Pharmacokinetic Interactions between Primaquine and Pyronaridine-Artesunate in Healthy Adult Thai Subjects

ABSTRACTPyronaridine-artesunate is a newly introduced artemisinin-based combination treatment which may be deployed together with primaquine. A single-dose, randomized, three-sequence crossover study was conducted in healthy Thai volunteers to characterize potential pharmacokinetic interactions between these drugs. Seventeen healthy adults received a single oral dose of primaquine alone (30 mg base) and were then randomized to receive pyronaridine-artesunate alone (540−180 mg) or pyronaridine-artesunate plus primaquine in combination, with intervening washout periods between all treatments. The pharmacokinetic properties of primaquine, its metabolite carboxyprimaquine, artesunate, its metabolite dihydroartemisinin, and pyronaridine were assessed in 15 subjects using a noncompartmental approach followed by a bioequivalence evaluation. All drugs were well tolerated. The single oral dose of primaquine did not result in any clinically relevant pharmacokinetic alterations to pyronaridine, artesunate, or dihydroartemisinin exposures. There were significantly higher primaquine maximum plasma drug concentrations (geometric mean ratio, 30%; 90% confidence interval [CI], 17% to 46%) and total exposures (15%; 6.4% to 24%) during coadministration with pyronaridine-artesunate than when primaquine was given alone. Pyronaridine, like chloroquine and piperaquine, increases plasma primaquine concentrations. (This study has been registered at ClinicalTrials.gov under registration no. NCT01552330.)

Novel Population Pharmacokinetic Method Compared to the Standard Noncompartmental Approach to Assess Bioequivalence of Iron Gluconate Formulations

Purpose: Iron-containing products are atypical in terms of their pharmacokinetic properties because iron is only removed by plasma sampling and is non-linear. This study aims to present a novel way of assessing the relative bioavailability of two sodium ferric gluconate complex (SFGC) formulations and compare this approach to a standard previously published noncompartmental approach. Methods: Data were from open-label, randomized, single-dose studies (Study 1 was parallel whereas Study 2 was crossover). Subjects with low but normal iron levels were infused IV SFGC in sucrose by GeneraMedix Inc. and/or Ferrlecit ® Injection (Watson Laboratories Inc.). In Study 1 (n=240), 125 mg was infused over 10 minutes. In Study 2 (n=29), 62.5 mg was infused over 30 minutes. Samples were assayed for total iron (TI) and transferrin-bound iron (TBI) over 36 hours (Study 1) or 72 hours (Study 2) post-dose. Studies 1 and 2 used standard noncompartmental analysis. Study 2 also used population PK (PPK) analyses with ADAPT 5®. The final model predicted SFGC area-under-the-curve (AUCpred) and maximal concentration (Cmaxpred). Analyses of variance was conducted on ln-transformed PK parameters. Ratios of means and 90% confidence intervals (CIs) were estimated. Bioequivalence was demonstrated if values were within 80-125%. Results: For Study 1, ratios and 90% CIs for TI baseline-corrected Cmax and AUC0-36 were 100.4 (96.5 – 104.5) and 99.7 (94.2 – 105.5). For TBI, results for TI baseline-corrected Cmax and AUC0-36 were 86.8 (82.7 – 91.1) and 92.4 (85.6 – 99.7). For Study 2, a multi-compartmental model simultaneously described the PK of TI, TBI and SFGC. Ratios and 90% CIs for SFGC Cmaxpred and AUCpred were 89.9 (85.9 - 94.0) and 89.7 (85.7 - 93.9), while ratios and 90% CI obtained from the noncompartmental analysis of Study 2 did not meet BE criteria because of low power. Conclusions: Both the standard and PPK modeling approach suggested bioequivalence between the iron products. However, with the PPK method, less subjects were required to meet study objectives compared to the standard noncompartmental approach which required considerably more subjects (29 vs 240). This article is open to POST-PUBLICATION REVIEW. Registered readers (see “For Readers”) may comment by clicking on ABSTRACT on the issue’s contents page.