Experimental examination of the room temperature hydrodynamics and electrochemical current-voltage behaviour of the Bi-terminated vibrating wire electrode

1981 ◽  
Vol 31 (1) ◽  
pp. 259-272 ◽  
Author(s):  
Edward D. Moorhead ◽  
Gajanana A. Bhat ◽  
Michael M. Stephens
Keyword(s):  
Room Temperature ◽  
Wire Electrode ◽  
Vibrating Wire ◽  
Experimental Examination ◽  
Current Voltage ◽  
Electrochemical Current

Laser Engineering of Barrier Structures Based on Solid Solution ZnCdHgTe.

2002 ◽  
Vol 719 ◽  
Author(s):  
Galina Khlyap
Keyword(s):  
Room Temperature ◽  
Film Surface ◽  
Charge Carriers ◽  
Barrier Structure ◽  
Free Charge ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Laser Engineering ◽  
Charged Defects ◽  
Epilayer Surface

AbstractRoom-temperature electric investigations carried out in CO2-laser irradiated ZnCdHgTe epifilms revealed current-voltage and capacitance-voltage dependencies typical for the metal-semiconductor barrier structure. The epilayer surface studies had demonstrated that the cell-like relief has replaced the initial tessellated structure observed on the as-grown samples. The detailed numerical analysis of the experimental measurements and morphological investigations of the film surface showed that the boundaries of the cells formed under the laser irradiation are appeared as the regions of accumulation of derived charged defects of different type of conductivity supplying free charge carriers under the applied electric field.

Study on Schottky Diode Characteristics Improving by X-Ray Irradiation

2013 ◽  
Vol 717 ◽  
pp. 113-116
Author(s):  
Sani Klinsanit ◽  
Itsara Srithanachai ◽  
Surada Ueamanapong ◽  
Sunya Khunkhao ◽  
Budsara Nararug ◽  
...  
Keyword(s):  
Leakage Current ◽  
Schottky Diode ◽  
Room Temperature ◽  
The Other ◽  
Low Power Consumption ◽  
Initial Value ◽  
X Ray ◽  
Forward Current ◽  
Current Voltage ◽  
Current Voltage Characteristics

The effect of soft X-ray irradiation to the Schottky diode properties was analyzed in this paper. The built-in voltage, leakage current, and work function of Schottky diode were investigated. The current-voltage characteristics of the Schottky diode are measured at room temperature. After irradiation at 70 keV for 55 seconds the forward current and leakage current are increase slightly. On the other hand, the built-in voltage is decrease from the initial value about 0.12 V. Consequently, this method can cause the Schottky diode has low power consumption. The results show that soft X-ray can improve the characteristics of Schottky diode.

Self-assembled rigid conjugated polymer nanojunction and its nonlinear current–voltage characteristics at room temperature

2004 ◽  
Vol 85 (1) ◽  
pp. 115-117 ◽  
Author(s):  
Wenping Hu ◽  
Hiroshi Nakashima ◽  
Kazuaki Furukawa ◽  
Yoshiaki Kashimura ◽  
Katsuhiro Ajito ◽  
...  
Keyword(s):  
Conjugated Polymer ◽  
Room Temperature ◽  
Current Voltage ◽  
Current Voltage Characteristics ◽  
Self Assembled

scholarly journals Production and Electrical Properties of a CuZnAlMn(SMA)/p-Si Diode

2021 ◽  
Author(s):  
EMINE ALDIRMAZ ◽  
M. Güler ◽  
E. Güler
Keyword(s):  
Room Temperature ◽  
Schottky Contact ◽  
Phase Identification ◽  
Frequency Interval ◽  
Electrical Measurements ◽  
X Ray ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
Type Semiconductor ◽  
Diode Current

