An Experimental Study of the Deformation of Zircaloy PWR Fuel Rod Cladding Under Mainly Convective Cooling

2009 ◽  
pp. 284-284-19 ◽  
Author(s):  
ED Hindle ◽  
CA Mann
Keyword(s):  
Experimental Study ◽  
Convective Cooling ◽  
Fuel Rod

Experimental Study of Advanced Convective Cooling Techniques for Combustor Liners

2008 ◽  
Author(s):  
Michael Maurer ◽  
Uwe Ruedel ◽  
Michael Gritsch ◽  
Jens von Wolfersdorf
Keyword(s):  
Heat Transfer ◽  
Experimental Study ◽  
Reynolds Number ◽  
Heat Transfer Coefficient ◽  
Flow Field ◽  
Transfer Coefficient ◽  
Heat Transfer Enhancement ◽  
Transfer Enhancement ◽  
Number Range ◽  
Convective Cooling

An experimental study was conducted to determine the heat transfer performance of advanced convective cooling techniques at the typical conditions found in a backside cooled combustion chamber. For these internal cooling channels, the Reynolds number is usually found to be above the Reynolds number range covered by available databases in the open literature. As possible candidates for an improved convective cooling configuration in terms of heat transfer augmentation and acceptable pressure drops, W-shaped and WW-shaped ribs were considered for channels with a rectangular cross section. Additionally, uniformly distributed hemispheres were investigated. Here, four different roughness spacings were studied to identify the influence on friction factors and the heat transfer enhancement. The ribs and the hemispheres were placed on one channel wall only. Pressure losses and heat transfer enhancement data for all test cases are reported. To resolve the heat transfer coefficient, a transient thermocromic liquid crystal technique was applied. Additionally, the area-averaged heat transfer coefficient on the W-shaped rib itself was observed using the so-called lumped-heat capacitance method. To gain insight into the flow field and to reveal the important flow field structures, numerical computations were conducted with the commercial code FLUENT™.

Experimental study to assess effects of ballooning and fuel relocation on the coolability of fuel rod bundle

2018 ◽  
Vol 332 ◽  
pp. 1-10 ◽  
Author(s):  
Jongrok Kim ◽  
Seok Cho ◽  
Jong-Kuk Park ◽  
Young-Jung Youn ◽  
Sang-Ki Moon
Keyword(s):  
Experimental Study ◽  
Fuel Rod ◽  
Rod Bundle

Experimental study on the restoration from a tilt-azimuth series for improvement in resolution

1995 ◽  
Vol 53 ◽  
pp. 636-637
Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe
Keyword(s):  
Experimental Study ◽  
Spherical Aberration ◽  
Incident Beam ◽  
Optical Parameters ◽  
Beam Tilting ◽  
Illumination Method ◽  
Restoration Method ◽  
Illumination Mode

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.

An Experimental Study of Some Properties of Stuttered Words

1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  
Experimental Study
Sign in / Sign up

Export Citation Format

Share Document