Numerical study of flow field in cyclones of different height

2005 ◽  
Vol 44 (8) ◽  
pp. 877-883 ◽  
Author(s):  
R.B. Xiang ◽  
K.W. Lee
Keyword(s):  
Flow Field ◽  
Numerical Study

Numerical Study of the Combined Free-Forced Convection and Mass Transfer Flow Past a Vertical Porous Plate in a Porous Medium with Heat Generation and Thermal Diffusion

2006 ◽  
Vol 11 (4) ◽  
pp. 331-343 ◽  
Author(s):  
M. S. Alam ◽  
M. M. Rahman ◽  
M. A. Samad
Keyword(s):  
Mass Transfer ◽  
Flow Field ◽  
Differential Equations ◽  
Forced Convection ◽  
Heat Generation ◽  
Numerical Study ◽  
Porous Plate ◽  
Integration Scheme ◽  
Suction Parameter ◽  
Transfer Flow

The problem of combined free-forced convection and mass transfer flow over a vertical porous flat plate, in presence of heat generation and thermaldiffusion, is studied numerically. The non-linear partial differential equations and their boundary conditions, describing the problem under consideration, are transformed into a system of ordinary differential equations by using usual similarity transformations. This system is solved numerically by applying Nachtsheim-Swigert shooting iteration technique together with Runge-Kutta sixth order integration scheme. The effects of suction parameter, heat generation parameter and Soret number are examined on the flow field of a hydrogen-air mixture as a non-chemical reacting fluid pair. The analysis of the obtained results showed that the flow field is significantly influenced by these parameters.

scholarly journals Experimental and Numerical Study of Proton Exchange Membrane Fuel Cells with a Novel Compound Flow Field

ACS Omega ◽  
2021 ◽  
Vol 6 (34) ◽  
pp. 21892-21899
Author(s):  
Yixiang Wang ◽  
Lei Wang ◽  
Xianhang Ji ◽  
Yulu Zhou ◽  
Mingge Wu
Keyword(s):  
Fuel Cells ◽  
Flow Field ◽  
Proton Exchange Membrane ◽  
Numerical Study ◽  
Proton Exchange ◽  
Exchange Membrane

Numerical study on the airfoil self-noise of three owl-based wings with the trailing-edge serrations

2021 ◽  
pp. 095441002098822
Author(s):  
Dian Li ◽  
Xiaomin Liu ◽  
Lei Wang ◽  
Fujia Hu ◽  
Guang Xi
Keyword(s):  
Flow Field ◽  
Noise Reduction ◽  
Numerical Study ◽  
Barn Owl ◽  
Aerodynamic Noise ◽  
Frequency Noise ◽  
Trailing Edge ◽  
Reduction Mechanisms ◽  
Trailing Edge Serrations ◽  
Bionic Airfoil

Previous publications have summarized that three special morphological structures of owl wing could reduce aerodynamic noise under low Reynolds number flows effectively. However, the coupling noise-reduction mechanism of bionic airfoil with trailing-edge serrations is poorly understood. Furthermore, while the bionic airfoil extracted from natural owl wing shows remarkable noise-reduction characteristics, the shape of the owl-based airfoils reconstructed by different researchers has some differences, which leads to diversity in the potential noise-reduction mechanisms. In this article, three kinds of owl-based airfoils with trailing-edge serrations are investigated to reveal the potential noise-reduction mechanisms, and a clean airfoil based on barn owl is utilized as a reference to make a comparison. The instantaneous flow field and sound field around the three-dimensional serrated airfoils are simulated by using incompressible large eddy simulation coupled with the FW-H equation. The results of unsteady flow field show that the flow field of Owl B exhibits stronger and wider-scale turbulent velocity fluctuation than that of other airfoils, which may be the potential reason for the greater noise generation of Owl B. The scale and magnitude of alternating mean convective velocity distribution dominates the noise-reduction effect of trailing-edge serrations. The noise-reduction characteristic of Owl C outperforms that of Barn owl, which suggests that the trailing-edge serrations can suppress vortex shedding noise of flow field effectively. The trailing-edge serrations mainly suppress the low-frequency noise of the airfoil. The trailing-edge serration can suppress turbulent noise by weakening pressure fluctuation.

