High-resolution spectroscopy of low-energy electrons emitted in nuclear transformations

1990 ◽  
Vol 61 (1-4) ◽  
pp. 1309-1313
Author(s):  
O. Dragoun ◽  
V. Brabec ◽  
A. Kovalík ◽  
M. Fiŝer ◽  
J. Novák ◽  
...  
Keyword(s):  
High Resolution ◽  
Low Energy ◽  
High Resolution Spectroscopy ◽  
Low Energy Electrons

Lithography with low-energy electrons

1984 ◽  
Vol 42 ◽  
pp. 468-471
Author(s):  
T. H. Newman ◽  
R. F. W. Pease ◽  
K. J. Polasko ◽  
Y. W. Yau
Keyword(s):  
Electron Beam ◽  
High Resolution ◽  
Electron Beam Lithography ◽  
Proximity Effects ◽  
Low Energy ◽  
Low Energy Electrons ◽  
Circuit Fabrication ◽  
Electron Range ◽  
Exposure Process

Two prominent problems of electron beam lithography are slow throughput and proximity effects. The former arises from the serial nature of the exposure process; the current available in a beam of given resolution is limited by electron optical considerations and the resist sensitivity is limited by material considerations such that a dose of 1 μC/cm2 at 20 kV is required for the most sensitive resist and ten times that dose if high resolution is required.Proximity effects are caused by electrons scattered through lateral distances greater than the resolution of the pattern; a 20 keV electron in silicon has a range of about 3 μm whereas feature sizes are often less than 1 μm. Lowering the energy of the exposing electrons to, say, 2 keV would lower the electron range to less than 0.1 μm in silicon and thus effectively eliminate proximity effects as far as semiconductor circuit fabrication is concerned.

Possibility of high-resolution ptychographic iterative imaging with low energy electrons: dynamical calculations

Microscopy ◽  
2014 ◽  
Vol 64 (2) ◽  
pp. 105-110 ◽  
Author(s):  
Ling Wang ◽  
Cheng Liu ◽  
John M. Rodenburg
Keyword(s):  
High Resolution ◽  
Low Energy ◽  
Low Energy Electrons

High resolution studies of the dissociative attachment of low energy electrons to state-selected sodium dimers

1996 ◽  
Author(s):  
K. Bergmann ◽  
M. Keil ◽  
M. Külz ◽  
A. Kortyna ◽  
D. Weyh ◽  
...  
Keyword(s):  
High Resolution ◽  
Low Energy ◽  
Dissociative Attachment ◽  
Low Energy Electrons ◽  
Sodium Dimers

scholarly journals New Ultra-High Resolution SEM for Imaging by Low Energy Electrons

2013 ◽  
Vol 19 (S2) ◽  
pp. 1302-1303 ◽  
Author(s):  
J. Jiruse ◽  
M. Havelka ◽  
J. Polster ◽  
F. Lopour
Keyword(s):  
High Resolution ◽  
Low Energy ◽  
Low Energy Electrons

Extended abstract of a paper presented at Microscopy and Microanalysis 2013 in Indianapolis, Indiana, USA, August 4 – August 8, 2013.

Microcalorimeters for X-Ray Spectroscopy

1988 ◽  
Vol 102 ◽  
pp. 41
Author(s):  
E. Silver ◽  
C. Hailey ◽  
S. Labov ◽  
N. Madden ◽  
D. Landis ◽  
...  
Keyword(s):  
High Resolution ◽  
High Efficiency ◽  
Thermal Response ◽  
Low Noise ◽  
High Resolution Spectroscopy ◽  
Superconducting Transition ◽  
Sapphire Substrates ◽  
Laboratory Plasmas ◽  
Adiabatic Demagnetization ◽  
Theoretical Predictions

The merits of microcalorimetry below 1°K for high resolution spectroscopy has become widely recognized on theoretical grounds. By combining the high efficiency, broadband spectral sensitivity of traditional photoelectric detectors with the high resolution capabilities characteristic of dispersive spectrometers, the microcalorimeter could potentially revolutionize spectroscopic measurements of astrophysical and laboratory plasmas. In actuality, however, the performance of prototype instruments has fallen short of theoretical predictions and practical detectors are still unavailable for use as laboratory and space-based instruments. These issues are currently being addressed by the new collaborative initiative between LLNL, LBL, U.C.I., U.C.B., and U.C.D.. Microcalorimeters of various types are being developed and tested at temperatures of 1.4, 0.3, and 0.1°K. These include monolithic devices made from NTD Germanium and composite configurations using sapphire substrates with temperature sensors fabricated from NTD Germanium, evaporative films of Germanium-Gold alloy, or material with superconducting transition edges. A new approache to low noise pulse counting electronics has been developed that allows the ultimate speed of the device to be determined solely by the detector thermal response and geometry. Our laboratory studies of the thermal and resistive properties of these and other candidate materials should enable us to characterize the pulse shape and subsequently predict the ultimate performance. We are building a compact adiabatic demagnetization refrigerator for conveniently reaching 0.1°K in the laboratory and for use in future satellite-borne missions. A description of this instrument together with results from our most recent experiments will be presented.

