Non-planar coil winding angle optimization for compatibility with non-insulated high-temperature superconducting magnets

The rapidly emerging technology of high-temperature superconductors (HTS) opens new opportunities for the development of non-planar non-insulated HTS magnets. This type of HTS magnet offers attractive features via its simplicity and robustness, and is well suited for modest size steady-state applications such as a mid-scale stellarator. In non-planar coil applications the HTS tape may be subject to severe hard-way bending strain ( $\epsilon _{\textrm {bend}}$ ), torsional strains ( $\epsilon _{\textrm {tor}}$ ) and magnetic field components transverse to the HTS tape plane ( $B_{\perp }$ ), all of which can limit the magnet operating space. A novel method of winding angle optimization is here presented to overcome these limitations for fixed input non-planar coil filamentary geometry. Essentially, this method: (i) calculates the peak $\epsilon _{\textrm {bend}}$ and $B_{\perp }$ for arbitrary winding angle along an input coil filamentary trajectory, (ii) defines a cost function including both and then (iii) uses tensioned splines to define a winding angle that reduces $\epsilon _{\textrm {tor}}$ and optimizes the $\epsilon _{\textrm {bend}}$ and $B_{\perp }$ cost function. As strain limits are present even without $B_{\perp }$ , this optimization is able to provide an assessment of the minimum buildable size of an arbitrary non-planar non-insulating HTS coil. This optimization finds that for standard 4 mm wide HTS tapes the minimum size coils of the existing HSX, NCSX and W7-X stellarator geometries are around 0.3–0.5 m in mean coil radius. Identifying the minimum size provides a path to specify a mid-scale stellarator capable of achieving high-field or high-temperature operation with minimal HTS tape length. For coils larger than this size, strain optimization allows use of wider (higher current capacity) HTS tapes or alternatively permitting a finite (yet tolerable) strain allows reduction of $B_{\perp }$ . Reduced $B_{\perp }$ enables a reduction of the HTS tape length required to achieve a given design magnetic field or equivalently an increase in the achievable magnetic field for fixed HTS tape length. The distinct considerations for optimizing a stellarator coilset to further ease compatibility with non-insulated HTS magnets are also discussed, highlighting relaxed curvature limits and the introduction of limits to the allowable torsion.

Multiple-Input Single-Output Wireless Power Transmission System for Coal Mine Application

The magnetic multiple input algorithms of Wireless Power Transmission (WPT) system as well as many multiple overlapping coils structures in the transmitter side are proposed for the coal mine Internet of the Things (IOT) nodes. Different phase shifts cases for the input signal are considered to study their effect on the efficiency. Simulation results showed that the axial component of magnetic induction resulted from the multiple overlapping coils structure has preferable homogeneous distribution over the traditional single input coil. The proposed system achieved an efficiency value of 60 % for a receiver placed 40 cm away from a 4 coils transmitter comparing to an efficiency value of 50% for the same distance using a single coil transmitter. Simulation results shows that the proposed model is well adapted for the movable charging mode for the IOT nodes in coal mine.