Abstract In this study, the Cu-23.37%Zn-13.73%Al-2.92%Mn (at.%) alloy was used. Phase identification was performed with the Scanning electron microscope (SEM), and energy-dispersive X-ray (EDX). We observed in the austenite phase in Cu-23.37%Zn-13.73%Al-2.92%Mn (at.%) alloy. To produce a new Schottky diode, CuZnAlMn alloy was exploited as a Schottky contact on p-type semiconductor silicon substrate. To calculate the characteristics of the produced diode, current-voltage (I-V), capacitance-voltage (C-V) and conductance-voltage (G-V) analyzes were taken at room temperature (300 K), in the dark and under various lights. Using electrical measurements, the diode's ideality factor (n), barrier height (Φb), and other diode parameters were calculated. Besides, the conductance / capacitance-voltage (G/C-V) characteristics of the diode were studied and in a wide frequency interval at room temperature. Also, the capacitance and conductance values strongly ​​ rely on the frequency. From the present experimental results, the obtained diode can be used for optoelectronic devices.

scholarly journals Effect of epitaxial alignment on electron transport from quasi-two-dimensional iron silicide alpha-FeSi-=SUB=-2-=/SUB=- nanocrystals into p-Si(001)

2018 ◽  
Vol 52 (5) ◽  
pp. 523
Author(s):  
I.A. Tarasov ◽  
M.V. Rautskii ◽  
I.A. Yakovlev ◽  
M.N. Volochaev
Keyword(s):  
Electron Transport ◽  
Room Temperature ◽  
Molecular Beam ◽  
Schottky Barrier Height ◽  
Iron Silicide ◽  
Current Voltage Characteristic ◽  
Current Voltage ◽  
Basic Orientation ◽  
Different Temperatures ◽  
A Current

AbstractSelf-assembled growth of α-FeSi_2 nanocrystal ensembles on gold-activated and gold-free Si(001) surface by molecular beam epitaxy is reported. The microstructure and basic orientation relationship (OR) between the silicide nanocrystals and silicon substrate were analysed. The study reveals that utilisation of the gold as catalyst regulates the preferable OR of the nanocrystals with silicon and their habitus. It is shown that electron transport from α-FeSi2 phase into p-Si(001) can be tuned by the formation of (001)—or (111)—textured α-FeSi2 nanocrystals ensembles. A current-voltage characteristic of the structures with different preferable epitaxial alignment (α-FeSi_2(001)/Si(100) and α-FeSi_2(111)/Si(100)) shows good linearity at room temperature. However, it becomes non-linear at different temperatures for different ORs due to different Schottky barrier height governed by a particular epitaxial alignment of the α-FeSi_2/ p -Si interfaces.

HYBRID NANOMATERIALS FOR MULTI-SPECTRAL INFRARED PHOTODETECTION

2007 ◽  
Vol 17 (01) ◽  
pp. 165-172 ◽  
Author(s):  
ADRIENNE D. STIFF-ROBERTS
Keyword(s):  
Dark Current ◽  
Room Temperature ◽  
Spectral Response ◽  
Substrate Material ◽  
Hybrid Nanomaterials ◽  
Thermally Activated ◽  
Dopant Incorporation ◽  
Quantum Dot Infrared Photodetectors ◽  
Current Voltage ◽  
Fourier Transform Ir

Quantum dot infrared photodetectors (QDIPs) using quantum dots (QDs) grown by strained-layer epitaxy have demonstrated low dark current, multi-spectral response, high operating temperature, and infrared (IR) imaging. However, achieving near room-temperature, multi-spectral operation is a challenge due to randomness in QD properties. The ability to control dopant incorporation is important since charge carrier occupation influences dark current and IR spectral response. In this work, dopant incorporation is investigated in two classes of QDs; epitaxial InAs/GaAs QDs and CdSe colloidal QDs (CQDs) embedded in MEH-PPV conducting polymers. The long-term goal of this work is to combine these hybrid nanomaterials in a single device heterostructure to enable multi-spectral IR photodetection. Two important results towards this goal are discussed. First, by temperature-dependent dark current-voltage and polarization-dependent Fourier transform IR spectroscopy measurements in InAs/GaAs QDIPs featuring different doping schemes, we have provided experimental evidence for the important contribution of thermally-activated, defect-assisted, sequential resonant tunneling. Second, the enhanced quantum confinement and electron localization in the conduction band of CdSe / MEH-PPV nanocomposites enable intraband transitions in the mid-IR at room temperature. Further, by controlling the semiconductor substrate material, doping type, and doping level on which these nanocomposites are deposited, the intraband IR response can be tuned.

