corundum ceramic
Recently Published Documents


TOTAL DOCUMENTS

39
(FIVE YEARS 2)

H-INDEX

3
(FIVE YEARS 0)

2021 ◽  
Vol 78 (5-6) ◽  
pp. 226-230
Author(s):  
D. A. Antonov ◽  
M. A. Tarasenko ◽  
S. S. Pavlov ◽  
N. A. Makarov

2020 ◽  
Vol 40 (9) ◽  
pp. 793-796
Author(s):  
V. P. Tarasovskii ◽  
V. V. Rybal’chenko ◽  
V. A. Kuznetsov ◽  
A. Yu. Omarov ◽  
A. V. Smirnov ◽  
...  

2020 ◽  
Vol 60 (6) ◽  
pp. 566-573 ◽  
Author(s):  
Yu. E. Pivinsky ◽  
P. V. Dyakin ◽  
E. M. Grishpun ◽  
A. M. Gorokhovsky

Mechanik ◽  
2018 ◽  
Vol 91 (8-9) ◽  
pp. 706-708
Author(s):  
Jan Burek ◽  
Artur Szajna ◽  
Tomasz Rydzak

The article presents the results of experimental research for grinding of corundum ceramic with the use of an spherical diamond head. Article shows the influence of tilt angle and feed on roughness parameters. Authors also described influence of tilt angle and thickness of the grinding layer on effective cutting speed.


2018 ◽  
Vol 27 (3-4) ◽  
Author(s):  
Seif-Eddine Bendaoudi ◽  
Mokhtar Bounazef ◽  
Ali Djeffal

AbstractPorous corundum ceramic samples were sintered at various temperatures in the range of 1350–1550°C. The effect of the sintering temperature on the porosity rate and compressive strength of corundum samples were investigated. The porosity rates were of the order of 3.3–38% and the high-density sample was obtained at a relatively high temperature. However, an increase of compressive strength by more than 6 times was observed with the sintering temperature rise. The Young’s modulus increased remarkably from 40.49 to 302.15 GPa, which is related to the corresponding decrease of porosity rate.


2018 ◽  
Vol 20 (7) ◽  
pp. 415-424
Author(s):  
P.A. Borzov ◽  
◽  
S.E. Filippov ◽  
V.Yu. Topolov ◽  
О.Е. Brill ◽  
...  

Mechanik ◽  
2017 ◽  
Vol 90 (8-9) ◽  
pp. 763-765
Author(s):  
Jan Burek ◽  
Artur Szajna ◽  
Joanna Lisowicz ◽  
Tomasz Rydzak

The article presents the results of experimental research for free form grinding of corundum ceramic with the use of an spherical diamond head. Article shows the influence of cutting depth and feed on roughness parameters and surface accuracy.


Author(s):  
M. A. Kostytsyn ◽  
D. S. Muratov ◽  
D. V. Lysov ◽  
K. O. Chuprunov ◽  
A. G. Yudin ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document