Simultaneous Resonance of Soft AC Doubly Actuated MEMS Resonators

2014 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Christian Reyes
Keyword(s):  
Natural Frequency ◽  
Phase Difference ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
The Other ◽  
Voltage Amplitude ◽  
Amplitude Response ◽  
Electrostatically Actuated ◽  
Mems Resonators ◽  
Voltage Phase

This paper deals with electrostatically actuated microelectromechanical (MEMS) cantilever resonators under soft AC double actuation. The cantilever is between two parallel ground plates. The two AC frequencies are one near half natural frequency, and the other near natural frequency. There is a phase difference between the two voltages. The system undergoes a simultaneous resonance. The voltage-amplitude response is investigated. The effects of the second voltage, phase difference between voltages, and frequency on the response are reported. The method of multiple scales is used in this paper.

Boundary Value Problem Method to Investigate Superharmonic Resonance of MEMS Resonators

2017 ◽  
Author(s):  
Julio Beatriz ◽  
Martin Botello ◽  
Christian Reyes ◽  
Dumitru I. Caruntu
Keyword(s):  
Differential Equation ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Equation Of Motion ◽  
The Other ◽  
Superharmonic Resonance ◽  
Electrostatically Actuated ◽  
Amplitude Frequency Response ◽  
Problem Method ◽  
Mems Resonators

This paper deals with two different methods to analyze the amplitude frequency response of an electrostatically actuated micro resonator. The methods used in this paper are the method of multiple scales, which is an analytical method with one mode of vibration. The other method is based on system of odes which is derived using the partial differential equation of motion, as well as the boundary conditions. This system is then solved using a built in matlab function known as BVP4C. Results are then shown comparing the two methods, under a variety of parameters, including the influence of damping, voltage, and fringe.

Reduced Order Model of Electrostatically Actuated MEMS Resonators Resonance Near Half Natural Frequency

2012 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Israel Martinez ◽  
Martin W. Knecht
Keyword(s):  
Frequency Response ◽  
Natural Frequency ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Reduced Order Model ◽  
Order Model ◽  
Reduced Order ◽  
Electrostatically Actuated ◽  
Amplitude Frequency Response ◽  
Mems Resonators

This paper uses the Reduced Order Model (ROM) method to investigate the influence of nonlinearities from parametric electrostatic excitation due to soft AC voltage of frequency near half natural frequency of the MEMS cantilever resonator on its frequency response. Most of the analysis in literature investigates pull-in phenomenon, stability, amplitude–frequency relations, or finds time responses of such systems. In this work it is showed that the bifurcation points in the amplitude-frequency response occur at lower frequencies and amplitudes than predicted by the Method of Multiple Scales (MMS), a perturbation method. This result is extremely important for predicting pull-in phenomena. Also the ROM predicts pull-in instability for large initial amplitudes and AC frequencies less than half natural frequency of the resonator. MMS fails to predict this behavior. Increasing the damping and/or decreasing the voltage increases the frequency at which the system undergoes into a pull-in phenomenon.

Voltage Response of Primary Resonance of Electrostatically Actuated MEMS Clamped Circular Plate Resonators

2016 ◽  
Vol 11 (4) ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Reynaldo Oyervides
Keyword(s):  
Natural Frequency ◽  
Multiple Scales ◽  
Primary Resonance ◽  
Micro Electro Mechanical System ◽  
Voltage Response ◽  
Voltage Amplitude ◽  
Amplitude Response ◽  
Weakly Nonlinear ◽  
Electrostatically Actuated ◽  
Sensing Applications

This paper investigates the voltage–amplitude response of soft alternating current (AC) electrostatically actuated micro-electro-mechanical system (MEMS) clamped circular plates for sensing applications. The case of soft AC voltage of frequency near half natural frequency of the plate is considered. Soft AC produces small to very small amplitudes away from resonance zones. Nearness to half natural frequency results in primary resonance of the system, which is investigated using the method of multiple scales (MMS) and numerical simulations using reduced order model (ROM) of seven terms (modes of vibration). The system is assumed to be weakly nonlinear. Pull-in instability of the voltage–amplitude response and the effects of detuning frequency and damping on the response are reported.

Near Three Half Natural Frequency Resonance of Electrostatically Actuated MEMS Resonators

2010 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Martin W. Knecht
Keyword(s):  
Natural Frequency ◽  
Casimir Force ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Electrostatic Force ◽  
Direct Approach ◽  
Electrostatically Actuated ◽  
Mems Resonators ◽  
Phase Amplitude ◽  
Fringe Effect

This paper investigates electrostatically actuated micro resonators response near three half natural frequency. Electrostatic force including fringe effect and Casimir force are included in the model. These forces introduce parametric nonlinear terms in the system. The partial-differential equation of motion of the system is solved by using the method of multiple scales. A direct approach of the problem is then used. Two approximation problems resulting from the direct approach are solved. Phase-amplitude relationship is obtained. Numerical results for electrostatically actuated uniform micro resonator sensors are provided.

scholarly journals Voltage–Amplitude Response of Superharmonic Resonance of Second Order of Electrostatically Actuated MEMS Cantilever Resonators

