Anaerobic Digestion of Cigarette Butts: Microbial Community Analysis and Energy Production Estimation

Anaerobic digestion using cigarette butts, one of most littered items, was studied not only as a waste treatment, but also as an energy production method. Methane production from cigarette butts was measured through the biochemical methane potential (BMP) test and it was evaluated whether it is possible to produce electrical energy. Intact cigarettes or individual components (filter, paper, and leaf) were supplied as the sole carbon source (substrate) for the BMP test. The tendency of methane production indicated biodegradation in the order of paper, filter, and leaves; however, the filter of cigarettes was the substrate produced the highest amount of methane per total solid. The microbial community was also analyzed in each anaerobic digestion reactor, and substrate-specific microorganisms were identified, such as Proteiniphilum strain (filter) and Methanobacterium formicicum (paper). In intact cigarettes, the related microbial community became dominant over time in the order of paper, filter, and leaf. The conversion of cigarette butts to methane, a renewable energy source, can be proposed as a sustainable route for energy demand, for example, in a smoking room.

Chemical pre-treatments on oil palm empty fruit bunches: Impacts on characteristics and methane potential

Production of biogas from lignocellulosic biomass by anaerobic digestion (AD) has attracted much interest. Oil palm empty fruit bunches (OPEFB), one of lignocellulosic biomass, is highly abundant in Indonesia and has potential as feedstock for bioenergy production such as biogas or methane. Yet, pre-treatments are needed to improve biogas production due to its complex crystalline structures. Chemical pre-treatments with acid or alkaline solution were reported to increase cellulose or highly reduce the lignin content of OPEFB. This study aimed to evaluate the effect of acid and alkaline pre-treatments on the characteristics of OPEFB and methane potential. The acid pre-treatment experimental design was used factor of H2SO4 concentration (1, 1.3, and 1.6 (%v/v)) and NaOH concentration (1.8, 2.8, and 3.8 (%w/v)). Methane potential evaluation was carried out using the biochemical methane potential (BMP) test with the Automatic Methane Potential Test System (AMPTS) II under mesophilic condition (37°C), operated for 28 days. The results showed that both dilute acid and alkaline pre-treatment positively impact altering the characteristics of OPEFB, hence the specific methane potential. Alkaline pre-treatment with NaOH 3.8 (%w/v) gave the highest average SMP value of 0.161 ± 0.005 m3 CH4/kgVSadded.

Characteristics of Biogas Production from Organic Wastes Mixed at Optimal Ratios in an Anaerobic Co-Digestion Reactor

This study determined the optimal mixing ratio of food waste and livestock manure for efficient co-digestion of sewage sludge by applying the biochemical methane potential (BMP) test, Design Expert software, and continuous reactor operation. The BMP test of sewage sludge revealed a maximum methane yield of 334 mL CH4/g volatile solids (VS) at an organic loading rate (OLR) of 4 kg VS/(m3·d). For food waste, the maximum methane yield was 573 mL CH4/g VS at an OLR of 6 kg VS/(m3·d). Livestock manure showed the lowest methane yield. The BMP tests with various mixing ratios confirmed that a higher mixing ratio of food waste resulted in a higher methane yield, which showed improved biodegradability and an improved VS removal rate. The optimal mixing ratio of 2:1:1 for sewage sludge, food waste, and livestock manure was determined using Design Expert 10. Using continuous co-digestion reactor operation under an optimal mixing ratio, greater organic matter removal and methane yield was possible. The process stability of co-digestion of optimally mixed substrate was improved compared with that of operations with each substrate alone. Therefore, co-digestion could properly maintain the balance of each stage of anaerobic digestion reactions by complementing the characteristics of each substrate under a higher OLR.

