Correspondence between XPs and Phonological Phrases

Bresnan (1971, 1972) establishes an interaction between stress assignment and syntactic movement. We are interested in a restriction on this interaction. We argue that this restriction shows that the constraint STRESS-XP needs to be part of the syntax-prosody mapping and that it needs to be a restriction on a correspondence relation between syntactic XPs and phonological phrases. (A second constraint on the correspondence relation is either WRAP-XP or MATCH-XP.) In the course of our argument, we analyze Bresnan’s interaction between stress assignment and movement within an account in which Internal Merge induces reconstruction effects at both LF and PF.

An anisotropic, viscoplastic power law for face-centred cubic crystals: comparative evaluations in the Goss and Brass orientations of channel die compression

An anisotropic, viscoplastic power law is introduced and applied to analysis of the Goss and Brass orientations, and compared with predictions from rate-independent theory and experiment. The structure of the new power law is so chosen that it has the capability of approaching rate-independent results for lattice rotation and crystal shearing, after finite rotation about the load axis, in the range of unstable lattice orientations in (110) channel die compression. (Rate-independent predictions of shear and lattice rotation are in good to very good agreement with experiments on aluminium and copper in that range, whereas classic isotropic power-law results are not.) It is established that, for sufficiently large power-law exponent n , the new anisotropic, elasto-viscoplastic theory predicts: (i) lattice stability in each of the Goss and Brass orientations, consistent with both experiment and rate-independent theory; (ii) zero crystal shear in the Goss orientation, also consistent with both; (iii) finite shear in the Brass orientation, in very good agreement with experiment and rate-independent theory; and (iv) a lateral-constraint stress that remains essentially elastic in both orientations, as predicted by rate-independent theory and close to experimental measurements for aluminium and copper in the Brass orientation.

The FEM Analysis of Size Effect on Prism Concrete Specimens with Different Lengths under Loads of Axial Compression

Four prism concrete specimens with same height, same width, but different lengths is simulated in using ABAQUS FEM analysis software. The simulation work is conducted under monotonic axial compression loading, and its purpose is to research the size effect of prism concrete specimens, primarily to study the effect of specimen length on the axial compressive strength. The stress-strain relation of the specimen is analyzed. The results indicate that, for different lengths of specimens, their axial compressive strengths are quite different and the size effect on them is much obvious. The compressive strength improves gradually with the increasing of length, and size effect on transverse and vertical constraint stress of core concrete area is much distinct as well. Meanwhile, it can be obtained that the standard design method of the structures and components is conservative and of adequate security.

Further investigation of crystal hardening inequalities in (110) channel die compression

A set of geometrically based FCC crystal slip-systems hardening inequalities is analytically investigated in (110) channel die compression for all lateral constraint directions between and , following previous analyses of the other two distinct orientation ranges in (110) compression. With all critical slip systems active, it is proved that these inequalities uniquely predict initial lattice stability and finite crystal shearing only in the horizontal channel plane, consistent with experiments for this range of orientations. (The earlier analyses had predicted load-axis stability in both orientation ranges, and lattice stability in one, also commonly found experimentally.) Moreover, it is established that the lateral constraint stress predicted by the hardening inequalities will be less than that given by classic Taylor hardening as this stress evolves with deformation. It is further shown, taking into account experimental stress–strain curves and latent hardening experiments for aluminium and copper, that lattice stability generally can be expected to very large deformations, except perhaps for lateral constraint orientations near the end of the range, which result is consistent with experiment. In appendix A, the possibilities of solutions with a critical slip system inactive are investigated, and predictions of a power law rate-dependent plasticity model are analysed for comparison with the results based on the hardening inequalities.

Emphatic stress shift in German

This paper presents an analysis of a sample of intentional deviations from the typical stress pattern of German words. These deviations are described as stress shifts in which the main stress is in a different position to the norm. This process is optional, mainly found in media speech and used for emphatic purposes. All stress shifts involve an interchange of primary and secondary stress, thereby demonstrating their sensitivity to a prosodic-similarity constraint. Stress retractions by far outnumber stress advancements, which can be jointly explained by a probabilistic association of the main stress and the word-initial position in language structure and an anticipatory bias in the language production system. Stress shifts show a strong overrepresentation of adjectives because this word class codes evaluative aspects most naturally and it is evaluations that speakers prefer to emphasize. From a social-psychological perspective, stress shifts are claimed to be a means by which speakers may boast their knowledge and, from a rhetorical perspective, a strategy of making the event being talked about more spectacular. Stress shifts are minority patterns in the sense that the constraints on them are so strong that only relatively few lexical items are eligible. This raises the issue of what speakers do with those items which they wish to emphasize but which do not lend themselves readily to stress shifting. Whether they turn to alternative means of expression or whether they leave their intentions unexpressed remains to be determined.