Porous Wall Gas Lubricated Journal Bearings: Experimental Investigation

1979 ◽  
Vol 101 (4) ◽  
pp. 466-473 ◽  
Author(s):  
E. P. Gargiulo
Keyword(s):  
Journal Bearing ◽  
Dynamic Stiffness ◽  
Porous Wall ◽  
Companion Paper ◽  
Quantitative Agreement ◽  
Journal Bearings ◽  
Test Apparatus ◽  
Unstable Vibration ◽  
Unsteady Characteristics ◽  
Stiffness And Damping

A model has been developed to compute the dynamic stiffness and damping properties of externally pressurized, porous-wall, gas journal bearings. The derivation of this model is described in a companion paper. A special test apparatus was constructed to experimentally investigate the steady and unsteady characteristics of a 51-mm diameter by 51-mm long journal bearing. Tests are described for a bearing pressurized to 0.412 MN/m2 at journal speeds up to 20,000 rpm over a range of clearances. Experimental results are compared to those of the theoretical model and show good quantitative agreement for diametral clearances of 25 μm and larger. Reasonable qualitative agreement is shown for smaller clearances. In addition, an unstable vibration phenomenon was discovered and briefly investigated.

Porous Wall Gas Lubricated Journal Bearings: Theoretical Investigation

1979 ◽  
Vol 101 (4) ◽  
pp. 458-465 ◽  
Author(s):  
E. P. Gargiulo
Keyword(s):  
Experimental Investigation ◽  
Dynamic Stiffness ◽  
Porous Wall ◽  
Companion Paper ◽  
Journal Bearings ◽  
Damping Properties ◽  
Governing Equations ◽  
Performance Curves ◽  
Unsteady Characteristics ◽  
Stiffness And Damping

A model has been developed to compute the dynamic stiffness and damping properties of externally pressurized, porous-wall, gas journal bearings which includes the effects of journal rotation and eccentricity. This paper presents the derivation of the governing equations and the perturbation analysis used to find the unsteady characteristics. Typical nondimensional performance curves are found and the influences of seven governing parameters are discussed. A companion paper describes an experimental investigation of porous journal bearings.

Dynamic Stiffness and Damping Coefficients of Aerostatic, Porous, Journal Bearings

1978 ◽  
Vol 20 (5) ◽  
pp. 291-296 ◽  
Author(s):  
N. S. Rao ◽  
B. C. Majumdar
Keyword(s):  
Continuity Equation ◽  
Reynolds Equation ◽  
Journal Bearing ◽  
Dynamic Pressure ◽  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Operating Conditions ◽  
Damping Coefficients ◽  
Design Charts ◽  
Stiffness And Damping

A periodic (displacement) disturbance is imposed on an aerostatic, porous, journal bearing of finite length under steady-state conditions. The dynamic pressure distribution is obtained by a pressure perturbation analysis of Reynolds equation and a modified flow continuity equation in a porous medium. Dynamic stiffness and damping coefficients for different operating conditions are calculated numerically, using a digital computer, and presented in the form of design charts.

Steady-State and Dynamic Behaviour of Multi-Recess Hybrid Oil Journal Bearings

1979 ◽  
Vol 21 (5) ◽  
pp. 345-351 ◽  
Author(s):  
M. K. Ghosh ◽  
B. C. Majumdar ◽  
J. S. Rao
Keyword(s):  
Perturbation Theory ◽  
Steady State ◽  
Theoretical Analysis ◽  
Dynamic Behaviour ◽  
Journal Bearing ◽  
Load Capacity ◽  
Journal Bearings ◽  
Time Dependent ◽  
Damping Coefficients ◽  
Stiffness And Damping

A theoretical analysis of the steady-state and dynamic characteristics of multi-recess hybrid oil journal bearings is presented. A perturbation theory for small vibrations is used to solve an incompressible, finite journal bearing with a time-dependent term. Load capacity, attitude angle, friction parameter, stiffness and damping coefficients are evaluated for a capillary-compensated bearing.

scholarly journals Dynamic Stiffness and Damping Characteristics of a High-Temperature Air Foil Journal Bearing