3D numerical study on flow field in disc-RDE

2021 ◽  
Author(s):  
A Koichi Hayashi ◽  
Kodai Shimomura ◽  
Nobuyuki Tsuboi ◽  
Kohei Ozawa ◽  
Nicolas H. Jourdaine ◽  
...  
Keyword(s):  
Flow Field ◽  
Numerical Study

Numerical Study of Winglet at Low Reynolds Numbers

2013 ◽  
Author(s):  
Sina Pooladsanj ◽  
Mehran Tadjfar
Keyword(s):  
Aspect Ratio ◽  
Flow Field ◽  
Vortex Flow ◽  
Numerical Study ◽  
Reynolds Numbers ◽  
Flow Zone ◽  
Low Reynolds Numbers ◽  
Structured Grid ◽  
Flow Field Characteristics ◽  
Wing Aspect Ratio

A numerical study has been performed to evaluate the aerodynamics coefficients of a winglet in the range of Reynolds numbers below 30,000. In this study some parameters on winglet design have been considered. The effect of winglet-tip airfoil thickness has been investigated on aerodynamics coefficients. In order to explore this effect, two different airfoils (NACA0002 and NACA0012) were employed at the winglet-tip. The influence of varying the winglet connection angle to the wing on aerodynamics coefficients and flow field characteristics in the vortex flow zone such as; circulation magnitude and vorticity magnitude in the vortex core have been studied. Six connection angles including 20°, 30°, 40°, 50°, 60° and 70° have been studied. Negative values of these angles have also been considered. In addition, the effect of changing wing aspect ratio on aerodynamics coefficients has been investigated. To solve the flow field around the studied geometry a fully structured grid was used which consists of 84 blocks.

Magnetohydrodynamic effects on flow structures and heat transfer over two cylinders wrapped with a porous layer in side

2016 ◽  
Vol 26 (5) ◽  
pp. 1416-1432 ◽  
Author(s):  
Saman Rashidi ◽  
Javad Abolfazli Esfahani ◽  
Mohammad Sadegh Valipour ◽  
Masoud Bovand ◽  
Ioan Pop
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Flow Field ◽  
Porous Layer ◽  
Numerical Study ◽  
Convection Heat Transfer ◽  
Circular Cylinders ◽  
Flow Structures ◽  
Content Type ◽  
The Magnetic Field

Purpose – The analysis of the flow field and heat transfer around a tube row or tube banks wrapped with porous layer have many related engineering applications. Examples include the reactor safety analysis, combustion, compact heat exchangers, solar power collectors, high-performance insulation for buildings and many another applications. The purpose of this paper is to perform a numerical study on flows passing through two circular cylinders in side-by-side arrangement wrapped with a porous layer under the influence of a magnetic field. The authors focus the attention to the effects of magnetic field, Darcy number and pitch ratio on the mechanism of convection heat transfer and flow structures. Design/methodology/approach – The Darcy-Brinkman-Forchheimer model for simulating the flow in porous medium along with the Maxwell equations for providing the coupling between the flow field and the magnetic field have been used. Equations with the relevant boundary conditions are numerically solved using a finite volume approach. In this study, Stuart and Darcy numbers are varied within the range of 0 < N < 3 and 1e-6 < Da < 1e-2, respectively, and Reynolds and Prandtl numbers are equal to Re=100 and Pr=0.71, respectively. Findings – The results show that the drag coefficient decreases for N < 0.6 and increases for N > 0.6. Also, the effect of magnetic field is negligible in the gap between two cylinders because the magnetic field for two cylinders counteracts each other in these regions. Originality/value – To the authors knowledge, in the open literature, flow passing over two circular cylinders in side-by-side arrangement wrapped with a porous layer has been rarely investigated especially under the influence of a magnetic field.

Experimental and Numerical Study on the Flow Field Around a Parallel-Foil Turbine

2020 ◽  
Author(s):  
Yulu Wang ◽  
Di Zhang ◽  
Yonghui Xie
Keyword(s):  
Flow Field ◽  
Aerodynamic Force ◽  
Numerical Study ◽  
Energy Extraction ◽  
Reduced Frequency ◽  
Image Velocimetry ◽  
Efficiency Increase ◽  
Oscillation Process ◽  
Effective Angle ◽  
Extraction Performance

Abstract An experiment facility of parallel-foil turbine is proposed in this study. The flow field around foils at different reduced frequency, pitching amplitude and plunging amplitude is measured by 2D Particle Image Velocimetry (PIV) system. And the energy extraction performance at different motion parameters is analyzed numerically. The comparison between experimental and numerical flow field is conducted at different reduced frequency. The evolution of flow field and the aerodynamic force with different pitching amplitude and plunging amplitude are discussed. The effect of pitching amplitude and plunging amplitude on energy extraction performance is obtained. Results indicate that the pitching amplitude can increase the range and the strength of acceleration area by varying the pitching velocity and the effective angle of attack. The optimal extraction performance appears at 70°. Due to the increase in plunging amplitude, the energy extraction performance and efficiency increase gradually. The optimal plunging amplitude is 1.0. The pitching amplitude and the plunging amplitude influence the power output by affecting the vortex shedding and the flow reattachment in oscillation process.

Sign in / Sign up

Export Citation Format

Share Document