Morphology and I-V Characteristics of Electrochemically Deposited Zinc Oxide on Silicon

2021 ◽  
Vol 20 (3) ◽  
pp. 32-36
Author(s):  
Ahmad Bukhairi Md Rashid ◽  
Mastura Shafinaz Zainal Abidin ◽  
Shaharin Fadzli Abd Rahman ◽  
Amirjan Nawabjan
Keyword(s):  
Zinc Oxide ◽  
Electrochemical Deposition ◽  
Dark Current ◽  
Room Temperature ◽  
Volume Ratio ◽  
Deposition Process ◽  
X Ray ◽  
Current Voltage ◽  
Electrochemically Deposited ◽  
A Current

This paper reported on the electrochemical deposition of zinc oxide (ZnO) on p-silicon (p-Si) (100) substrate in the mixture of 0.1 M of zinc chloride (ZnCl2) and potassium chloride (KCl) electrolyte at a volume ratio of 1:1, 3:1 and 5:1 namely Sample A, B and C. The deposition process was done in room temperature with a current density of 10 mA/cm2 for 30 minutes. Prior to the experiment, all samples were treated by RCA cleaning steps. All samples were characterized using scanning electron microscopy (SEM) and energy dispersive X-ray (EDX). The results show that all samples have the same morphology of a flake-like structure with different Zn:O ratio that were 2.81, 2.35 and 2.49 for samples A, B and C. The current-voltage (I-V) characteristic graph was obtained by dark current measurement using Keithley SMU 2400 and the threshold voltage (Vth) values were determined at 2.21 V, 0.85 V and 1.22 V for sample A, B and C respectively which correspond with the Zn:O ratio where the highest value of Zn:O ratio can be found in sample A and the lowest in sample B. Based on these results, it shows that electrochemical deposition technique is capable of being used to deposit the flake-like structure ZnO on semiconductor material to form the p-n junction which behaves like a diode. The value of Vth seems to be depended on the ratio between Zn and O. Higher ratio of Zn and O will cause the higher value of intrinsic carrier concentration and built in potential which will increase the Vth value.

scholarly journals Poole-Frenkel Conduction in Cu/Nano-SnO2/Cu Arrangement

2011 ◽  
Vol 2011 ◽  
pp. 1-4 ◽  
Author(s):  
Hossein Mahmoudi Chenari ◽  
Hassan Sedghi ◽  
Mohammad Talebian ◽  
Mir Maqsoud Golzan ◽  
Ali Hassanzadeh
Keyword(s):  
Electrical Properties ◽  
Room Temperature ◽  
Tin Dioxide ◽  
Current Flow ◽  
Sandwich Structures ◽  
Conduction Band Edge ◽  
Flow Mechanism ◽  
Conduction Mechanisms ◽  
Current Voltage ◽  
Limited Conduction

It is well known that metal/Tin-dioxide/metal sandwich structures exhibit a field-assisted lowering of the potential barrier between donor-like center and the conduction band edge, known as the Poole-Frenkel effect. This behavior is indicated by a linear dependence of Iog  on , where is the current density, and is the applied voltage. In this study, the electrical properties of Cu/nano-SnO2/Cu sandwich structures were investigated through current-voltage measurements at room temperature. Also, an attempt to explore the governing current flow mechanism was tried. Our results indicate that noticeable feature appearing clearly in the current-voltage characterization is the Poole-Frenkel and space-charge-limited conduction mechanisms.

Sign in / Sign up

Export Citation Format

Share Document