Narrow Band Interference Elimination based on Compressed Sensing in UWB Energy Detector

2016 ◽  
Vol 66 (2) ◽  
pp. 168
Author(s):  
Priyanka G. Patil ◽  
Gajanan K. Birajdar
Keyword(s):  
Compressed Sensing ◽  
Power Consumption ◽  
Message Passing ◽  
Narrow Band ◽  
Wide Band ◽  
Energy Detection ◽  
Energy Detector ◽  
Large Signal ◽  
Large Bandwidth ◽  
Interference Elimination

<p>Wireless communication applications with large signal bandwidth are developed tremendously in recent times. Due to large bandwidth the wide band communication causes huge power consumption and signal deterioration after addition of narrow band interference (NBI). The ultra wide band (UWB) energy detector, which is highly robust against NBI signal is presented. Compressed sensing is implemented to reduce the power consumption at the analog to digital converter with approximated message passing reconstruction. In addition to this, digital notch is employed to eliminate the NBI affected measurements from compressed version of the received signal before applying it to the energy detector. To analyze the efficiency of the detector, the energy detection and bit error probability of the detector in the absence of NBI and after mitigating NBI is compared. The simulation results are the evidence of effectiveness of the presented energy detector.</p><p> </p>

scholarly journals Performance Evaluation of Different Modulation Schemes for Ultra Wide Band Systems

2014 ◽  
Vol 65 (3) ◽  
pp. 184-188 ◽  
Author(s):  
Tasnuva Ali ◽  
Poppy Siddiqua ◽  
Mohammad A. Matin
Keyword(s):  
Short Distance ◽  
Narrow Band ◽  
Wide Band ◽  
Performance Comparison ◽  
Ultra Wideband ◽  
Good Resolution ◽  
Transmission Power ◽  
Large Bandwidth ◽  
Simulation Results ◽  
Modulation Schemes

Abstract Ultra-wideband (UWB) signals with a large bandwidth has some advantages like multipath immunity, low transmission power, good resolution for ranging and detecting geo locations, as well as it can resist to narrow-band interference. These signals are used for transmission in short distance with high throughput. In this paper, we have analyzed different modulation schemes for performance comparison in terms of BER with UWB Gaussian second derivative monopulse and wavelet-based monopulse. The simulation results demonstrate that wavelet-based monopulse provides better performance in comparison to the other two monopulses.

A Power-Efficient Noise Canceling Technique Using Signal-Suppression Feed-Forward for Wideband LNAs

2015 ◽  
Vol 643 ◽  
pp. 109-116
Author(s):  
Daiki Oki ◽  
Satoru Kawauchi ◽  
Cong Bing Li ◽  
Masataka Kamiyama ◽  
Seiichi Banba ◽  
...  
Keyword(s):  
Power Consumption ◽  
Input Signal ◽  
Noise Figure ◽  
Wide Band ◽  
Noise Cancellation ◽  
Cmos Process ◽  
Feed Forward ◽  
Power Efficient ◽  
Signal Suppression ◽  
Noise Canceling

This paper presents a power-efficient noise-canceling technique based on the feed-forward amplifiers, considering a fundamental tradeoff between noise figure (NF) and power consumption in the design of wide-band amplifiers. By suppressing the input signal of the noise cancellation amplifier, the nonlinear effect on the amplifier can be reduced, as well as the power consumption can be smaller. Furthermore, as a lower gain of the noise-canceling sub-amplifier can be achieved simultaneously, further reduction of the power consumption becomes possible. The verification of the proposed technique is conducted with Spectre simulation using 90nm CMOS process.

Ground-Adjustable Inductor for Wide-Tuning VCO Design

2012 ◽  
Vol 256-259 ◽  
pp. 2373-2378
Author(s):  
Wu Shiung Feng ◽  
Chin I Yeh ◽  
Ho Hsin Li ◽  
Cheng Ming Tsao
Keyword(s):  
Power Consumption ◽  
Tuning Range ◽  
Supply Voltage ◽  
Wide Band ◽  
Ultra Wide Band ◽  
Cmos Process ◽  
Voltage Controlled Oscillator ◽  
Wide Tuning Range ◽  
Chip Area ◽  
Ground Plate

A wide-tuning range voltage-controlled oscillator (VCO) with adjustable ground-plate inductor for ultra-wide band (UWB) application is presented in this paper. The VCO was implemented by standard 90nm CMOS process at 1.2V supply voltage and power consumption of 6mW. The tuning range from 13.3 GHz to 15.6 GHz with phase noise between -99.98 and -115dBc/Hz@1MHz is obtained. The output power is around -8.7 to -9.6dBm and chip area of 0.77x0.62mm2.

Spread-of-Masking Effects on Pure Tones and Several Speech Stimuli

1973 ◽  
Vol 16 (3) ◽  
pp. 385-396
Author(s):  
Richard H. Wilson ◽  
Richard W. Stream ◽  
Donald D. Dirks
Keyword(s):  
Pure Tone ◽  
Narrow Band ◽  
Wide Band ◽  
Intensity Level ◽  
Speech Stimuli ◽  
Intensity Range ◽  
Speech Spectrum ◽  
Series Of Experiments ◽  
Pure Tones ◽  
Upper Slope

