Porous Wall Gas Lubricated Journal Bearings: Theoretical Investigation

1979 ◽  
Vol 101 (4) ◽  
pp. 458-465 ◽  
Author(s):  
E. P. Gargiulo
Keyword(s):  
Experimental Investigation ◽  
Dynamic Stiffness ◽  
Porous Wall ◽  
Companion Paper ◽  
Journal Bearings ◽  
Damping Properties ◽  
Governing Equations ◽  
Performance Curves ◽  
Unsteady Characteristics ◽  
Stiffness And Damping

A model has been developed to compute the dynamic stiffness and damping properties of externally pressurized, porous-wall, gas journal bearings which includes the effects of journal rotation and eccentricity. This paper presents the derivation of the governing equations and the perturbation analysis used to find the unsteady characteristics. Typical nondimensional performance curves are found and the influences of seven governing parameters are discussed. A companion paper describes an experimental investigation of porous journal bearings.

Porous Wall Gas Lubricated Journal Bearings: Experimental Investigation

1979 ◽  
Vol 101 (4) ◽  
pp. 466-473 ◽  
Author(s):  
E. P. Gargiulo
Keyword(s):  
Journal Bearing ◽  
Dynamic Stiffness ◽  
Porous Wall ◽  
Companion Paper ◽  
Quantitative Agreement ◽  
Journal Bearings ◽  
Test Apparatus ◽  
Unstable Vibration ◽  
Unsteady Characteristics ◽  
Stiffness And Damping

A model has been developed to compute the dynamic stiffness and damping properties of externally pressurized, porous-wall, gas journal bearings. The derivation of this model is described in a companion paper. A special test apparatus was constructed to experimentally investigate the steady and unsteady characteristics of a 51-mm diameter by 51-mm long journal bearing. Tests are described for a bearing pressurized to 0.412 MN/m2 at journal speeds up to 20,000 rpm over a range of clearances. Experimental results are compared to those of the theoretical model and show good quantitative agreement for diametral clearances of 25 μm and larger. Reasonable qualitative agreement is shown for smaller clearances. In addition, an unstable vibration phenomenon was discovered and briefly investigated.

Design and Analysis of a Magnetorheological Fluid Mount Featuring Uni-Directional Squeeze Mode

2015 ◽  
Author(s):  
Xian-Xu Bai ◽  
Peng Chen ◽  
Li-Jun Qian ◽  
Ping Kan
Keyword(s):  
Dynamic Stiffness ◽  
Magnetorheological Fluid ◽  
Relative Displacement ◽  
Bottom Surface ◽  
Damping Properties ◽  
Damping Force ◽  
Equivalent Damping ◽  
Engine Vibration ◽  
Coil Winding ◽  
Stiffness And Damping

A magnetorheological fluid (MRF) mount featuring unidirectional squeeze mode for vehicle engine mounting system is proposed and designed to attenuate the engine vibration with characteristics of broadband and small amplitude. The MRF mount is comprised of upper and lower bases for installation, a main rubber for static load, a bobbin for electromagnetic coil winding and a squeeze plate. The bottom surface of the bobbin and the top surface of the squeeze plate form the polar plates, between which the MRF is squeezed during the rebound of the MRF mount. Combining dynamic stiffness property of passive hydraulic mounts without fluid and adjustable damping force of MRF at squeeze mode, the MRF mount could provide a unique variable dynamic stiffness and damping properties, by adjusting the exciting current. To evaluate the performance of the MRF mount, a mathematical model considering the behavior of MRF at squeeze mode is derived to theoretically analyze and numerically simulate the dynamic stiffness and equivalent damping properties of the MRF mount. Further, the MRF mount based quarter vehicle mounting system model considering suspension system is constructed to analyze the force transmissibility of engine mounting system in frequency domain and simulate the relative displacement response in time domain.

Dynamic Properties of Tilting-Pad Journal Bearings: Experimental and Theoretical Investigation of Frequency Effects due to Pivot Flexibility

2006 ◽  
Vol 129 (3) ◽  
pp. 865-869 ◽  
Author(s):  
Waldemar Dmochowski
Keyword(s):  
High Speed ◽  
Dynamic Properties ◽  
Three Dimensional ◽  
Journal Bearings ◽  
Operating Conditions ◽  
Damping Properties ◽  
Frequency Effects ◽  
Tilting Pad ◽  
Stiffness And Damping ◽  
Tilting Pad Journal Bearings

Tilting-pad journal bearings (TPJBs) dominate as rotor supports in high-speed rotating machinery. The paper analyzes frequency effects on the TPJB’s stiffness and damping characteristics based on experimental and theoretical investigations. The experimental investigation has been carried out on a five pad tilting-pad journal bearing of 98mm in diameter. Time domain and multifrequency excitation has been used to evaluate the dynamic coefficients. The calculated results have been obtained from a three-dimensional computer model of TPJB, which accounts for thermal effects, turbulent oil flow, and elastic effects, including that of pad flexibility. The analyzes of the TPJB’s stiffness and damping properties showed that the frequency effects on the bearing dynamic properties depend on the operating conditions and bearing design. It has been concluded that the pad inertia and pivot flexibility are behind the variations of the stiffness and damping properties with frequency of excitation.

