scholarly journals Inter-fibre failure of through-thickness reinforced laminates in combined transverse compression and shear load

2018 ◽  
Vol 165 ◽  
pp. 48-57 ◽  
Author(s):  
Hao Cui ◽  
António R. Melro ◽  
Mehdi Yasaee
Keyword(s):  
Shear Load ◽  
Transverse Compression ◽  
Fibre Failure

scholarly journals Strengthening of RCC Beams in Shear by Using SBR Polymer-Modified Ferrocement Jacketing Technique

2018 ◽  
Vol 2018 ◽  
pp. 1-16 ◽  
Author(s):  
Rajinder Ghai ◽  
Prem Pal Bansal ◽  
Maneek Kumar
Keyword(s):  
Carrying Capacity ◽  
Shear Failure ◽  
Ultimate Load ◽  
Load Test ◽  
Wire Mesh ◽  
Styrene Butadiene Rubber ◽  
Shear Load ◽  
Butadiene Rubber ◽  
Load Carrying Capacity ◽  
Load Carrying

There is a common phenomenon of shear failure in RCC beams, especially in old buildings and bridges. Any possible strengthening of such beams is needed to be explored that could strengthen and make them fit for serviceable conditions. The present research has been made to determine the performance of predamaged beams strengthened with three-layered wire mesh polymer-modified ferrocement (PMF) with 15% styrene-butadiene-rubber latex (SBR) polymer. Forty-eight shear-designed and shear-deficient real-size beams were used in this experimental work. Ultimate shear load-carrying capacity of control beams was found at two different shear-span (a/d) ratios 1 and 3. The sets of remaining beams were loaded with different predetermined damage levels of 45%, 75%, and 95% of the ultimate load values and then strengthened with 20 mm thick PMF. The strengthened beams were then again tested for ultimate load-carrying capacity by conducting the shear load test at a/d = 1 and 3. As a result, the PMF-strengthened beams showed restoration and enhancement of ultimate shear load-carrying capacity by 5.90% to 12.03%. The ductility of strengthened beams was improved, and hence, the corresponding deflections were prolonged. On the other hand, the cracking pattern of PMF-strengthened beams was also improved remarkably.

scholarly journals Effect of Bottom Geometry on the Natural Sloshing Motion of Water Inside Tanks: An Experimental Analysis

2021 ◽  
Vol 11 (2) ◽  
pp. 605
Author(s):  
Antonio Agresta ◽  
Nicola Cavalagli ◽  
Chiara Biscarini ◽  
Filippo Ubertini
Keyword(s):  
Energy Dissipation ◽  
Water Depth ◽  
Shear Force ◽  
Experimental Tests ◽  
Shear Load ◽  
Damping Properties ◽  
Base Shear ◽  
Structure Interaction ◽  
Sloshing Phenomenon ◽  
Key Aspects

The present work aims at understanding and modelling some key aspects of the sloshing phenomenon, related to the motion of water inside a container and its effects on the substructure. In particular, the attention is focused on the effects of bottom shapes (flat, sloped and circular) and water depth ratio on the natural sloshing frequencies and damping properties of the inner fluid. To this aim, a series of experimental tests has been carried out on tanks characterised by different bottom shapes installed over a sliding table equipped with a shear load cell for the measurement of the dynamic base shear force. The results are useful for optimising the geometric characteristics of the tank and the fluid mass in order to obtain enhanced energy dissipation performances by exploiting fluid–structure interaction effects.

Improving the Tensile Shear Load of Al–Mg–Si Alloy FSLW Joint by BPNN–GA

2021 ◽  
Author(s):  
Ruixiu Guo ◽  
Wei Hu ◽  
Qi Song ◽  
Shude Ji ◽  
Weiwei Qi ◽  
...  
Keyword(s):  
Shear Load ◽  
Tensile Shear

Shear-friction behavior of concrete-to-concrete interface under direct shear load

2021 ◽  
Vol 238 ◽  
pp. 112211
Author(s):  
Jin Xia ◽  
Kuang-yi Shan ◽  
Xiao-hui Wu ◽  
Run-li Gan ◽  
Wei-liang Jin
Keyword(s):  
Shear Load ◽  
Direct Shear ◽  
Friction Behavior ◽  
Shear Friction ◽  
Concrete Interface

Phenomenon of crack arrest in a plate with transverse compression zones

1978 ◽  
Vol 10 (1) ◽  
pp. 6-11
Author(s):  
G. S. Pisarenko ◽  
V. P. Naumenko ◽  
V. I. Koval'
Keyword(s):  
Crack Arrest ◽  
Transverse Compression

The effect of shear load on frictional healing in simulated fault gouge

1998 ◽  
Vol 25 (24) ◽  
pp. 4561-4564 ◽  
Author(s):  
Stephen L. Karner ◽  
Chris Marone
Keyword(s):  
Fault Gouge ◽  
Shear Load

The tilted punch under normal and shear load (with application to fretting tests)

2001 ◽  
Vol 43 (8) ◽  
pp. 1881-1892 ◽  
Author(s):  
A Sackfield ◽  
C.E Truman ◽  
D.A Hills
Keyword(s):  
Shear Load

Flow Deformation of Liquefied Sand Under Constant Shear Load and Prediction of Flow Slide of Infinite Slope

Geomechanics ◽  
2005 ◽  
Author(s):  
Mitsutoshi Yoshimine ◽  
Hiroto Nishizaki ◽  
Kei Amano ◽  
Yasuyo Hosono
Keyword(s):  
Shear Load ◽  
Infinite Slope ◽  
Flow Slide ◽  
Constant Shear ◽  
Flow Deformation
Sign in / Sign up

Export Citation Format

Share Document