Selected Synthesis of CuS Nanotubes and Hollow Nanospheres at Room Temperature

2007 ◽  
Vol 7 (12) ◽  
pp. 4501-4507 ◽  
Author(s):  
Xiaoyan Liu ◽  
Guangcheng Xi ◽  
Yankuan Liu ◽  
Shenglin Xiong ◽  
Lanlan Chai ◽  
...  

A solution route has been developed to synthesize covellite (CuS) nanostructures through the precitation reaction of CuCl2 · 2H2O, thiourea (Tu), and NaHCO3 in distilled water at room temperature. By regulating the concentration of Tu, CuS nanotubes and hollow nanospheres with diameters of 100–200 nm have been selectively prepared. Structural characterizations indicate that both nanotubes and hollow spheres are composed of CuS nanoparticles with diameters of about 5–10 nm. UV-Vis absorption and room temperature photoluminescence (PL) spectra display different morphology-related absorption phenomena for nanotubes and hollow nanospheres. A systematic investigation has been carried out to understand the factors influencing the CuS morphology. Two different routes are identified to explain the formation of the nanotubes and hollow nanospheres herein.

1992 ◽  
Vol 284 ◽  
Author(s):  
C. Savall ◽  
E. Bustarret ◽  
J. P. Stoquert ◽  
J. C. Bruyére

ABSTRACTWe present the changes upon isochronous annealing in the room temperature photoluminescence (PL) spectra of nearly stoichiometric silicon nitride. Samples are prepared by the 50kHz PECVD of a N2/SiH4/Helium gas mixture at 350°C. In the as-deposited films the hydrogen content was around 11% for a refractive index of 1.98. For a photoexcitation at 351 nm, the polarized PL spectrum of the as-deposited film is characterized by a main broad emission band in the visible region with a maximum at 2.55eV. A second narrow peak (FWHM = 55meV), at 3.02eV is observed. We study the evolution of the PL spectra with different isochronous anneals from 350°C to 1000°C. Even though the general shape of the PL spectra does not change, we observe an increase of quantum efficiency with maximum value upon 750°C annealing. Beyond this temperature the low energy part of the PL spectrum shows a slight increase. These variations are compared to those of the infrared absorption peaks measured on the same samples. Both the temperature dependence of the intensity of a well defined absorption peak in the Si-H stretching mode region and that of the PL features can be explained assuming that solid state chemical reactions involving hydrogen and Si-Si bonds occur in the bulk of the alloy.


2011 ◽  
Vol 284-286 ◽  
pp. 2276-2279 ◽  
Author(s):  
Hua Zhang ◽  
Jun Cheng Liu ◽  
Jiao Li

A active Cl-doping for photoluminescent ZnS powder has been carried out by thermal decomposed AlCl3·6H2O in a quartz tube. Room temperature photoluminescence of the Cl-doped ZnS powder has been investigated using a photoluminescence spectrometer with 365 nm excitation wave length. A strong blue photoluminescence with maximum peak about 450 nm and green photoluminescence with maximum peak about 500 nm can be observed if the doping temperature in range of 800 ~ 900 °C and 1100 ~1200 °C, respectively. The structural characterizations of the Cl-doped ZnS powders were performed with X-ray diffraction (XRD) and the mechanism of photoluminescence was preliminarily discussed.


2010 ◽  
Vol 645-648 ◽  
pp. 355-358 ◽  
Author(s):  
Rii Hirano ◽  
Michio Tajima ◽  
Kohei M. Itoh

We investigated the optical properties of stacking faults (SFs) in cubic silicon carbide by photoluminescence (PL) spectroscopy and mapping. The room-temperature PL spectra consisted of a 2.3 eV peak due to nitrogen and two undefined broad peaks at 1.7 eV and 0.95 eV. On the PL intensity mapping for the 2.3 eV peak, SFs appeared as dark lines. SFs which expose carbon atoms (SFC) and silicon atoms (SFSi) on the surface appeared as bright lines and dark lines, respectively, in PL mapping for the 1.7 eV and 0.95 eV peaks. We believe the two undefined peaks are associated with SFC. This technique allows us to detect SFs nondestructively and to distinguish between SFC and SFSi. We further suggest the presence of inhomogeneous stress around SFCs based on the broadening of the 2.3 eV peak.


