Experimental study of a combined heat-power-cool system

Author(s):  
Wang Jia ◽  
Xu Weiging ◽  
Sun Wenjun ◽  
Cai Maolin
2010 ◽  
Author(s):  
X. Y. Tang ◽  
D. S. Zhu ◽  
C. Q. Guo ◽  
Liejin Guo ◽  
D. D. Joseph ◽  
...  

2020 ◽  
Vol 2020 ◽  
pp. 1-9
Author(s):  
Fei Cao ◽  
Qingjun Liu ◽  
Hong Xiao

The solar humidification-dehumidification system is of high significance to the freshwater supply in remote areas. In the present study, a humidification-dehumidification seawater desalination system combined with the chimney is designed and experimentally evaluated. Main parameters influencing its freshwater productivity are analyzed. It is found from this study that the cooling tower is required to obtain long-term steady freshwater generation. Raising the temperature difference between the evaporation and condensation chambers would lead to the rise of the freshwater productivity. There is a turning wind speed, beyond which increasing the wind speed would lead to the decline of both the freshwater productivity and the thermal efficiency. The turning wind speed is relevant to the ambient humanity and the heating power. Decreasing the heat power would increase the turning wind speed. When the heating power is 4.9 kW, the highest freshwater productivity and the highest efficiency are 48 g/min and 32.14%, respectively.


Energies ◽  
2021 ◽  
Vol 14 (19) ◽  
pp. 6310
Author(s):  
Jing Chen ◽  
Junbiao Dong ◽  
Ye Yao

Vibrations have attracted much attention as an effective method for enhancing heat transfer in pulsating heat pipes (PHPs). This study mainly investigates and explores the effects of local low-frequency vibrations on the starting-up and heat transfer characteristics of a PHP. The starting-up temperature and average temperatures along the evaporation section of the pulsating heat pipe were experimentally scrutinized, along with thermal performance, under local vibrations on evaporation, condensation and adiabatic sections, respectively. The following important conclusions can be derived by the experimental study: (1) The effect of vibrations at the evaporation section and at the adiabatic section during the starting-up time of the PHP were more significant than that at the condensation section; (2) vibrations at different positions could reduce the starting-up temperature of the PHP—the effect of the vibrations at the evaporation section was the best when heat power was lower, while the effect of vibrations on the adiabatic section was the best when heat power was higher; (3) vibrations at the evaporation and adiabatic sections could reduce the thermal resistance of the PHP, but vibrations at the condensation section had little effect on the thermal resistance of the PHP; (4) vibrations at the evaporation and adiabatic sections could effectively reduce the temperature at the evaporation section of the PHP, but the vibrations at the condensation section had no effect on the temperature at the evaporation section of the PHP. This paper shows that local low-frequency vibrations have positive effects on the heat transfer performances of PHPs.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  

1974 ◽  
Vol 126 (2) ◽  
pp. 243-248
Author(s):  
A WAKABAYASHI ◽  
T KUBO ◽  
K CHARNEY ◽  
Y NAKAMURA ◽  
J CONNOLLY

1963 ◽  
Vol 45 (3) ◽  
pp. 374-383 ◽  
Author(s):  
Donald C. McIlrath ◽  
George A. Hallenbeck ◽  
Hubert A. Allen ◽  
Charles V. Mann ◽  
Edward J. Baldes ◽  
...  
Keyword(s):  

1958 ◽  
Vol 34 (1) ◽  
pp. 11-20 ◽  
Author(s):  
Henry D. Janowitz ◽  
Vernon A. Weinstein ◽  
Rhoda G. Shaer ◽  
James F. Cereghini ◽  
Franklin Hollander

Sign in / Sign up

Export Citation Format

Share Document