Transfer optics for high spatial resolution electron spectroscopy

1988 ◽  
Vol 46 ◽  
pp. 666-667
Author(s):  
G. G. Hembree ◽  
Luo Chuan Hong ◽  
P.A. Bennett ◽  
J.A. Venables
Keyword(s):  
Magnetic Field ◽  
Scanning Transmission Electron Microscope ◽  
Low Energy ◽  
Objective Lens ◽  
State University ◽  
Arizona State University ◽  
Initial Field ◽  
Resolution Electron ◽  
Scanning Transmission ◽  
Low Energy Electrons

A new field emission scanning transmission electron microscope has been constructed for the NSF HREM facility at Arizona State University. The microscope is to be used for studies of surfaces, and incorporates several surface-related features, including provision for analysis of secondary and Auger electrons; these electrons are collected through the objective lens from either side of the sample, using the parallelizing action of the magnetic field. This collimates all the low energy electrons, which spiral in the high magnetic field. Given an initial field Bi∼1T, and a final (parallelizing) field Bf∼0.01T, all electrons emerge into a cone of semi-angle θf≤6°. The main practical problem in the way of using this well collimated beam of low energy (0-2keV) electrons is that it is travelling along the path of the (100keV) probing electron beam. To collect and analyze them, they must be deflected off the beam path with minimal effect on the probe position.

Performance Evaluation of a Novel Type of Low-Energy Electron Microscope

1990 ◽  
Vol 48 (1) ◽  
pp. 354-355
Author(s):  
Bertholdand Senftinger ◽  
Helmut Liebl
Keyword(s):  
Electron Microscope ◽  
High Resolution ◽  
Field Strength ◽  
Numerical Aperture ◽  
Low Energy ◽  
Energy Electron ◽  
High Resolution Imaging ◽  
Lens System ◽  
Resolution Imaging ◽  
Low Energy Electron

During the last few years the investigation of clean and adsorbate-covered solid surfaces as well as thin-film growth and molecular dynamics have given rise to a constant demand for high-resolution imaging microscopy with reflected and diffracted low energy electrons as well as photo-electrons. A recent successful implementation of a UHV low-energy electron microscope by Bauer and Telieps encouraged us to construct such a low energy electron microscope (LEEM) for high-resolution imaging incorporating several novel design features, which is described more detailed elsewhere.The constraint of high field strength at the surface required to keep the aberrations caused by the accelerating field small and high UV photon intensity to get an improved signal-to-noise ratio for photoemission led to the design of a tetrode emission lens system capable of also focusing the UV light at the surface through an integrated Schwarzschild-type objective. Fig. 1 shows an axial section of the emission lens in the LEEM with sample (28) and part of the sample holder (29). The integrated mirror objective (50a, 50b) is used for visual in situ microscopic observation of the sample as well as for UV illumination. The electron optical components and the sample with accelerating field followed by an einzel lens form a tetrode system. In order to keep the field strength high, the sample is separated from the first element of the einzel lens by only 1.6 mm. With a numerical aperture of 0.5 for the Schwarzschild objective the orifice in the first element of the einzel lens has to be about 3.0 mm in diameter. Considering the much smaller distance to the sample one can expect intense distortions of the accelerating field in front of the sample. Because the achievable lateral resolution depends mainly on the quality of the first imaging step, careful investigation of the aberrations caused by the emission lens system had to be done in order to avoid sacrificing high lateral resolution for larger numerical aperture.

Preincubation with Sn-complexes causes intensive intracellular retention of 99mTc in thyroid cells in vitro

2012 ◽  
Vol 51 (05) ◽  
pp. 179-185 ◽  
Author(s):  
M. Wendisch ◽  
D. Aurich ◽  
R. Runge ◽  
R. Freudenberg ◽  
J. Kotzerke ◽  
...  
Keyword(s):  
Cell Model ◽  
Low Energy ◽  
Thyroid Cells ◽  
Low Energy Electrons ◽  
A Cell ◽  
Vitro Model ◽  
Uptake Studies ◽  
Radiobiological Effects ◽  
Radioactivity Retention

SummaryTechnetium radiopharmaceuticals are well established in nuclear medicine. Besides its well-known gamma radiation, 99mTc emits an average of five Auger and internal conversion electrons per decay. The biological toxicity of these low-energy, high-LET (linear energy transfer) emissions is a controversial subject. One aim of this study was to estimate in a cell model how much 99mTc can be present in exposed cells and which radiobiological effects could be estimated in 99mTc-overloaded cells. Methods: Sodium iodine symporter (NIS)- positive thyroid cells were used. 99mTc-uptake studies were performed after preincubation with a non-radioactive (cold) stannous pyro - phosphate kit solution or as a standard 99mTc pyrophosphate kit preparation or with pure pertechnetate solution. Survival curves were analyzed from colony-forming assays. Results: Preincubation with stannous complexes causes irreversible intracellular radioactivity retention of 99mTc and is followed by further pertechnetate influx to an unexpectedly high 99mTc level. The uptake of 99mTc pertechnetate in NIS-positive cells can be modified using stannous pyrophosphate from 3–5% to >80%. The maximum possible cellular uptake of 99mTc was 90 Bq/cell. Compared with nearly pure extracellular irradiation from routine 99mTc complexes, cell survival was reduced by 3–4 orders of magnitude after preincubation with stannous pyrophosphate. Conclusions: Intra cellular 99mTc retention is related to reduced survival, which is most likely mediated by the emission of low-energy electrons. Our findings show that the described experiments constitute a simple and useful in vitro model for radiobiological investigations in a cell model.

Sign in / Sign up

Export Citation Format

Share Document