Superplastic-Like Elongation by Transition of Deformation Mechanism from Grain Boundary Sliding to Solute Drag Creep in Fine-Grained Al-Mg Solid Solution Alloy

It is widely accepted that the dominant deformation mechanism of fine-grained superplasticity is through grain boundary sliding (GBS) that occurs in fine-grained materials. However, it has been reported that in “Class I” solid solution alloys, superplastic-like behavior controlled by trans-granular deformation occurs by solute drag creep. In this study, we have investigated superplastic behavior in a fine-grained aluminum solid solution alloy with a thermally unstable microstructure. To obtain fine-grained microstructure, friction stir processing (FSP) was applied to a commercial 5083 aluminum (Al−Mg) alloy. An equiaxial fine-grained microstructure with a grain size of 7.4 μm was obtained after FSP; however, this microstructure was unstable at high temperatures. Generally, for fine-grained superplasticity or GBS to occur or continue, the fine-grained microstructure must be smaller than 10 μm during high-temperature deformation. However, a large elongation of over 200% was observed at high temperatures despite the occurrence of grain growth. From microstructural observations, it was determined that a fine-grained microstructure is maintained in the early stage of deformation, but at strain levels greater than 100%, trans-granular deformation occurs. The microstructural feature of this trans-granular deformation is similar to the deformation microstructure of solute drag creep observed in “Class I” solid solution alloys. This indicates that a change in the deformation mechanism from GBS to solute drag creep takes place during high-temperature deformation. Here, based on our observations on our model system, which is a thermally unstable aluminum solid solution alloy, we discuss the possibility of a superplastic elongation occurring by means of a transition of the deformation mechanism.

Characteristics of the GBS – SDC Transition during Bi-Axial Forming of AA5083

Thermomechanical processing to enable superplasticity in AA5083 materials includes cold working followed by heating prior to hot blow forming. Upon heating for forming at 450°C, a B-type ({110}) rolling texture is replaced by a near-random texture with a weak superimposed cube orientation parallel to the sheet normal. The presence of refined grains 7 – 8μm in size reflects the predominance of particle-stimulated nucleation of recrystallization prior to forming. The subsequent evolution of microstructure, texture and cavitation behaviour during biaxial deformation in the solute drag creep (SDC) and grain boundary sliding (GBS) regimes will be presented.

An Overview of Hot- and Warm-Forming of Al-Mg Alloys

Al-Mg alloys exhibit remarkable hot and warm ductilities, which have made the 5000-series alloys a critical part of commercial hot gas-pressure forming operations for the transportation industry. A review of the metallurgical and practical engineering reasons for this success is presented, and new understanding for behaviors in these materials, expected to impact future advances in hot- and warm-forming technology, are described. The excellent formabilities in this material class are fundamentally attributable to two deformation mechanisms, grain-boundary-sliding and solute-drag creep. However, a number of failure mechanisms ultimately limit final ductility and formability. These include cavitation, flow localization and microstructure evolution. The interplay of these mechanisms is discussed in terms of the potential to improve processing windows in forming operations.