In Vitro Cardiovascular System Emulator (Bioreactor) for the Simulation of Normal and Diseased Conditions With and Without Mechanical Circulatory Support

2013 ◽  
Vol 37 (6) ◽  
pp. 549-560 ◽  
Author(s):  
Paula Ruiz ◽  
Mohammad Amin Rezaienia ◽  
Akbar Rahideh ◽  
Thomas R. Keeble ◽  
Martin T. Rothman ◽  
...  
Keyword(s):  
Cardiovascular System ◽  
Mechanical Circulatory Support ◽  
Circulatory Support

Hemolysis associated with Impella heart pump positioning: In vitro hemolysis testing and computational fluid dynamics modeling

2020 ◽  
Vol 43 (11) ◽  
pp. 710-718
Author(s):  
Nicholas Roberts ◽  
Uma Chandrasekaran ◽  
Soumen Das ◽  
Zhongwei Qi ◽  
Scott Corbett
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Mechanical Circulatory Support ◽  
Circulatory Support ◽  
Dynamics Modeling ◽  
Computational Fluid Dynamics Modeling ◽  
Heart Pump ◽  
Mechanical Circulatory Support Devices ◽  
Support Devices

Introduction: Short-term mechanical circulatory support devices provide temporary hemodynamic support in heart failure and are increasingly used to enable recovery or as a bridge to decision. Blood damage with mechanical circulatory support devices is influenced by many factors, including the magnitude and duration of shear stress and obstruction to blood flow. This study aimed to evaluate the effects of the Impella CP® heart pump positioning on hemolysis using in vitro hemolysis testing and computational fluid dynamics modeling. Methods: The in vitro hemolysis testing was conducted per the recommended Food and Drug Administration and American Society for Testing and Materials guidelines. The bench hemolysis testing and computational fluid dynamics simulation analysis were performed for both normal operating (outlet unobstructed) and outlet-obstructed condition of Impella CP (mimicking outlet on the aortic valve due to improper positioning). Results: The modified index of hemolysis was 2.78 ± 0.69 at normal operating conditions compared to 18.7 ± 7.8 when the Impella CP outlet was obstructed ( p = 0.002). Computational fluid dynamics modeling showed about three times increase in exposure time to regions of high shear stress when the Impella CP outlet was obstructed compared to unobstructed condition, thus supporting the experimental observations. Conclusion: Based on these results, it is recommended to ensure proper placement of Impella CP via regular monitoring using echocardiographic guidance or other methods to minimize the risk of hemolysis associated with an obstructed outflow.

scholarly journals Ghost Cells for Mechanical Circulatory Support In Vitro Testing: A Novel Large Volume Production

2020 ◽  
Vol 15 (4) ◽  
pp. 1900239
Author(s):  
Malte Schöps ◽  
Johanna C. Clauser ◽  
Matthias F. Menne ◽  
Dennis Faßbänder ◽  
Thomas Schmitz‐Rode ◽  
...  
Keyword(s):  
Large Volume ◽  
Mechanical Circulatory Support ◽  
Circulatory Support ◽  
In Vitro Testing ◽  
Ghost Cells ◽  
Volume Production

Numerical and In Vitro Investigation of a Novel Mechanical Circulatory Support Device Installed in the Descending Aorta

2015 ◽  
Vol 39 (6) ◽  
pp. 502-513 ◽  
Author(s):  
Mohammad Amin Rezaienia ◽  
Akbar Rahideh ◽  
Borhan Alhosseini Hamedani ◽  
Dawid Emanuel Maximilian Bosak ◽  
Silviya Zustiak ◽  
...  
Keyword(s):  
Mechanical Circulatory Support ◽  
Circulatory Support ◽  
Descending Aorta ◽  
In Vitro Investigation ◽  
Support Device ◽  
Mechanical Circulatory Support Device ◽  
Circulatory Support Device

scholarly journals In‐vitro Thrombogenicity Testing of Pulsatile Mechanical Circulatory Support Systems: Design and Proof‐of‐Concept