2011 ◽  
Vol 2011 ◽  
pp. 1-10 ◽  
Author(s):  
Lin Tan ◽  
Lihong Wang ◽  
Yude Wang

SnO2hollow spheres and nanorods were prepared by an aqueous sol-gel route involving the reaction of tin chloride and sodium dodecyl sulphate (SDS) in hexanol and heptane under the different hydrothermal treating temperature and time. X-ray diffraction (XRD) spectra, Fourier transformed infrared (FTIR) spectrum, scanning electron microscopy (SEM), transmission electron microscopy (TEM), high-resolution TEM (HRTEM) and Raman spectroscopy were used to examine the morphology and microstructure to find out the cause. The result indicates that the products are hollow spheres with diameters of approximately 200–900 nm and shell thickness of 60–70 nm via hydrothermal treating at 160°C and one-dimensional rod-like nanostructures with diameters of approximately 20–40 nm and lengths of 100–300 nm via hydrothermal treating at 180 and 200°C, respectively. Room-temperature photoluminescence (PL) properties were investigated under the excitation of 275 nm. The samples exhibited the emission peaks of room-temperature photoluminescence.


2011 ◽  
Vol 399-401 ◽  
pp. 967-972
Author(s):  
Qi Xiao ◽  
Gao Yuan Zhu

The Sm3+-Doped La2O3powders were prepared by precipitation method. The room temperature photoluminescence (PL) spectra of Sm3+-Doped La2O3powders doped with different Sm3+concentration excited at 405 nm have been investigated. The PL spectra showed three main strong emissions peaks at near 572, 613, and 657 nm, which were due to the f-f forbidden transitions of the 4f electrons of Sm3+, corresponding to4G5/2→6H5/2(572 nm),6H7/2(613 nm), and6H9/2(657 nm), respectively. The optimum Sm3+concentration in La2O3powders for optical emission was determined to be 2.0 %. Since the 2% Sm-doped La2O3 offer a rather strong f–f transition excitation in near the UV region, the as-prepared phosphors are likely to be used as potential red phosphors for near-ultraviolet (370-410 nm) light-emitting diodes (LEDs).


Author(s):  
P. A. Madden ◽  
W. R. Anderson

The intestinal roundworm of swine is pinkish in color and about the diameter of a lead pencil. Adult worms, taken from parasitized swine, frequently were observed with macroscopic lesions on their cuticule. Those possessing such lesions were rinsed in distilled water, and cylindrical segments of the affected areas were removed. Some of the segments were fixed in buffered formalin before freeze-drying; others were freeze-dried immediately. Initially, specimens were quenched in liquid freon followed by immersion in liquid nitrogen. They were then placed in ampuoles in a freezer at −45C and sublimated by vacuum until dry. After the specimens appeared dry, the freezer was allowed to come to room temperature slowly while the vacuum was maintained. The dried specimens were attached to metal pegs with conductive silver paint and placed in a vacuum evaporator on a rotating tilting stage. They were then coated by evaporating an alloy of 20% palladium and 80% gold to a thickness of approximately 300 A°. The specimens were examined by secondary electron emmission in a scanning electron microscope.


2003 ◽  
Vol 769 ◽  
Author(s):  
Asha Sharma ◽  
Deepak ◽  
Monica Katiyar ◽  
Satyendra Kumar ◽  
V. Chandrasekhar ◽  
...  

AbstractThe optical degradation of polysilane copolymer has been studied in spin cast thin films and solutions using light source of 325 nm wavelength. The room temperature photoluminescence (PL) spectrum of these films show a sharp emission at 368 nm when excited with a source of 325 nm. However, the PL intensity deteriorates with time upon light exposure. Further the causes of this degradation have been examined by characterizing the material for its transmission behaviour and changes occurring in molecular weight as analysed by GPC data.


ACS Photonics ◽  
2021 ◽  
Author(s):  
Tomojit Chowdhury ◽  
Kiyoung Jo ◽  
Surendra B. Anantharaman ◽  
Todd H. Brintlinger ◽  
Deep Jariwala ◽  
...  

