Surface and bulk point defect generation in Czochralski and float zone type silicon wafers

1996 ◽  
Vol 68 (15) ◽  
pp. 2085-2087 ◽  
Author(s):  
Wingra T. C. Fang ◽  
Tilden T. Fang ◽  
Peter B. Griffin ◽  
James D. Plummer
1999 ◽  
Vol 568 ◽  
Author(s):  
C. R. Cho ◽  
N. Yarykin ◽  
G. A. Rozgonyi ◽  
R. A. Zuhr

ABSTRACTThe formation of vacancy-related defects in n-type silicon has been studied immediately after implantation of He, Si, or Ge ions at 85 K using in-situ DLTS. A-center concentrations in He-implanted samples reach a maximum immediately after implantation, whereas, with Si or Ge ion implanted samples they continuously increase during subsequent anneals. It is proposed that defect clusters, which emit vacancies during anneals, are generated in the collision cascades of Si or Ge ions. An illumination-induced suppression of A-center formation is seen immediately after implantation of He ions at 85 K. This effect is also observed with Si or Ge ions, but only after annealing. The suppression of vacancy complex formation via photoexcitation is believed to occur due to an enhanced recombination of defects during ion implantation, and results in reduced number of vacancies remaining in the defect clusters. In p-type silicon, a reduction in K-center formation and an enhanced migration of defects are concurrently observed in the illuminated sample implanted with Si ions. These observations are consistent with a model where the injection of excess carriers modifies the defect charge state and impacts their diffusion.


2019 ◽  
Vol 8 (1) ◽  
pp. P35-P40 ◽  
Author(s):  
Haruo Sudo ◽  
Kozo Nakamura ◽  
Susumu Maeda ◽  
Hideyuki Okamura ◽  
Koji Izunome ◽  
...  

1997 ◽  
Vol 469 ◽  
Author(s):  
Srinivasan Chakravarthit ◽  
Scott T. Dunham

Point defect properties, including diffusivities and equilibrium concentrations for both interstitials and vacancies, are commonly extracted from metal diffusion experiments, and these values are widely used in process simulation software. However, in many cases, these parameter values were extracted using oversimplified models which ignore interactions between interstitial and vacancy diffusion mechanisms. Questions about the accuracy of these parameters have come from ab-initio defect calculations which conclude that vacancies diffuse faster than interstitials, in contrast with published reports on metal diffusion which find vacancies diffuse much more slowly than interstitials. We have reanalyzed published data for zinc and platinum diffusion and find that it is possible to match all of the data using fast vacancy diffusivity. The most direct evidence for slow vacancy diffusion (and a high equilibrium concentration) comes from platinum diffusion experiments. However, we are able to reproduce these results with fast V diffusion and carbon/interstitial clustering, using carbon concentrations typical of Czochralski and float zone silicon (1016cm−3). We evaluate the effectiveness of metal diffusion experiments in determining point defect parameters, and find that it is not possible to reliably determine both diffusivities and equilibrium concentrations for both interstitials and vacancies from metal diffusion results.


Sign in / Sign up

Export Citation Format

Share Document