Bio-Methane Potential (BMP) of Cassava Pulp Waste and Effect of Alkaline Pre-Treatment

Cassava starch processing industry produces cassava pulp as a by-product or waste. In the well-known Duong Lieu village, this waste is released in surrounding environment without treatment causing serious environmental problems. The study aimed to (1) determine the Biomethane Potential (BMP) of the waste and to (2) find out if alkaline pre-treatment would improve it. Different cassava pulp samples were going through BMP test: untreated sample; pre-treated samples at different NaOH doses of 2, 6, 8 wt.% (dry weight-based) and pre-treated samples at different NaHCO3 doses of 2, 4, 6, 8 wt.% (dry weight based). BMP assays were conducted in 590mL bottles at 37oC for 40 days. As the result, BMP of the untreated waste was 281 NmLCH4/gVS and alkaline pretreatment increased BMP of the waste up to 479 mLCH4/gVS by treatment with NaOH 6 wt.% and 450 mLCH4/gVS by treatment with NaHCO3 6 wt.%. In addition, there was a significant reduction of lignin content of the substrate after alkaline pre-treatment. The results show that cassava pulp waste has moderate potential for biogas recovery. In addition, alkaline pre-treatment by either NaOH or NaHCO3 would significantly improve its BMP, possibly thanks to the reduction of lignin content.

Enhancement of Methane Production in Anaerobic Digestion of Food Waste using Thermal Pretreatment

Anaerobic digestion (AD) is an energy production process and food waste is a potential feedstock. The main biochemical reactions are Hydrolysis, Acidogenesis, Acetogenesis, and Methanogenesis. The hydrolysis step acts as the rate-limiting reaction and the pretreatment of the feedstocks can be used to support this step. In this research, thermal pretreatment was used as a potential method for food waste pretreatment. Six different pretreatment conditions were used: two different temperatures (80oC and 100oC) and three different pretreatment times (30, 60, and 90 min). The Bio-Methane Potential (BMP) test was conducted using 120 mL serum bottles for 20 days to determine the most suitable pretreatment conditions. An experiment was also conducted at the selected optimal conditions (80oC for 90 min) using a small-scale bioreactor against the control with a NaHCO3 buffer solution. The highest Soluble Chemical Oxygen Demand (SCOD) was observed at 100oC for 90 min. The optimal pretreatment was selected as 80oC for 90 min, which produced 14.75 mL/g VS of methane while the control produced 8.64 mL/g VS in BMP test. After a few days, the methane production started to slow down due to a decrease in pH. When a buffer was added, a specific methane yield of 120.13 mL/g VS was observed in the small-scale bioreactor. This was an 11.24% increase compared to the buffered control without thermal pretreatment. In conclusion, thermal pretreatment has a potential to enhance the AD but it is economical to use with less biodegradable waste than food waste.

Optimizing anaerobic co-digestion of goat manure and cotton gin trash using biochemical methane potential (BMP) test and mathematical modeling

Anaerobic co-digestion is widely adopted to enhance process efficacy by balancing the C/N ratio of the feedstock while converting organic wastes to biomethane. Goat manure (GM) and cotton gin trash (CGT) were anaerobically co-digested in triplicate batch bioreactors. The process was optimized and evaluated utilizing mathematical equations. The liquid fraction of the digestate was analyzed for nitrate and phosphate. The co-digestions with 10 and 20% CGT having the C/N ratios of 17.7 and 19.8 yielded the highest and statistically similar 261.4 ± 4.8 and 262.6 ± 4.2 mL/gvs biomethane, respectively. The biodegradability (BD) of GM and CGT was 94.5 ± 2.7 and 37.6 ± 0.8%, respectively. The BD decreased proportionally with an increase in CGT percentage. The co-digestion having 10% CGT yielded 80–90% of biomethane in 26–39 d. The modified Gompertz model-predicted and experimental biomethane values were similar. The highest synergistic effect index of 15.6 ± 4.7% was observed in GM/CGT; 30:70 co-digestion. The concentration of nitrate and phosphate was lower in the liquid fraction of digestate than the feedstocks, indicating that these nutrients stay in the solid fraction. The results provide important insights in agro-waste management, further studies determining the effects of effluent application on plants need to be conducted.