scholarly journals Alternation of the dynamic coefficients of short journal bearings due to wear

2015 ◽  
Vol 6 (5) ◽  
pp. 649-664
Author(s):  
Michael G. Papanikolaou ◽  
Michael G. Farmakopoulos ◽  
Chris A. Papadopoulos
Keyword(s):  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Fe Analysis ◽  
Operating Conditions ◽  
Wear Depth ◽  
Content Type ◽  
Damping Coefficients ◽  
Dynamic Coefficients ◽  
Low Viscosity ◽  
Stiffness And Damping

Purpose – Wear in journal bearings occurs when the operating conditions (high load, high temperature, low angular velocity or low viscosity), downgrade the ability of the bearing to carry load. The wear depth increases because the rotor comes in contact with the bearing surface. Wear in journal bearings affects their characteristics because of its influence on the thickness of the fluid film. This influence can be detected in the dynamic behavior of the rotor and especially in the dynamic stiffness and damping coefficients. The paper aims to discuss these issues. Design/methodology/approach – In this paper, the effect of wear on the rotor dynamic stiffness and damping coefficients (K and C) of a short journal bearing is investigated. K and C in this work are estimated by using two methods a semi-analytical method and finite element (FE) analysis implemented in the ANSYS software. Findings – The main goal of this research is to make the identification of wear in journal bearings feasible by observing the alternation of their dynamic coefficients. Both of the methods implemented are proven to be useful, while FE analysis can provide more accurate results. Originality/value – This paper is original and has not been published elsewhere.

Effects of Turbulence and Viscosity Variation on the Dynamic Coefficients of Fluid Film Journal Bearings

1985 ◽  
Vol 107 (2) ◽  
pp. 256-261 ◽  
Author(s):  
D. F. Wilcock ◽  
O. Pinkus
Keyword(s):  
High Speed ◽  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Fluid Film ◽  
Turbulent Regime ◽  
Dynamic Coefficients ◽  
Damping Characteristics ◽  
Fluid Film Bearings ◽  
Viscosity Variation ◽  
Stiffness And Damping

Many high-speed or large fluid film bearings operate in the turbulent regime. However, relatively little consideration has been given to the effects of turbulence and of the variation in viscosity on the dynamic stiffness and damping characteristics of the bearings. Since the dynamic behavior of the rotor supported on such bearings is often closely tied to the bearing dynamic coefficients, knowledge of them may be critical to both the design and the in-place correction of rotor instabilities. These effects are here considered in some detail on the basis of computer calculated analytical results, both in general dimensionless terms and with regard to a specific numerical example.

Dynamic Stiffness and Damping Coefficients of Aerostatic, Porous, Journal Bearings

1978 ◽  
Vol 20 (5) ◽  
pp. 291-296 ◽  
Author(s):  
N. S. Rao ◽  
B. C. Majumdar
Keyword(s):  
Continuity Equation ◽  
Reynolds Equation ◽  
Journal Bearing ◽  
Dynamic Pressure ◽  
Dynamic Stiffness ◽  
Journal Bearings ◽  
Operating Conditions ◽  
Damping Coefficients ◽  
Design Charts ◽  
Stiffness And Damping

A periodic (displacement) disturbance is imposed on an aerostatic, porous, journal bearing of finite length under steady-state conditions. The dynamic pressure distribution is obtained by a pressure perturbation analysis of Reynolds equation and a modified flow continuity equation in a porous medium. Dynamic stiffness and damping coefficients for different operating conditions are calculated numerically, using a digital computer, and presented in the form of design charts.

Dynamic Properties of Tilting-Pad Journal Bearings: Experimental and Theoretical Investigation of Frequency Effects Due to Pivot Flexibility

2006 ◽  
Author(s):  
Waldemar Dmochowski
Keyword(s):  
High Speed ◽  
Dynamic Properties ◽  
Three Dimensional ◽  
Journal Bearings ◽  
Operating Conditions ◽  
Damping Properties ◽  
Frequency Effects ◽  
Tilting Pad ◽  
Stiffness And Damping ◽  
Tilting Pad Journal Bearings

Tilting-pad journal bearings (TPJB) dominate as rotor supports in high speed rotating machinery. The paper analyzes frequency effects on the TPJB’s stiffness and damping characteristics based on experimental and theoretical investigations. The experimental investigation has been carried out on a five pad tilting-pad journal bearing of 98 mm in diameter. Time domain and multifrequency excitation has been used to evaluate the dynamic coefficients. The calculated results have been obtained from a three-dimensional computer model of TPJB, which accounts for thermal effects, turbulent oil flow, and elastic effects, including that of pad flexibility. The analyzes of the TPJB’s stiffness and damping properties showed that the frequency effects on the bearing dynamic properties depend on the operating conditions and bearing design. It has been concluded that the pad inertia and pivot flexibility are behind the variations of the stiffness and damping properties with frequency of excitation.

Sign in / Sign up

Export Citation Format

Share Document