Capacitance-voltage and current-voltage characteristics of graphite oxide thin films patterned by ultraviolet photolithography

2009 ◽  
Vol 95 (26) ◽  
pp. 263308 ◽  
Author(s):  
In-yeal Lee ◽  
E. S. Kannan ◽  
Gil-Ho Kim
Keyword(s):  
Thin Films ◽  
Graphite Oxide ◽  
Oxide Thin Films ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Current Voltage Characteristics

Influence of Metallic Indium Concentration on the Properties of Indium Oxide Thin Films

2016 ◽  
Vol 35 (9) ◽  
pp. 949-954
Author(s):  
N. Kalkan
Keyword(s):  
Thin Films ◽  
Indium Oxide ◽  
Optical Transmission ◽  
Oxide Thin Films ◽  
Film Properties ◽  
Indium Concentration ◽  
Ag Electrodes ◽  
Current Voltage ◽  
Current Voltage Characteristics ◽  
Substrate Temperatures

AbstractCurrent–voltage characteristics of indium-embedded indium oxide thin films (600–850 Å), with Ag electrodes approximately 1000 Å thick, prepared by reactive evaporation of pure metallic indium in partial air pressure have been studied for substrate temperatures between 50 and 125°C. The optical properties of these films have also been investigated as a function of metallic indium concentration and substrate temperature. I–V characteristics of all the samples are non-ohmic, independent of metallic indium concentration. The conductivity of the films increases but the optical transmission decreases with increasing metallic indium concentration. Metallic indium concentration was found to be an important parameter affecting the film properties. Furthermore, two possible conduction mechanisms are proposed.

scholarly journals Advanced processes for low-temperature formation of functional metal oxide based thin films

2021 ◽  
Vol 2056 (1) ◽  
pp. 012046
Author(s):  
A Abduev ◽  
A Akhmedov ◽  
A Asvarov ◽  
V Kanevsky ◽  
A Muslimov ◽  
...  
Keyword(s):  
Thin Films ◽  
Low Temperature ◽  
Metal Oxide ◽  
Transparent Conductive Oxide ◽  
Oxide Thin Films ◽  
Metal Oxide Thin Films ◽  
Magnetron Deposition ◽  
Current Voltage ◽  
Plasma Target ◽  
Current Voltage Characteristics

Abstract The analysis the discharge processes in magnetron plasma, target sputtering processes, as well as nucleation and formation of oxide thin films during dc magnetron sputtering is carried out. Particular attention is paid to the phenomenon of instabilities of the current-voltage characteristics of magnetron plasma during the sputtering of oxide targets, the processes of structural transformations of the surface of metal oxide targets under ion bombardment impact, and the mechanisms of low-temperature magnetron deposition of metal oxide thin films. Based on the results of the analysis performed the optimal routes for improving technologies for the low-temperature formation of transparent conductive oxide thin films have been discussed.

Preparation and Electrical Characteristics of (100), (111), and Randomly Oriented PZT Thin Films

1994 ◽  
Vol 361 ◽  
Author(s):  
Chang Jung Kim ◽  
Dae Sung Yoon ◽  
Joon Sung Lee ◽  
Chaun Gi Choi ◽  
Won Jong Lee ◽  
...  
Keyword(s):  
Thin Films ◽  
Sol Gel ◽  
Hysteresis Loops ◽  
Test System ◽  
Electrical Characteristics ◽  
Pzt Thin Films ◽  
Pole Figures ◽  
Current Voltage ◽  
Current Voltage Characteristics ◽  
Drying Conditions

ABSTRACTThe (100), (111) and randomly oriented PZT thin films were fabricated on Pt/Ti/Coming 7059 glass using sol-gel method. The thin films having different orientation were fabricated by different drying conditions for pyrolysis. The preferred orientations of the PZT thin films were observed using XRD, rocking curves, and pole figures. The microstructures were investigated using SEM. The hysteresis loops and capacitance-voltage characteristics of the films were investigated using a standardized ferroelectric test system. The dielectric constant and current-voltage characteristics of the films were investigated using an impedance analyzer and pA meter, respectively. The films oriented in a particular direction showed superior electrical characteristics to the randomly oriented films.

