Far infrared-assisted removal of extraction solvent for capillary electrophoretic determination of the bioactive constituents in Plumula Nelumbinis

2018 ◽  
Vol 40 (4) ◽  
pp. 582-586 ◽  
Author(s):  
Danjing Wan ◽  
Yu Han ◽  
Farui Li ◽  
Hua Mao ◽  
Gang Chen
Keyword(s):  
Far Infrared ◽  
Bioactive Constituents ◽  
Extraction Solvent ◽  
Capillary Electrophoretic

Far Infrared-assisted Sample Extraction and Solvent Removal for Capillary Electrophoretic Determination of the Bioactive Constituents in Citri Reticulatae Pericarpium

2020 ◽  
Vol 17 (1) ◽  
pp. 57-66
Author(s):  
Yan Zhang ◽  
Luyan Zhang ◽  
Gang Chen
Keyword(s):  
Sample Preparation ◽  
Low Cost ◽  
Far Infrared ◽  
Bioactive Constituents ◽  
Solvent Removal ◽  
Sample Extraction ◽  
Wide Range ◽  
Conventional Solvent Extraction ◽  
Capillary Electrophoretic

Background: Sample preparation is crucially important for the capillary electrophoretic measurement of the bioactive constituents in Citri Reticulatae Pericarpium because conventional solvent extraction is time-consuming and the solvent peaks seriously interfere with the measured capillary electropherograms. Objective: The objective of the present study is to establish far infrared-assisted sample preparation approaches for the analysis of Citri Reticulatae Pericarpium. Methods: Synephrine and hesperidin in Citri Reticulatae Pericarpium were determined by capillary electrophoresis in combination with far infrared-assisted sample extraction and solvent removal. Results: The effects of detection potentials, irradiation times and the voltages applied to the infrared generator were investigated to acquire the optimal assay conditions. Synephrine and hesperidin could be well separated within 6 min at a separation voltage of 9 kV in an alkaline borate solution. Satisfactory linearity was observed over the concentration range of 0.001 to 1 mM with the detection limits of 0.43 and 0.52 μM for synephrine and hesperidin, respectively. The results exhibited that far infrared irradiations could enhance the efficiencies of sample extraction and solvent removal during the sample preparation of Citri Reticulatae Pericarpium. The extraction time was significantly reduced to 6 min while the interference of the solvent peaks towards the electropherograms was eliminated. Conclusion: Far infrared-accelerated extraction and solvent removal were employed in the capillary electrophoretic determination of the bioactive constituents in Citri Reticulatae Pericarpium with satisfactory results. The ease, simplicity, efficiency and low cost of the novel sample preparation approaches indicate they may find a wide range of applications.

Microextraction and Chromatographic Analysis of Budesonide Epimers in Exhaled Breath Condensate

2020 ◽  
Vol 16 (8) ◽  
pp. 1032-1040
Author(s):  
Laleh Samini ◽  
Maryam Khoubnasabjafari ◽  
Mohamad M. Alimorad ◽  
Vahid Jouyban-Gharamaleki ◽  
Hak-Kim Chan ◽  
...  
Keyword(s):  
Biological Fluids ◽  
Exhaled Breath Condensate ◽  
Low Cost ◽  
Exhaled Breath ◽  
Chromatography Method ◽  
Extraction Solvent ◽  
Drug Concentrations ◽  
Dispersive Liquid Liquid Microextraction ◽  
Breath Condensate

Background: Analysis of drug concentrations in biological fluids is required in clinical sciences for various purposes. Among other biological samples, exhaled breath condensate (EBC) is a potential sample for follow up of drug concentrations. Methods: A dispersive liquid-liquid microextraction (DLLME) procedure followed by a validated liquid chromatography method was employed for the determination of budesonide (BDS) in EBC samples collected using a homemade setup. EBC is a non-invasive biological sample with possible applications for monitoring drug concentrations. The proposed analytical method is validated according to the FDA guidelines using EBC-spiked samples. Its applicability is tested on EBC samples collected from healthy volunteers receiving a single puff of BDS. Results: The best DLLME conditions involved the use of methanol (1 mL) as a disperser solvent, chloroform (200 μL) as an extraction solvent, and centrifugation rate of 3500 rpm for 5 minutes. The method was validated over a concentration range of 21-210 μg·L-1 in EBC. Inter- and intra-day precisions were less than 10% where the acceptable levels are less than 20%. The validated method was successfully applied for the determination of BDS in EBC samples. Conclusion: The findings of this study indicate that the developed method can be used for the extraction and quantification of BDS in EBC samples using a low cost method.

scholarly journals Optimization of a Method for Extraction and Determination of Residues of Selected Antimicrobials in Soil and Plant Samples Using HPLC-UV-MS/MS

2021 ◽  
Vol 18 (3) ◽  
pp. 1159
Author(s):  
Klaudia Kokoszka ◽  
Agnieszka Kobus ◽  
Sylwia Bajkacz
Keyword(s):  
Nalidixic Acid ◽  
High Performance ◽  
Solid Phase ◽  
Sewage Treatment ◽  
Animal Manure ◽  
Uv Detector ◽  
Citrate Buffer ◽  
High Biological Activity ◽  
Extraction Solvent

The residues of antimicrobials used in human and veterinary medicine are popular pollutants of anthropogenic origin. The main sources of introducing antimicrobials into the environment are sewage treatment plants and the agricultural industry. Antimicrobials in animal manure contaminate the surrounding soil as well as groundwater, and can be absorbed by plants. The presence of antimicrobials in food of plant origin may pose a threat to human health due to their high biological activity. As part of the research, a procedure was developed for the extraction and determination of ciprofloxacin, enrofloxacin, cefuroxime, nalidixic acid and metronidazole in environmental samples (soil and parsley root). An optimized solid-liquid extraction (SLE) method was used to separate antimicrobials from the solid samples and a mixture of citrate buffer (pH = 4): methanol (1:1; v/v) was used as the extraction solvent. Solid phase extraction (SPE) with OASIS® HLB cartridges was used to purify and pre-concentrate the sample. The recovery of the developed method was in the range of 55–108%. Analytes were determined by high-performance liquid chromatography coupled with an ultraviolet (UV) detector and a tandem mass spectrometer (HPLC-UV-MS/MS). The procedure was validated and applied to the determination of selected antimicrobials in soil and parsley root samples. Five types of soil and five types of parsley roots of different origins were analyzed. The presence of nalidixic acid in the parsley root samples was found in the concentration range of 0.14–0.72 ng g−1. It has been shown that antimicrobials are absorbed by the plant and can accumulate antimicrobials in its edible parts.

Capillary Electrophoretic Determination of Resveratrol in Wines†

1999 ◽  
Vol 47 (8) ◽  
pp. 3223-3227 ◽  
Author(s):  
Xuelin Gu ◽  
Le Creasy ◽  
April Kester ◽  
Michael Zeece
Keyword(s):  
Capillary Electrophoretic
Sign in / Sign up

Export Citation Format

Share Document