2001 ◽  
Vol 44 (4) ◽  
pp. 657-663 ◽  
Author(s):  
Samuela Howard ◽  
Christopher Dellacorte ◽  
Mark J. Valco ◽  
Joseph M. Prahl ◽  
Hooshang Heshmat
Keyword(s):  
High Temperature ◽  
Journal Bearing ◽  
Dynamic Stiffness ◽  
Damping Characteristics ◽  
Stiffness And Damping

Advancements in the Structural Stiffness and Damping of a Large Compliant Foil Journal Bearing: An Experimental Study

2004 ◽  
Vol 129 (1) ◽  
pp. 154-161 ◽  
Author(s):  
Mohsen Salehi ◽  
Hooshang Heshmat ◽  
James F. Walton
Keyword(s):  
Journal Bearing ◽  
Dynamic Stiffness ◽  
Operating Conditions ◽  
Test Facility ◽  
Squeeze Film ◽  
Structural Stiffness ◽  
Low Frequencies ◽  
Equivalent Viscous Damping ◽  
Damping Characteristics ◽  
Stiffness And Damping

This paper presents the results of an experimental investigation into the dynamic structural stiffness and damping characteristics of a 21.6‐cm(8.5in.)-diameter compliant surface foil journal bearing. The goal of this development was to achieve high levels of damping without the use of oil, as is used in squeeze film dampers, while maintaining a nearly constant dynamic stiffness over a range of frequencies and amplitudes of motion. In the experimental work described herein, a full compliant foil bearing was designed, fabricated, and tested. The test facility included a non-rotating journal located inside the bearing. The journal was connected to an electrodynamic shaker so that dynamic forces simulating expected operating conditions could be applied to the structurally compliant bump foil elements. Excitation test frequencies to a maximum of 400Hz at amplitudes of motion between 25.4 and 102μm were applied to the damper assembly. During testing, both compressive preload and unidirectional static loads of up to 1335 and 445N, respectively, were applied to the damper assembly. The experimental data from these tests were analyzed using both a single degree of freedom model and an energy method. These methods of data analysis are reviewed here and results are compared. Excellent agreement in results obtained from the two methods was achieved. Equivalent viscous damping coefficients as high as 1050N.s∕cm(600lbf.s∕in) were obtained at low frequencies. Dynamic stiffness was shown to be fairly constant with frequency.

Advancements in the Structural Stiffness and Damping of a Large Compliant Foil Journal Bearing: An Experimental Study

2004 ◽  
Author(s):  
Mohsen Salehi ◽  
Hooshang Heshmat ◽  
James F. Walton
Keyword(s):  
Journal Bearing ◽  
Dynamic Stiffness ◽  
Operating Conditions ◽  
Test Facility ◽  
Squeeze Film ◽  
Structural Stiffness ◽  
Low Frequencies ◽  
Equivalent Viscous Damping ◽  
Damping Characteristics ◽  
Stiffness And Damping

This paper presents the results of an experimental investigation into the dynamic structural stiffness and damping characteristics of a 21.6 cm (8.5inch) diameter compliant surface foil journal bearing. The goal of this development was to achieve high levels of damping without the use of oil, as is used in squeeze film dampers, while maintaining a nearly constant dynamic stiffness over a range of frequencies and amplitudes of motion. In the experimental work described herein, a full compliant foil bearing was designed, fabricated and tested. The test facility included a non-rotating journal located inside the bearing. The journal was connected to an electrodynamic shaker so that dynamic forces simulating expected operating conditions could be applied to the structurally compliant bump foil elements. Excitation test frequencies to a maximum of 400 Hz at amplitudes of motion between 25.4μm to 102μm were applied to the damper assembly. During testing, both compressive preload and unidirectional static loads of up to 1335N and 445N, respectively, were applied to the damper assembly. The experimental data from these tests were analyzed using both a single degree of freedom model and an energy method. These methods of data analysis are reviewed here and results are compared. Excellent agreement in results obtained from the two methods was achieved. Equivalent viscous damping coefficients as high as 1050 N.s/cm (600 lbf.s/in) were obtained at low frequencies. Dynamic stiffness was shown to be fairly constant with frequency.

scholarly journals Alternation of the dynamic coefficients of short journal bearings due to wear

