Application of selective epitaxial silicon and chemo-mechanical polishing to bipolar transistors

1994 ◽  
Vol 41 (12) ◽  
pp. 2343-2350 ◽  
Author(s):  
C.T. Nguyen ◽  
S.C. Kuehne ◽  
S.S. Wong ◽  
L.K. Garling ◽  
C. Drowley
Keyword(s):  
Bipolar Transistors ◽  
Mechanical Polishing ◽  
Epitaxial Silicon

TEM evaluation of graded SixGe1-x heterolayers

1991 ◽  
Vol 49 ◽  
pp. 894-895
Author(s):  
N. David Theodore ◽  
Mamoru Tomozane ◽  
Ming Liaw
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Gas Flow ◽  
Field Effect Transistors ◽  
Chemical Vapor ◽  
Dark Field ◽  
Bipolar Transistors ◽  
Structural Quality ◽  
Weak Beam ◽  
Transmission Electron ◽  
And Behavior

There is extensive interest in SiGe for use in heterojunction bipolar transistors. SiGe/Si superlattices are also of interest because of their potential for use in infrared detectors and field-effect transistors. The processing required for these materials is quite compatible with existing silicon technology. However, before SiGe can be used extensively for devices, there is a need to understand and then control the origin and behavior of defects in the materials. The present study was aimed at investigating the structural quality of, and the behavior of defects in, graded SiGe layers grown by chemical vapor deposition (CVD).The structures investigated in this study consisted of Si1-xGex[x=0.16]/Si1-xGex[x= 0.14, 0.13, 0.12, 0.10, 0.09, 0.07, 0.05, 0.04, 0.005, 0]/epi-Si/substrate heterolayers grown by CVD. The Si1-xGex layers were isochronally grown [t = 0.4 minutes per layer], with gas-flow rates being adjusted to control composition. Cross-section TEM specimens were prepared in the 110 geometry. These were then analyzed using two-beam bright-field, dark-field and weak-beam images. A JEOL JEM 200CX transmission electron microscope was used, operating at 200 kV.

TEM study of phosphorus-implanted pseudomorphic Si0.88Ge0.12 on Si(100)

1995 ◽  
Vol 53 ◽  
pp. 468-469
Author(s):  
N. David Theodore ◽  
Donald Y.C Lie ◽  
J. H. Song ◽  
Peter Crozier
Keyword(s):  
Integrated Circuits ◽  
Heterojunction Bipolar Transistors ◽  
Integrated Circuit ◽  
High Speed ◽  
Room Temperature ◽  
Strain Relaxation ◽  
Bipolar Transistors ◽  
Sige Hbt ◽  
Integrated Circuit Manufacturing ◽  
Microstructural Behavior

SiGe is being extensively investigated for use in heterojunction bipolar-transistors (HBT) and high-speed integrated circuits. The material offers adjustable bandgaps, improved carrier mobilities over Si homostructures, and compatibility with Si-based integrated-circuit manufacturing. SiGe HBT performance can be improved by increasing the base-doping or by widening the base link-region by ion implantation. A problem that arises however is that implantation can enhance strain-relaxation of SiGe/Si.Furthermore, once misfit or threading dislocations result, the defects can give rise to recombination-generation in depletion regions of semiconductor devices. It is of relevance therefore to study the damage and anneal behavior of implanted SiGe layers. The present study investigates the microstructural behavior of phosphorus implanted pseudomorphic metastable Si0.88Ge0.12 films on silicon, exposed to various anneals.Metastable pseudomorphic Si0.88Ge0.12 films were grown ~265 nm thick on a silicon wafer by molecular-beam epitaxy. Pieces of this wafer were then implanted at room temperature with 100 keV phosphorus ions to a dose of 1.5×1015 cm-2.

Focused Ion Beam Irradiation Induced Damages on CMOS and Bipolar Technologies

1998 ◽  
Author(s):  
J. Benbrik ◽  
G. Rolland ◽  
P. Perdu ◽  
B. Benteo ◽  
M. Casari ◽  
...  
Keyword(s):  
Focused Ion Beam ◽  
Ion Beam ◽  
Electronic Devices ◽  
Complete Characterization ◽  
Bipolar Transistors ◽  
Ion Beam Irradiation ◽  
Physical Mechanisms ◽  
Dc Characteristics ◽  
Electrical Degradation ◽  
Physical Phenomena

Abstract Focused Ion Beam is commonly used for IC repairs and modifications. However, FIB operation may also induce a damaging impact which can takes place far from the working area due to the charge-up phenomenon. A complete characterization joined to an in-depth understanding of the physical phenomena arising from FIB irradiation is therefore necessary to take into account spurious FIB induced effects and to enhance the success of FIB modifications. In this paper, we present the effects of FIB irradiation on the electrical DC performances of different electronic devices such as nMOS and pMOS transistors, CMOS inverters, PN junctions and bipolar transistors. From the observed behavior of the DC characteristics evolution of the devices, some suggestions about physical mechanisms inducing the electrical degradation are proposed.

Sign in / Sign up

Export Citation Format

Share Document