2019 ◽  
Vol 14 (3) ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Martin A. Botello ◽  
Christian A. Reyes ◽  
Julio S. Beatriz
Keyword(s):  
Numerical Integration ◽  
Multiple Scales ◽  
Low Voltage ◽  
Second Order ◽  
Voltage Amplitude ◽  
Amplitude Response ◽  
Superharmonic Resonance ◽  
Bifurcation Points ◽  
Electrostatically Actuated ◽  
Modes Of Vibration

This paper investigates the voltage–amplitude response of superharmonic resonance of second order (order two) of alternating current (AC) electrostatically actuated microelectromechanical system (MEMS) cantilever resonators. The resonators consist of a cantilever parallel to a ground plate and under voltage that produces hard excitations. AC frequency is near one-fourth of the natural frequency of the cantilever. The electrostatic force includes fringe effect. Two kinds of models, namely reduced-order models (ROMs), and boundary value problem (BVP) model, are developed. Methods used to solve these models are (1) method of multiple scales (MMS) for ROM using one mode of vibration, (2) continuation and bifurcation analysis for ROMs with several modes of vibration, (3) numerical integration for ROM with several modes of vibration, and (4) numerical integration for BVP model. The voltage–amplitude response shows a softening effect and three saddle-node bifurcation points. The first two bifurcation points occur at low voltage and amplitudes of 0.2 and 0.56 of the gap. The third bifurcation point occurs at higher voltage, called pull-in voltage, and amplitude of 0.44 of the gap. Pull-in occurs, (1) for voltage larger than the pull-in voltage regardless of the initial amplitude and (2) for voltage values lower than the pull-in voltage and large initial amplitudes. Pull-in does not occur at relatively small voltages and small initial amplitudes. First two bifurcation points vanish as damping increases. All bifurcation points are shifted to lower voltages as fringe increases. Pull-in voltage is not affected by the damping or detuning frequency.

Reduced Order Model for MEMS Cantilever Resonators Under Soft AC Voltage Near Natural Frequency

2012 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Israel Martinez
Keyword(s):  
Natural Frequency ◽  
Nonlinear Response ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Electrostatic Force ◽  
Reduced Order Model ◽  
Order Model ◽  
Reduced Order ◽  
First Order ◽  
Electrostatically Actuated

The nonlinear response of an electrostatically actuated cantilever beam microresonator is investigated. The AC voltage is of frequency near resonator’s natural frequency. A first order fringe correction of the electrostatic force and viscous damping are included in the model. The dynamics of the resonator is investigated using the Reduced Order Model (ROM) method, based on Galerkin procedure. Steady-state motions are found. Numerical results for the uniform microresonator are compared with those obtained via the Method of Multiple Scales (MMS).

Casimir and Van der Waals Effects on Voltage Response of Electrostatically Actuated MEMS/NEMS Plates

2015 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Reynaldo Oyervides ◽  
Valeria Garcia
Keyword(s):  
Natural Frequency ◽  
Parametric Resonance ◽  
Electrostatic Force ◽  
Van Der Waals ◽  
Van Der Waals Forces ◽  
Voltage Response ◽  
Voltage Amplitude ◽  
Amplitude Response ◽  
Electrostatically Actuated ◽  
Ground Plate

This paper deals with electrostatically actuated MEMS plates. The model consists of a flexible MEMS plate above a parallel ground plate. An AC voltage of frequency near natural frequency of the plate provides the electrostatic force that actuates the flexible MEMS plate. This leads to parametric resonance. The effect of Casimir and/or van der Waals forces on the voltage-amplitude response of the plate is investigated.

Sensitivity of MEMS/NEMS Biosensors Near Twice Natural Frequency

2010 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Martin W. Knecht
Keyword(s):  
Natural Frequency ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Casimir Effect ◽  
Electrostatic Force ◽  
Equation Of Motion ◽  
Direct Approach ◽  
Mass Detection ◽  
Electrostatically Actuated ◽  
Phase Amplitude

Bio-MEMS/NEMS resonator sensors near twice natural frequency for mass detection are investigated. Electrostatic force along with fringe correction and Casimir effect are included in the model. They introduce parametric nonlinear terms in the system. The partial-differential equation of motion of the system is solved by using the method of multiple scales. A direct approach of the problem is then used. Two approximation problems resulting from the direct approach are solved. Phase-amplitude relationship is obtained. Numerical results for uniform electrostatically actuated micro resonator sensors are reported.

Primary Resonance Voltage Response of Electrostatically Actuated M/NEMS Circular Plate Resonators

2014 ◽  
Author(s):  
Dumitru I. Caruntu ◽  
Reynaldo Oyervides
Keyword(s):  
Casimir Force ◽  
Multiple Scales ◽  
Method Of Multiple Scales ◽  
Excitation Frequency ◽  
Primary Resonance ◽  
Voltage Response ◽  
Circular Plates ◽  
Amplitude Response ◽  
Weakly Nonlinear ◽  
Electrostatically Actuated

This paper investigates the voltage-amplitude response of soft AC electrostatically actuated M/NEMS clamped circular plates. AC frequency is near half natural frequency of the plate. This results in primary resonance. The system is analytically modeled using the Method of Multiple Scales (MMS). The system is assumed weakly nonlinear. The behavior of the system including pull-in instability as the AC voltage is swept up and down while the excitation frequency is constant is reported. The effects of detuning frequency, damping, Casimir force, and van der Waals force are reported as well.

Sign in / Sign up

Export Citation Format

Share Document