1985 ◽  
Vol 25 (06) ◽  
pp. 945-953 ◽  
Author(s):  
Mark A. Miller ◽  
H.J. Ramey

Abstract Over the past 20 years, a number of studies have reported temperature effects on two-phase relative permeabilities in porous media. Some of the reported results, however, have been contradictory. Also, observed effects have not been explained in terms of fundamental properties known to govern two-phase flow. The purpose of this study was to attempt to isolate the fundamental properties affecting two-phase relative permeabilities at elevated temperatures. Laboratory dynamic-displacement relative permeability measurements were made on unconsolidated and consolidated sand cores with water and a refined white mineral oil. Experiments were run on 2-in. [5.1-cm] -diameter, 20-in. [52.-cm] -long cores from room temperature to 300F [149C]. Unlike previous researchers, we observed essentially no changes with temperature in either residual saturations or relative permeability relationships. We concluded that previous results may have been affected by viscous previous results may have been affected by viscous instabilities, capillary end effects, and/or difficulties in maintaining material balances. Introduction Interest in measuring relative permeabilities at elevated temperatures began in the 1960's with petroleum industry interest in thermal oil recovery. Early thermal oil recovery field operations (well heaters, steam injection, in-situ combustion) indicated oil flow rate increases far in excess of what was predicted by viscosity reductions resulting from heating. This suggested that temperature affects relative permeabilities. One of the early studies of temperature effects on relative permeabilities was presented by Edmondson, who performed dynamic displacement measurements with crude performed dynamic displacement measurements with crude and white oils and distilled water in Berea sandstone cores. Edmondson reported that residual oil saturations (ROS's) (at the end of 10 PV's of water injected) decreased with increasing temperature. Relative permeability ratios decreased with temperature at high water saturations but increased with temperature at low water saturations. A series of elevated-temperature, dynamic-displacement relative permeability measurements on clean quartz and "natural" unconsolidated sands were reported by Poston et al. Like Edmondson, Poston et al. reported a decrease in the "practical" ROS (at less than 1 % oil cut) as temperature increased. Poston et al. also reported an increase in irreducible water saturation. Although irreducible water saturations decreased with decreasing temperature, they did not revert to the original room temperature values. It was assumed that the cores became increasingly water-wet with an increase in both temperature and time; measured changes of the IFT and the contact angle with temperature increase, however, were not sufficient to explain observed effects. Davidson measured dynamic-displacement relative permeability ratios on a coarse sand and gravel core with permeability ratios on a coarse sand and gravel core with white oil displaced by distilled water, nitrogen, and superheated steam at temperatures up to 540F [282C]. Starting from irreducible water saturation, relative permeability ratio curves were similar to Edmondson's. permeability ratio curves were similar to Edmondson's. Starting from 100% oil saturation, however, the curves changed significantly only at low water saturations. A troublesome aspect of Davidson's work was that he used a hydrocarbon solvent to clean the core between experiments. No mention was made of any consideration of wettability changes, which could explain large increases in irreducible water saturations observed in some runs. Sinnokrot et al. followed Poston et al.'s suggestion of increasing water-wetness and performed water/oil capillary pressure measurements on consolidated sandstone and limestone cores from room temperature up to 325F [163C]. Sinnokrot et al confirmed that, for sandstones, irreducible water saturation appeared to increase with temperature. Capillary pressures increased with temperature, and the hysteresis between drainage and imbibition curves reduced to essentially zero at 300F [149C]. With limestone cores, however, irreducible water saturations remained constant with increase in temperature, as did capillary pressure curves. Weinbrandt et al. performed dynamic displacement experiments on small (0.24 to 0.49 cu in. [4 to 8 cm3] PV) consolidated Boise sandstone cores to 175F [75C] PV) consolidated Boise sandstone cores to 175F [75C] with distilled water and white oil. Oil relative permeabilities shifted toward high water saturations with permeabilities shifted toward high water saturations with increasing temperature, while water relative permeabilities exhibited little change. Weinbrandt et al. confirmed the findings of previous studies that irreducible water saturation increases and ROS decreases with increasing temperature. SPEJ P. 945


Sign in / Sign up

Export Citation Format

Share Document