Photoconductivity of Nanocomposite MEH-PPV: TiO2 Thin Films

2011 ◽  
Vol 13 ◽  
pp. 87-92 ◽  
Author(s):  
M.S.P Sarah ◽  
F.S. Zahid ◽  
M.Z. Musa ◽  
U.M. Noor ◽  
Z. Shaameri ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Surface Morphology ◽  
Spin Coating ◽  
Glass Substrate ◽  
Spin Coating Technique ◽  
Coating Technique ◽  
Current Voltage ◽  
Current Voltage Characteristics

The photoconductivity of a nanocomposite MEH-PPV:TiO2 thin film is investigated. The nanocomposite MEH-PPV:TiO2 thin film was deposited on a glass substrate by spin coating technique. The composition of the TiO2 powder was varied from 5 wt% to 20 wt% (with 5 wt% interval). The concentration of the MEH-PPV is given by 1 mg/1 ml. The current voltage characteristics were measured in dark and under illumination. The photoconductivity showed increment in value as the composition of the TiO2 is raised in the polymer based solution. The absorption showed augmentation as the amount of TiO2 is increased. The escalation of the current voltage is then supported by the results of surface morphology.

Ferroelectric Property and Microstructures of La-Doped Bi4Ti3O12 Thin Films

2013 ◽  
Vol 537 ◽  
pp. 114-117
Author(s):  
X.A. Mei ◽  
Rui Fang Liu ◽  
C.Q. Huang ◽  
J. Liu
Keyword(s):  
Thin Films ◽  
Hysteresis Loops ◽  
Differential Resistance ◽  
Rf Magnetron Sputtering ◽  
Layered Perovskite ◽  
Random Orientation ◽  
Si Substrates ◽  
Current Voltage ◽  
Current Voltage Characteristics ◽  
La Doped

La-doped bismuth titanate (Bi4-xLaxTi3O12: BLT) and pure Bi4Ti3O12 (BIT) thin films with random orientation were fabricated on Pt/Ti/SiO2/Si substrates by rf magnetron sputtering technique. These samples had polycrystalline Bi-layered perovskite structure without preferred orientation, and consisted of well developed rod-like grains with random orientation. For the samples with x=0.25 and 1.0 the current-voltage characteristics exhibited negative differential resistance behaviors and their P-V hysteresis loops were characterized by large leakage current, whereas for the samples with x=0.5 and 0.75 the current-voltage characteristics showed simple ohmic behaviors and their P-V hysteresis loops were the saturated and undistorted hysteresis loops. The remanent polarization ( Pr ) and coercive field (Ec) of the BLT ceramic with x=0.75 were above 20μC/cm2 and 85KV/cm , respectively.

Effect of Thermal Annealing on La2O3 Films Grown by Plasma Enhanced Atomic Layer Deposition

2015 ◽  
Vol 1088 ◽  
pp. 107-111
Author(s):  
Jian Shuang Liu ◽  
Fang Fang Zhu ◽  
Fei Lu ◽  
Lin Zhang
Keyword(s):  
Atomic Layer Deposition ◽  
Atomic Layer ◽  
Deposition Process ◽  
Flat Band ◽  
Interface Reactions ◽  
Layer Deposition ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Before And After ◽  
Current Voltage Characteristics

A plasma enhanced atomic layer deposition process has been demonstrated for Lanthanum oxide films using La (thd)3 precursor and oxygen plasma. The chemical and electrical properties of La2O3 ultra-thin films on Si (100) substrates before and after post-annealing in N2 ambient have been investigated. X-ray photoelectron spectroscopic revealed that interface reactions take place after annealing process which lead to oxygen insufficiency, as well as the balance band offset decreases with the increase of annealing temperature. The capacitance-voltage and current-voltage characteristics show La2O3 capacitors annealed at 900 °C have negligible hysteresis, smaller interface trap density in comparison with as-deposited samples, but larger flat band voltage and higher gate-leakage current density due to the appearance of oxygen vacancy in the La2O3 films.

Sign in / Sign up

Export Citation Format

Share Document