INVESTIGATION OF POLYMER COMPOSITE MATERIAL SAMPLES BY X-RAY COMPUTED TOMOGRAPHY AND PROCESSING OF TOMOGRAMS WITH THE IMAGE OF THE VOLUME FRACTION OF POROSITY

The question of the quality of samples made of polymer composite materials and its verification by x-ray computed tomography is considered. The capabilities of North Star Imaging X5000 tomograph were studied and the samples from PCM were examined for detection and evaluation of the porosity volume fraction. The factors influencing the accuracy of the estimation of the porosity volume fraction are investigated. Namely the size voxel, a filter material, quantity of projections. On the other hand, the size вокселя defines resolution of the digital image, the relation depends on a material of the applied filter a signal/noise, productivity of control worsens with growth of quantity of projections. The choice of optimum values of the listed parametres is necessary for satisfactory quality received tomographic images.

Numerical modeling of the porosity influence on strength of structural materials

The effect of micro-scale structural low-level porosity on strength of structural materials was studied using the three-dimensional Unit Cell Numerical Model - UCNM. A comparison between proposed UCNM and available experimental data in literature was done by comparing obtained values for stress concentration factor - SCF for different sizes and shapes of pore. Results for normalized strength obtained by proposed UCNM model are in agreement with available experimental data published in literature. It was confirmed that material porosity in form of closed pores, regarding pores? size (volume fraction) and shape, has note cable influence on strength of structural material. Less porosity in the material microstructure generally leads to higher values of material strength. For fixed porosity volume fraction, shape of pores has an impact on strength of structural material.

Hygrothermal wave characteristic of nanobeam-type inhomogeneous materials with porosity under magnetic field

Flexural and longitudinal wave behaviors of nanobeams made of nanoporous-graded materials while surrounded by Winkler-Pasternak foundation, subjected to the longitudinal magnetic field and exposed to the hygrothermal environment are studied analytically. To this end, the governing equation derived by Euler–Bernoulli beam theory in conjunction with the nonlocal strain gradient theory is defined by employing Hamilton’s principle. By adopting an analytic model, the flexural and longitudinal dispersion relations between phase velocity and wave number are derived. The reliability of the present method is confirmed by comparing the obtained results with those stored in the literature. Finally, the effects of the power-law index, porosity volume fraction, nonlocal and material characteristic parameters, uniform temperature and moisture rise, elastic foundation parameters, magnetic field intensity, and wave number are also investigated in detail. It is found that the small-scale parameters are more influential in higher wave numbers where the wavelength is close to the length scale of nanostructures. However, foundation parameters, porosity volume fraction, and longitudinal magnetic field are more influential in lower wave numbers.

Effects of Shrinkage Porosity on Mechanical Properties of a Sand Cast Mg-Y-Re (WE54) Alloy

The distribution of shrinkage porosities in sand cast Mg-Y-RE (WE54) alloy castings was characterized through density measurement and calculated by Archimedess principle. The effect of porosity on mechanical properties of sand cast WE54 alloy was investigated through tensile tests and microstructure observation. It was found that the shrinkage porosities distributed mainly in the middle of the plate where the liquid feeding was quite inconvenient. And the porosities were formed along grain boundaries when secondary phases formed at the end of solidification. Hardness tests showed that the vikers hardness declined linearly with increasing porosity volume fraction. While the tensile strength and nominal yield strength declined exponentially as the porosity volume fraction increased. Microstructure observation showed that the fracture cracks propagated along the grain boundaries where porosities and secondary phases gathering together in as-cast WE54 alloy. The tiny porosities distributed in the secondary phases were observed, which could reduce the tensile strength of cast specimens significantly. The heat treatment strengthening effects were significantly weakened by porosities, and even no heat treatment strengthening effect was detected when the porosity volume fraction was higher than 1%. The microstructure observation also proved that no heat treatment strengthening effect existed in samples containing porosities.