The Performance Evaluation on Co-Digestion of Domestic Sewage Sludge and Food Waste for Methane Yield and Kinetics Analysis

Sewage sludge and food waste; are organic wastes suitable for the anaerobic digestion. However, the digestion of sewage sludge and food waste as solely substrate is having a drawback in term of methane yield. Therefore, many researchers combined these two wastes as a co-substrate and used in co-digestion. This study focused to evaluate the anaerobic co-digestion of domestic sewage sludge (in form of primary and secondary sewage sludge) with food waste under mesophilic temperature in a batch assay. Two series of batch biochemical methane potential (BMP) test were conducted using the Automatic Methane Potential Test System (AMPTS II). Each set are labelled with BMP 1(PSS:FW) and BMP 2 (SSS:FW). The BMP tests were monitored automatically until the methane production is insignificant. Using the data observed in the laboratory, the kinetic paremeters were calculated. Also, the First-order and Modified Gompertz modeling were included to predict the anaerobic digestion performance. Finding showed that BMP 1(PSS:FW) have better performance with respect to the higher ultimate methane yield and methane production rate as compared to BMP 2 (SSS:FW). Besides, the kinetic parameters from laboratory work and modeling were slightly different. In which the kinetic paremetes from modelling is lesser. However, both modelling are well fitted to the experimental data with high correlation coefficient, R2 ranged from 0.993 to 0.997.

Biochemical Methane Potential of Cork Boiling Wastewater at Different Inoculum to Substrate Ratios

The present study evaluates the digestion of cork boiling wastewater (CBW) through a biochemical methane potential (BMP) test. BMP assays were carried out with a working volume of 600 mL at a constant mesophilic temperature (35 °C). The experiment bottles contained CBW and inoculum (digested sludge from a wastewater treatment plant (WWTP)), with a ratio of inoculum/substrate (Ino/CBW) of 1:1 and 2:1 on the basis of volatile solids (VSs); the codigestion with food waste (FW) had a ratio of 2/0.7:0.3 (Ino/CBW:FW) and the codigestion with cow manure (CM) had a ratio of 2/0.5:0.5 (Ino/CBW:CM). Biogas and methane production was proportional to the inoculum substrate ratio (ISR) used. BMP tests have proved to be valuable for inferring the adequacy of anaerobic digestion to treat wastewater from the cork industry. The results indicate that the biomethane potential of CBWs for Ino/CBW ratios 1:1 and 2:1 is very low compared to other organic substrates. For the codigestion tests, the test with the Ino/CBW:CM ratio of 2/0.7:0.3 showed better biomethane yields, being in the expected values. This demonstrated that it is possible to perform the anaerobic digestion (AD) of CBW using a cosubstrate to increase biogas production and biomethane and to improve the quality of the final digestate.

Biomethane Potential Test: Influence of Inoculum and the Digestion System

High precision of measurement of methane potential is important for the economic operation of biogas plants in the future. The biochemical methane potential (BMP) test based on the VDI 4630 protocol is the state-of-the-art method to determine the methane potential in Germany. The coefficient of variation (CV) of methane yield was >10% in several previous inter-laboratory tests. The aim of this work was to investigate the effects of inoculum and the digestion system on the measurement variability. Methane yield and methane percentage of five substrates were investigated in a Hohenheim biogas yield test (D-HBT) by using five inocula, which were used several times in inter- laboratory tests. The same substrates and inocula were also tested in other digestion systems. To control the quality of the inocula, the effect of adding trace elements (TE) and the microbial community was investigated. Adding TE had no influence for the selected, well- supplied inocula and the community composition depended on the source of the inocula. The CV of the specific methane yield was <4.8% by using different inocula in one D-HBT (D-HBT1) and <12.8% by using different digestion systems compared to D-HBT1. Incubation time between 7 and 14 days resulted in a deviation in CV of <4.8%.