Determining Selected Bio-Engineering Properties of Olives Part II. Ease of Detachment: Reciprocating Motion

1965 ◽  
Vol 8 (2) ◽  
pp. 0273-0274
Author(s):  
L. H. Lamouria and H. L. Brewer
Keyword(s):  
Engineering Properties ◽  
Reciprocating Motion ◽  
Bio Engineering

Improvement in the Engineering Properties of Clayey Soil Using Sodium Chloride

2020 ◽  
Author(s):  
Harpinder Pal Singh ◽  
Jaspreet Singh Chana ◽  
Gurpreet Singh ◽  
Hardev Singh ◽  
Manvir Singh
Keyword(s):  
Sodium Chloride ◽  
Clayey Soil ◽  
Engineering Properties

Experimental Investigation of aluminum doping crumb rubber/epoxy composite in reciprocating motion

2015 ◽  
Vol 3 ◽  
pp. 1
Author(s):  
Goutam Chandra Karar ◽  
Nipu Modak
Keyword(s):  
Experimental Investigation ◽  
Coefficient Of Friction ◽  
Epoxy Composite ◽  
Normal Load ◽  
Crumb Rubber ◽  
The Other ◽  
Reciprocating Motion ◽  
Molding Process ◽  
Friction Tester ◽  
The Coefficient Of Friction

The experimental investigation of reciprocating motion between the aluminum doped crumb rubber /epoxy composite and the steel ball has been carried out under Reciprocating Friction Tester, TR-282 to study the wear and coefficient of frictions using different normal loads (0.4Kg, 0.7Kgand1Kg), differentfrequencies (10Hz, 25Hz and 40Hz).The wear is a function of normal load, reciprocating frequency, reciprocating duration and the composition of the material. The percentage of aluminum presents in the composite changesbut the other components remain the same.The four types of composites are fabricated by compression molding process having 0%, 10%, 20% and 30% Al. The effect of different parameters such as normal load, reciprocating frequency and percentage of aluminum has been studied. It is observed that the wear and coefficient of friction is influenced by the parameters. The tendency of wear goes on decreasing with the increase of normal load and it is minimum for a composite having 10%aluminum at a normal load of 0.7Kg and then goes on increasing at higher loads for all types of composite due to the adhesive nature of the composite. The coefficient of friction goes on decreasing with increasing normal loads due to the formation of thin film as an effect of heat generation with normal load.

Sign in / Sign up

Export Citation Format

Share Document