2015 ◽  
Vol 6 (5) ◽  
pp. 649-664
Author(s):  
Michael G. Papanikolaou ◽  
Michael G. Farmakopoulos ◽  
Chris A. Papadopoulos
Keyword(s):  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Fe Analysis ◽  
Operating Conditions ◽  
Wear Depth ◽  
Content Type ◽  
Damping Coefficients ◽  
Dynamic Coefficients ◽  
Low Viscosity ◽  
Stiffness And Damping

Purpose – Wear in journal bearings occurs when the operating conditions (high load, high temperature, low angular velocity or low viscosity), downgrade the ability of the bearing to carry load. The wear depth increases because the rotor comes in contact with the bearing surface. Wear in journal bearings affects their characteristics because of its influence on the thickness of the fluid film. This influence can be detected in the dynamic behavior of the rotor and especially in the dynamic stiffness and damping coefficients. The paper aims to discuss these issues. Design/methodology/approach – In this paper, the effect of wear on the rotor dynamic stiffness and damping coefficients (K and C) of a short journal bearing is investigated. K and C in this work are estimated by using two methods a semi-analytical method and finite element (FE) analysis implemented in the ANSYS software. Findings – The main goal of this research is to make the identification of wear in journal bearings feasible by observing the alternation of their dynamic coefficients. Both of the methods implemented are proven to be useful, while FE analysis can provide more accurate results. Originality/value – This paper is original and has not been published elsewhere.

Research on the Static and Dynamic Characteristics of Misaligned Journal Bearing Considering the Turbulent and Thermohydrodynamic Effects

2015 ◽  
Vol 137 (2) ◽  
Author(s):  
Guohui Xu ◽  
Jian Zhou ◽  
Haipeng Geng ◽  
Mingjian Lu ◽  
Lihua Yang ◽  
...  
Keyword(s):  
Film Thickness ◽  
Dynamic Characteristics ◽  
Journal Bearing ◽  
Journal Bearings ◽  
Static And Dynamic Characteristics ◽  
Oil Film ◽  
Stiffness And Damping ◽  
Film Stiffness ◽  
Journal Misalignment ◽  
Oil Film Pressure

Journal misalignment usually exists in journal bearings that affect nearly all the bearings static and dynamic characteristics including minimum oil film thickness, maximum oil film pressure, maximum oil film temperature, oil film stiffness, and damping. The main point in this study is to provide a comprehensive analysis on the oil film pressure, oil film temperature, oil film thickness, load-carrying capacity, oil film stiffness, and damping of journal bearing with different misalignment ratios and appropriately considering the turbulent and thermo effects based on solving the generalized Reynolds equation and energy equation. The results indicate that the oil thermo effects have a significant effect on the lubrication of misaligned journal bearings under large eccentricity ratio. The turbulent will obviously affect the lubrication of misaligned journal bearings when the eccentricity or misalignment ratio is large. In the present design of the journal bearing, the load and speed become higher and higher, and the eccentricity and misalignment ratio are usually large in the operating conditions. Therefore, it is necessary to take the effects of journal misalignment, turbulent, and thermal effect into account in the design and analysis of journal bearings.

Effects of Turbulence and Viscosity Variation on the Dynamic Coefficients of Fluid Film Journal Bearings

1985 ◽  
Vol 107 (2) ◽  
pp. 256-261 ◽  
Author(s):  
D. F. Wilcock ◽  
O. Pinkus
Keyword(s):  
High Speed ◽  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Fluid Film ◽  
Turbulent Regime ◽  
Dynamic Coefficients ◽  
Damping Characteristics ◽  
Fluid Film Bearings ◽  
Viscosity Variation ◽  
Stiffness And Damping

Many high-speed or large fluid film bearings operate in the turbulent regime. However, relatively little consideration has been given to the effects of turbulence and of the variation in viscosity on the dynamic stiffness and damping characteristics of the bearings. Since the dynamic behavior of the rotor supported on such bearings is often closely tied to the bearing dynamic coefficients, knowledge of them may be critical to both the design and the in-place correction of rotor instabilities. These effects are here considered in some detail on the basis of computer calculated analytical results, both in general dimensionless terms and with regard to a specific numerical example.

Sign in / Sign up

Export Citation Format

Share Document