A series of experiments was performed to study the upward-spread-of-masking phenomena as it pertains to pure-tone and speech stimuli. In the initial two experiments, three maskers were employed over a 40–60-dB intensity range. They included a wide band (50–5500 Hz), a speech spectrum (50–1000 Hz), and a narrow-band (50–950 Hz) noise. All filter slopes were 48 dB/octave, except for the upper slope of the speech-spectrum noise that was 6 dB/octave. In the first experiment, pure-tone thresholds obtained by a tracking procedure revealed no spread of masking when the wide-band and speech-spectrum maskers were used. Substantial spread-of-masking effects, characterized by nonlinear threshold increments outside the spectrum of the masker, were observed with the narrow-band masker. The second experiment included three types of speech stimuli (PBs, spondees, and synthetic sentences) under the same mask conditions used with the pure tones. Threshold shifts observed for the wide- and speech-spectrum maskers were linear with the masking intensity level. However, increased shifts, attributable to spread of masking, were observed with the narrow band and progressed nonlinearly as a function of the masking level. Finally, two additional experiments, performed with two different narrow-band maskers and spondee words, provided insightful information regarding the effects of the spread of masking on speech stimuli.

scholarly journals Spectrum Sensing in Cognitive Radio using Frequency Domain

2019 ◽  
Vol 9 (2) ◽  
pp. 3475-3477
Keyword(s):  
Cognitive Radio ◽  
Frequency Domain ◽  
Spectrum Sensing ◽  
Bandwidth Allocation ◽  
Dynamic Spectrum Access ◽  
Signal To Noise Ratio ◽  
Wide Band ◽  
Energy Detection ◽  
Secondary Users ◽  
Sensing Applications

An efficient bandwidth allocation and dynamic bandwidth access away from its previous limits is referred as cognitive radio (CR).The limited spectrum with inefficient usage requires the advances of dynamic spectrum access approach, where the secondary users are authorized to utilize the unused temporary licensed spectrum. For this reason it is essential to analyze the absence/presence of primary users for spectrum usage. So spectrum sensing is the main requirement and developed to sense the absence/ presence of a licensed user. This paper shows the design model of energy detection based spectrum sensing in frequency domain utilizing Binary Symmetric Channel (BSC) ,Additive white real Gaussian channel (AWGN), Rayleigh fading channel users for 16-Quadrature Amplitude Modulation(QAM) which is utilized for the wide band sensing applications at low Signal to noise Ratio(SNR) level to reduce the false error identification. The spectrum sensing techniques has least computational complexity. Simulink model for the energy detection based spectrum sensing using frequency domain in MATLAB 2014a.

Full-Spectrum k-Distribution Model for Radiation in Gas Based on Multi-Group Methods

2014 ◽  
Vol 1008-1009 ◽  
pp. 839-845
Author(s):  
Yue Zhou ◽  
Qiang Wang ◽  
Hai Yang Hu
Keyword(s):  
Narrow Band ◽  
Wide Band ◽  
Distribution Model ◽  
Full Spectrum ◽  
Distribution Method ◽  
One Dimensional ◽  
Group Methods ◽  
Monotonically Increasing Function ◽  
Homogeneous Media ◽  
Increasing Function

The k-distribution method applied in narrow band and wide band is extended to the full spectrum based on spectroscopic datebase HITEMP, educing the full-spectrum k-distribution model. Absorption coefficents in this model are reordered into a smooth,monotonically increasing function such that the intensity calculations are performed only once for each absorption coefficent value and the resulting computations are immensely more efficent.Accuracy of this model is examined for cases ranging from homogeneous one-dimensional carbon dioxide to inhomogeneous ones with simultaneous variations in temperature. Comparision with line-by-line calculations (LBL) and narrow-band k-distribution (NBK) method as well as wide-band k-distribution (WBK) method shows that the full-spectrum k-distribution model is exact for homogeneous media, although the errors are greater than the other two models. After dividing the absorption coefficients into several groups according to their temperature dependence, the full-spectrum k-distribution model achieves line-by-line accuracy for gases inhomogeneous in temperature, accompanied by lower computational expense as compared to NBK model or WBK model. It is worth noting that a new grouping scheme is provided in this paper.

Efficient Multirate Filtering

2002 ◽  
pp. 105-142 ◽  
Author(s):  
Ljiljana D. Milic ◽  
Miroslav D. Lutovac
Keyword(s):  
Digital Filter ◽  
Filter Design ◽  
Narrow Band ◽  
Sampling Rate ◽  
Wide Band ◽  
Digital Filter Design ◽  
Iir Filter ◽  
Design And Implementation ◽  
Sampling Rate Conversion ◽  
Rate Conversion

Application of multirate techniques to improve digital filter design and implementation are considered in this chapter. FIR and IIR filter design and implementation for sampling rate conversion by integer and rational factors are presented. Sharp narrow-band and wide-band multirate design techniques are discussed. Accurate designs of FIR and IIR half-band filters are described in detail. Several examples are provided to illustrate the multirate approach to filter design.

scholarly journals Broadband push-pull power amplifier design methodology based on the GaN component base for high-performance nonlinear junction detectors

2019 ◽  
Vol 30 ◽  
pp. 01011
Author(s):  
Vladimir Klokov ◽  
Nikolay Kargin ◽  
Alexander Garmash ◽  
Ekaterina Guzniaeva
Keyword(s):  
Theoretical Model ◽  
Output Power ◽  
Power Amplifier ◽  
High Performance ◽  
Design Methodology ◽  
Wide Band ◽  
Signal Power ◽  
Large Signal ◽  
Amplifier Design ◽  
Gain Characteristic

The paper presents a description of design methodology for wide-band push-pull large-signal power amplifier based on GaN transistor with an output power of more than 10 W for high-performance Nonlinear Junction Detectors, which allows achieving optimal convergence of the theoretical model in practice, as well as increasing the efficiency of the power amplifier while maintaining a linear gain characteristic.

Sign in / Sign up

Export Citation Format

Share Document