses into the amorphous layer, where it causes a reduction in the epitaxial growth rate. The measured variation of growth rate with the depth of the amorphous/crystal interface is correlated with the concentration of H at the interface. The diffusion coefficient for H in a-Si is determined by comparing measured depth profiles with calculated values. Hydrogen intrusion is observed even in layers annealed in vacuum and in inert gas ambients. Thin (<;5000 Åthick) a-Si layers are especially susceptible to this effect, but we show that in spite of the presence of H the activation energy for SPE derived earlier from thin-layer data is in good agreement with the intrinsic value obtained from thick, hydrogen-free layers.


2001 ◽  
Vol 89 (3) ◽  
pp. 1986 ◽  
Author(s):  
Masataka Satoh ◽  
Yuuki Nakaike ◽  
Tomonori Nakamura

2017 ◽  
Vol 897 ◽  
pp. 91-94
Author(s):  
Philip Hens ◽  
Ryan Brow ◽  
Hannah Robinson ◽  
Michael Cromar ◽  
Bart van Zeghbroeck

In this paper, we report, for the first time, growth of high-quality single-crystalline 3C-SiC on silicon substrates using Hot Filament Chemical Vapor Deposition (HF-CVD). Rocking curve X-Ray diffraction (XRD) measurements revealed a full-width at half maximum (FWHM) as low as 333 arcsec for a 15 μm thick layer. Low tensile strain, below 0.1%, was measured using Raman spectroscopy. This quality was achieved with a carefully optimized process making use of the additional degrees of freedom the hot filaments create. For example, the hot filaments allow for precursor pre-cracking. Additionally, they allow a tuning of the vertical thermal gradient which creates an improved thermal field compared to classic Chemical Vapor Deposition techniques used for the deposition of this material today.


2007 ◽  
Vol 539-543 ◽  
pp. 1230-1235 ◽  
Author(s):  
Hyoun Woo Kim ◽  
S.H. Shim

We have synthesized the high-density Ga2O3 nanowires on gold (Au)-coated silicon substrates using metalorganic chemical vapor deposition. The nanowires exhibited one-dimensional structures having circular cross sections with diameters in the range of 30-200 nm. The energy dispersive x-ray spectroscopy revealed that the nanowires contained elements of Ga and O, without Au-related impurities. X-ray diffraction analysis and high-resolution transmission electron microscopy showed that the Ga2O3 nanowires were crystalline.


1992 ◽  
Vol 270 ◽  
Author(s):  
Li Chang

ABSTRACTDiamond films prepared by microwave plasma chemical vapor deposition, using a gas mixture of methane and hydrogen with ethanol, were formed on silicon substrates. Highresolution transmission electron microscopy was employed to characterize the microstructure at interface regions. It was found that the diamond crystals were grown on an amorphous carbon layer. Twins and stacking faults were observed at the regions interfaced with the amorphous carbon layer, suggesting that the defects may already exist in the nucleation stage and at the very first stage of growth. Also, some diamond nuclei embedded in the amorphous layer were observed.


1993 ◽  
Vol 335 ◽  
Author(s):  
Warren C. Hendricks ◽  
Seshu B. Desu ◽  
Chien H. Peng

AbstractTransparent and highly specular PbTiO3 thin films were deposited on sapphire, platinum and ruthenium oxide-coated silicon wafers by hot-wall metallorganic chemical vapor deposition (MOCVD). Lead bis-tetramethylheptadionate and titanium ethoxide were used as chemical precursors. Films were deposited over a range of experimental conditions. X-ray diffraction (XRD) was used to determine the phases present in the films; Scanning Electron Microscopy (SEM) was used to examine the surface morphology and Energy Dispersive Spectroscopy (EDS) was used to determine the composition. Optical spectra were obtained to confirm the highly dense and transparent nature of the films. The chemical stability of the ruthenium oxide substrates in the MOCVD environment as well as the existence of a high-temperature deposition regime for composition control are also discussed.


Sign in / Sign up

Export Citation Format

Share Document