2021 ◽  
Author(s):  
Moritz K. Brockhaus ◽  
Mehdi J. Behbahani ◽  
Farina Muris ◽  
Sebastian V. Jansen ◽  
Thomas Schmitz‐Rode ◽  
...  
Keyword(s):  
Mechanical Circulatory Support ◽  
Support Systems ◽  
Systems Design ◽  
Circulatory Support ◽  
Proof Of Concept

scholarly journals Platelet Dysfunction During Mechanical Circulatory Support

2021 ◽  
Author(s):  
Yana Roka-Moiia ◽  
Samuel Miller-Gutierrez ◽  
Daniel E. Palomares ◽  
Joseph E. Italiano ◽  
Jawaad Sheriff ◽  
...  
Keyword(s):  
Shear Stress ◽  
Mechanical Circulatory Support ◽  
Platelet Adhesion ◽  
Surface Expression ◽  
Progressive Increase ◽  
Circulatory Support ◽  
Adhesion Receptors ◽  
Pulsatile Shear Stress ◽  
Functional Responsiveness

Objective: Mechanical circulatory support has emerged as lifesaving therapy for patients with advanced heart failure. However, mechanical circulatory support remains limited by a paradoxical coagulopathy accompanied by both thrombosis and bleeding. While mechanisms of mechanical circulatory support thrombosis are increasingly defined, mechanical circulatory support-related bleeding, as related to shear-mediated alteration of platelet function, remains poorly understood. We tested the hypothesis that platelet exposure to elevated shear stress, while a defined prothrombotic activator of platelets, coordinately induces downregulation of key platelet adhesion receptors GPIb (glycocalicin)-IX-V, α IIb β 3 , and P-selectin, thus decreasing platelet functional responsiveness to physiological stimuli. Approach and Results: Human gel-filtered platelets were exposed to continuous or pulsatile shear stress in vitro. Surface expression of platelet receptors and platelet-derived microparticle generation were quantified by flow cytometry. Shedding of receptor soluble forms were assessed via ELISA, and platelet aggregation was measured by optical aggregometry. We demonstrate that platelet exposure to elevated shear stress led to a downregulation of GPIb and α IIb β 3 receptors on platelets with a progressive increase in the generation of platelet-derived microparticles expressing elevated levels of α IIb β 3 and GPIb on their surface. No shear-mediated shedding of GPIb and β 3 subunit soluble fragments was detected. Soluble P-selectin was extensively shed from platelets, while surface expression of P-selectin on platelets and microparticles was not significantly altered by shear. Shear-mediated downregulation of GPIb, α IIb β 3 , and P-selectin on platelets was associated with an evident decrease of platelet aggregatory response induced by ADP and TRAP 6 (thrombin receptor activating peptide 6). Conclusions: Our data clearly indicate that accumulation of shear stress, consistent with supraphysiologic conditions characterizing device-supported circulation (1) induces adequate platelet degranulation, yet (2) causes downregulation of primary platelet adhesion receptors via ejection of receptor-enriched platelet-derived microparticles, thus mechanistically limiting platelet activation and the aggregatory response.

In Vitro Comparison of Two Different Mechanical Circulatory Support Devices Installed in Series and in Parallel

2014 ◽  
pp. n/a-n/a
Author(s):  
Mohammad Amin Rezaienia ◽  
Akbar Rahideh ◽  
Martin Terry Rothman ◽  
Scott A. Sell ◽  
Kyle Mitchell ◽  
...  
Keyword(s):  
Mechanical Circulatory Support ◽  
Circulatory Support ◽  
Mechanical Circulatory Support Devices ◽  
In Series ◽  
Support Devices ◽  
In Vitro Comparison

Inhibition of adamts13: a novel therapy to treat mechanical circulatory support-induced acquired von willebrand syndrome

2020 ◽  
Vol 41 (Supplement_2) ◽  
Author(s):  
S.J Deconinck ◽  
C Nix ◽  
E Bennek-Schopping ◽  
A Rauch ◽  
E Roose ◽  
...  
Keyword(s):  
Animal Model ◽  
Mechanical Circulatory Support ◽  
Axial Flow ◽  
Circulatory Support ◽  
Funding Source ◽  
Novel Therapy ◽  
Acquired Von Willebrand Syndrome ◽  
Von Willebrand

Abstract Introduction Bleeding is the most frequent adverse event in patients with continuous flow mechanical circulatory support (CF-MCS) and has been linked to the occurrence of acquired von Willebrand syndrome (aVWS). MCS devices cause an increased shear-induced proteolysis of von Willebrand factor (VWF) by ADAMTS13, leading to aVWS. Hence, specifically blocking ADAMTS13 might be an efficient way to rescue the loss of HMW VWF multimers in CF-MCS patients. Purpose To investigate if blocking ADAMTS13, using an in-house developed inhibitory anti-ADAMTS13 monoclonal antibody (mAb), prevents the loss of high molecular weight (HMW) VWF multimers in in vitro CF-MCS systems and to determine the efficacy of this therapy in a CF-MCS calf model. Methods Human blood was perfused through in vitro CF-MCS systems (Heartmate II and Impella CP, axial flow heart pumps) in the presence of the inhibitory or control mAb (20 μg/mL). Bovine blood was perfused through an in vitro Impella 5.5 system with the inhibitory mAb (20 μg/mL) or PBS. Next, Impella 5.5 pumps were implanted in calves. One dose of the inhibitory mAb (600 μg/kg) or PBS was injected eight days after Impella implantation. Plasma samples were analysed for VWF multimers, VWF antigen (VWF:Ag) and VWF collagen binding activity (VWF:CB). Results A time-dependent decrease in HMW VWF multimers was observed in both in vitro CF-MCS systems in the presence of the control mAb, leading to a 70% reduction of HMW VWF multimers, 180 minutes (min) after blood perfusion (p=0.01 for HM II and p=0.0003 for Impella). This was also reflected by a severely decreased VWF:CB/VWF:Ag ratio (0.59±0.11 and 0.52±0.10 at 180 min versus 1.00±0.06 and 1.07±0.09 before perfusion, for the HM II (p=0.03) and Impella (p=0.001) respectively). Interestingly, blocking ADAMTS13 using the inhibitory mAb prevented the loss of HMW VWF multimers in both systems (p=0.50 for the HM II and p=0.06 for the Impella, 180 min after the start of perfusion). The preservation of HMW VWF multimers was also reflected by normal VWF:CB/VWF:Ag ratios (0.92±0.16 and 0.97±0.11 at 180 min versus 0.93±0.09 and 1.19±0.12 before perfusion for the HM II (p=0.75) and Impella (p=0.06) respectively). Blocking bovine ADAMTS13 using the inhibitory mAb could prevent the loss of HMW VWF multimers in the in vitro Impella 5.5 system, showing that the calf is a good preclinical animal model to study the in vivo effect of this novel therapy. Impella implantation in the calves led to a decrease in HMW VWF multimers (Figure 1A and B). Hence, this animal model represents the VWF laboratory features of MCS-induced aVWS. Moreover, the loss of HMW VWF multimers after pump implantation could be rescued after injection of the inhibitory mAb (Figure 1A and B). Conclusion Blocking ADAMTS13 rescues MCS-induced VWF proteolysis in calves. Hence, inhibiting ADAMTS13 function could become a promising therapeutic strategy to rescue aVWS-induced bleeding in MCS patients. Figure 1. Impella calf model Funding Acknowledgement Type of funding source: Foundation. Main funding source(s): Fund for Scientific Research Flanders

Long-term survival on mechanical circulatory support

2008 ◽  
Vol 7 ◽  
pp. 173-173
Author(s):  
A GKOUZIOUTA ◽  
E LEONTIADIS ◽  
S ADAMOPOULOS ◽  
A MANGINAS ◽  
G KARAVOLIAS ◽  
...  
Keyword(s):  
Mechanical Circulatory Support ◽  
Circulatory Support ◽  
Term Survival ◽  
Long Term Survival
Sign in / Sign up

Export Citation Format

Share Document